Electrolux EDBMFSCWO UltimateHome 300 Top Loading Water Dispenser User Manual

Electrolux EDBMFSCWO UltimateHome 300 Top Loading Water Dispenser

Thank you for choosing Electrolux.
Our water dispensers are developed with high technical and quality standards, with features to offer you even more comfort. Read all instructions before using this appliance. This book contains valuable information about operation, care and service. Keep it in a safe place. You expect all this from Frigidaire.…and we deliver.

Environmental advice
The packaging material used is recyclable; we recommend that you separate plastic, paper and cardboard and give them to recycling companies.

According to WEEE (Waste of Electrical and Electronic Equipment) guidelines, waste from electrical and electronic devices should be collected separately. If you need to dispose of this appliance in the future, do NOT throw it away with the rest of your domestic garbage. Instead, please take the appliance to the nearest WEEE collection point, where available.

Attention
Inside you will find many helpful hints on how to use and maintain your water dispenser properly. Just a little preventive care on your part can save you a great deal of time and money over the life of your air conditioner. You’ll find many answers to common problems in the chart of troubleshooting tips. If you review our chart of Troubleshooting Tips first, you may not need to call for service at all.

Attention

• The appliance that you have bought may be slightly different from the one illustrated in this manual. Please refer to the information related to the model you have.
• The appliance you have may carry a different plug than the one illustrated in this manual. The plug that comes with the product follows the electrical specifications of the country where it is sold.
• Contact the authorised service technician for repair or maintenance of this unit.
• If the power cord is to be replaced, replacement work shall be performed by authorised personnel only.
• This product was developed for regions with an altitude of approximately 2000 meters. For a higher region, the water boiling point might be too low and cause product damage.
• DANGER: Flammable Refrigerant Used.
• To be repaired only by trained service personnel.
• Do not puncture refrigerant tubing.
• CAUTION: Risk of Fire or Explosion.

R600a

• Dispose of properly by National or local regulations.
• WARNING: During transportation, installation, cleaning & use of the appliance, care should be taken to avoid damage to the refrigeration circuit which could result in a refrigerant leak.
• A qualified technician carrying out the installation is obliged to observe applicable national standards and regulations concerning connection to the water distribution system and the electric network.
• The manufacturer is not responsible for any unprofessional or incorrect installation.
• Servicing of this appliance should only be carried out by trained and qualified personnel.

Safety

To reduce the risk of injury and property damage, the user must read this entire guide delore assembly, Hsialig and Overture distance Failure to execute the instructions in this manual can cause personal injury or This product dispenses water at very high temperatures. Failure to use property When operating this dispenser, always exercise basic safety precautions, including the following:

For children
This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge onlv it they have been given supervision or instruction concerning safely using the appliance and understanding the hazards involved.

• Do not let children play with the appliance.
• Keep all packaging items away from children.
• If the appliance has a child safety device, we recommend you activate it.
• Cleaning and user maintenance shall not be done by children without supervision.
• Children of less than 8 years should be kept away unless continuously  supervised

General safety

• It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move to another house and leave the appliance, always ensure that the book is supplied with the appliance so that the new owner can get to know the functioning of the appliance and the relevant warnings.
• The correct functioning of your appliance does not only depend on the product quality, but on correct installation by a qualified professional.
• Never remove or damage stickers, warning labels or nameplates attached to the appliance.
• A qualified technician carrying out the installation is obliged to observe applicable national standards and regulations concerning connection to the water distribution system and the electric network. The manuracturer is not responsible for any unprofessional or incorrect installation.
• Check that the specifications written on the appliance’s identification plate are the same as those of the electrical power supply.

This appliance is manufactured and tested by valid regulations.
WARNING: Keep ventilation openings, in the appliance enclosure or the built-in structure, clear of obstruction.
WARNING: Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
WARNING: Do not damage the refrigerant circuit.

Installation

• Obey the installation instructions supplied with the appliance.
• Remove the packaging Nemo
• Do not install or use a damaged appliance.
• Before the first time starting up, check the appliance for any damage incurred during transport.
• Never remove or damage stickers, warning labels or nameplates attached to the appliance.

Electrical connection

• Only plug the water dispenser directly in the current if it is correctly grounded and with a certain voltage.
• Choose a place that is near a grounded
• Make sure the appliance is installed correctly.
• Loose and Incorrect electnicky mains cable on the plug (if applicable) can make the terminal too hot.
• Make sure that the electrical information on the rating plate agrees with the power supply.
• If not, contact our Authorised Service Centre or an electrician.
• The appliance has electrical switchs on the rear side which are set to turn ON or OFF the water heating and cooling system.
• Do not use multi-plug adapters and extension cables.
• Make sure not to cause damage to the mains plug (if applicable) or to the mains cable.
• Contact our Authorised Service Centre or an electrician to change a damaged mains cable. Make sure to use a new water bottle.
• Make sure the water bottle is not faulty – no leakage or holes.
• Make sure to install the bottle as in the Catalogue.
• Make sure to use the proper capacity (<20) litre for the water bottle.

Product Description

Parts names

1. Hole punch for water bottle
2. Child safety switch
3. Hot water button
4. Ambient water button
5. Cold water button
6. Spout
7. Water collector grid
8. Storage space
9. Cooling switch
10. Heating switch
11. Power cord
12. Condenser
13. Drain hole of cold water
14. Drain hole of hot water

Installation

Placement
Use the appliance indoors, there is no likelihood of rain or bad weather, as there is damage risk to the product’s electrical system. The product must be installed in an easily accessible location in case of repairs. Put the appliance on a flat surface and keep a minimum distance of 25 cm from the wall. Make sure that the ventilation openings of the product are not being obstructed.

