V-TAC 80133970 LED Strip Lights Instruction Manual
- June 2, 2024
- V TAC
Table of Contents
V-TAC 80133970 LED Strip Lights
SAFETY INSTRUCTION AND WARNINGS!
- Please make sure to turn off the power before starting the installation.
- Please cut the LED Strip Light according to the cutting as shown in the cutting instructions. Cutting outside the marking will damage the product. Please cut only on the dotted/scissor marking on the LED Strip Light.
- LED Strip Light cannot be folded or twisted during the installation. DO NOT turn on power until LED Strip Light is connected properly and well-installed.
- DO NOT touch/cut the LED Strip Light when power is on.
- DO NOT power the LED Strip Light in roll/package.
- DO NOT install in water or flammable environment, and make sure well ventilated.
- DO NOT wrap or cover the LED Strip Light with any objects.
- Once the IP65 LED Strip Light is cut, it loses its IP rating. To ensure and regain the IP rating kindly use the silicone glue.
- Please use only approved accessories and engage a professional electrician for installation work.
- Do not turn on the power supply until the lighting strip has been properly installed.
- Please do not use the product if any damage is found on the strip light.
- Not to be used for a long period is an environment with temperature exceeding 40°C.
- Do not wipe the strip with organic solvent to avoid damage to the insulation layer.
- Install only by certified Electrician.
INSTALLATION
- Use only power supply DC: 12/24V
- In case the section is longer than 10M , we recommend to power strips from both ends
- When selecting the appropriate power supply, please take into account, the electric power consumed by LED strips (kindly check the technical data sheet)
During Installation
- Red wire should be connected to the positive(+) side of the power supply unit.
- Black wire should be connected to the negative(-) side of the power supply unit.
Connecting LED Strip with power supply
Connecting RGB LED Strip with power supply and LED
Controller
Remarks
- IP20 can be used only indoors
CUTTING INSTRUCTIONS
CUTTING INSTRUCTIONS
NOTE: Cutting outside the marking will damage the product. Please cut
only on the dotted/scissor marking on the LED Strip light.
IMPORTANT: When cutting IP65 Striplight, it will lose its IP protection.
Please ensure to use Silicone Glue on the end of the strip light to ensure the
IP Protection is retained.
PARALLEL CONNECTION
POWERING STRIPLIGHT FROM BOTH THE ENDS
[SERIES CONNECTION]
NOTE: In case the section is longer than 10 M we recommend to power
strips from both ends.
SPECIFICATION
REMARKS
- IP20 can be used only indoors.
- IP65 can be used only indoors as well as outdoors (Not for signage use).
In case of any query/issue with the product, please reach out to us at:
support@v-tac.eu
For More products range, inquiry please contact our distributor or nearest
dealers.
V-TAC EUROPE LTD. Bulgaria, Plovdiv 4000, bul.L.Karavelow 9B
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>