Important
Do not install the water dispenser in a location where there is a direct impact of sunlight or near heat sources, such as a stove, oven, etc. This appliance is intended to be used in household and similar applications such as

• staff kitchen areas in shops, offices and other working environments;
• farmhouses and by clients in hotels, motels and other residential-type environments;
• bed and breakfast type environments;
• catering and similar non-retail applications.

To avoid a hazard due to the instability of the appliance, it must be fixed by the instructions:

1. Use a 13 mm screw to fix the fixing bracket on the middle of the bottom cover.
2. Drill out a screw hole(6 mm) on the floor.
3. Insert a screw anchor (wall plug) into the drilled hole.
4. Move the water dispenser, Align the fixing bracket hole with a screw hole of the floor
5. Put the 25mm screw into the screw hole of fixing the bracket.
6. Tighten the screw.

Warning
Do not plug in the device unless a water bottle is already installed and the system is tu or water

Installing the water bottle
Before putting the water bottle:

1. Clean the inside of the water cooler, where the water bottle is placed, with normal water and mild detergent and sterilize as indicated in the Care and Cleaning section.
2. Clean and sterilize also the water bottle, especially the part that will be inside the water cooler.
3. Leave the protective plastic cap on the bottle, where The product has a hole punch.

If the user prefers not to use the hole punch, you can pull it off. follow the next instructions:

1. Remove the top cover with the hole punch.
2. Turn clockwise the hole punch to fit it in tears.
3. Remove the hole punch.
4. Replace the lid on the water dispenser.
5. Place the water bottle at the water cooler and make sure that it is well docked.

This product was developed to be used with bottles of 10 or 20 litres. Depending on the maker and model of the water bottle, there may be some variation in size. Check, during installation of the bottle, that it is well supported and stable, and that there is no risk of falling.

Attention
Never turn the appliance upside down or tilt it more than 45% A short power supply cord is provided to reduce the risks resulting from becoming entangled in or tripping over a longer cord. Connect the plug firmly, if the product is connected to an adaptor plug or extension cord, be sure it is not in an area where it will be exposed to water.  After placing the water dispenser, check if it is not over the power cord.

Important
We do not recommend the use of an extension cord or adapter plug. Do not fasten, twist or tie the power cord. Do not try to fix it. If it is damaged, request the visit of a professional. technician. If the power cord is damaged, it should be replaced by the service centre technician.

How to use
Activate heating and cooling This unit will not dispense hot or cold water until the switchers are activated. To activate, push the top side of the power switches in to start heating and cooling water:

• If you do not want to heat water, push the bottom side of the red switch in.
• If you do not want to cool the water,  push the bottom side of the green switch

Dispensing water
This unit has been tested and sanitized before packing and shipping. During transit dust and odors can accumulate in the tank and lines. Dispense and dispose of at least one quart of water before drinking any water.

Hot water
To get the hot water: slide the child safety switch to the right, and press the water button simultaneously.

Normal water
To get the room temperature water: put the cup on the water collector grid and press the natural water button.

Cold water
To obtain chilled water put the cup on the water collector grid and press the cold water button.

Storage without fridge
In non-remderated models tere is a hermetic storage cabinet. Do not store any goods at this non-refrigerated storage.

Attention

• When the machine is under the ice point and blocked by ice, the cooling switch must be closed for 4 hours before turning it on again to continue its operation.
• This machine should not be turned on until 3 minutes later after turning off tne power switch.
• Do not operate or stop the appliance plugged in by the power cord or by pulling on the power cord. Unplug the power cord by holding it by the plug.
• In case cox or not water is not needed for a long time, turn on the respective power switch.
• Food and fruits should not be placed on non-refrigerated models to prevent putrefaction.

Care and cleaning
This unit has been tested and sanitized before packing and shipping. During transit dust and odors can accumulate in the tank and lines. Dispense and dispose of at least one quart of water before drinking any water. Wipe with a soft, clean piece of cloth in part outside of the water dispenser regularly. The water inside the bottle must not contain chlorine additives. So the inside of the water dispenser must be sterilized and clean. Do not touch the water outlet to avoid contamination. The water reservoir must be cleaned and sterilized every 3 months. Water will fall from the water collector if it is filled with water, please empty the water collector periodically.

Never clean your water cooler with namable nuts such as a canal. kerosene, gasoline, paint thinner, solvents, chemicals or abrasives such as detergents, acids, vinegar or products that might leave the smell. Wipe the outside of the water dispenser with water and neutral detergent. Do not use chemical cleaners or volatile solvents, because the product can lose brightness and colour.

Procedure for cleaning & sterilization of the appliance

1. Disconnect the licence from the power source.
2. Remove the water bottle and empty the water reservoir by pressing the buttons until there is no water coming out.
3. Open the drainage cao, existing at the back of the dispenser, and ensure that all the water flows out of the appliance.
4. Prepare a chlorinated solution (2 litres of clean water and 0.5 teaspoon of bleach.
5. Place the chlorinated solution in an empty bottle of water and to your water. dispenser.
6. Wait 10 minutes for the chlorinated solution to take effect and remove all the water through the drain.
7. Fill 11 of the bottle with clean water. Replace the bottle and remove all the water by triggers and drainage cap. This will rinse the tanks and the triggers of your product.

Warning
Always disconnect the water dispenser from the power source before cleaning it or doing any maintenance

Troubleshooting

Certain problems are due to a lack of simple maintenance or oversights, which can be solved easily without calling the service technicians, before contacting the service centre please carry out the check listed below.

Technical information

Customer Care
Thailand
Call Center Tel : (+66 2) 725 9000
Bangkapi, Huay Kwang, Bangkok 10310
Office Tel : (+66 2) 7259100
Office Fax : (+66 2) 7259299
Email : customercarethai@electrolux.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>