JUYANG JC006 USB Wireless CarPlay Adapter User Manual
- May 15, 2024
- JUYANG
Table of Contents
Wireless
CarPlay Adapter
JC006 USB Wireless CarPlay Adapter
User Manual
Make sure your iPhone’s Bluetooth and Wi-Fi features are turned onand no other
in-car devices are connected. On your iPhone, go to”Settings” > “Bluetooth”,
in Other Devices list, you will see a Bluetooth device name starting with
CarPlayBox, tap to pair. Allow permission and tap Use CarPlay to Connect
wirelessly.
Product function introduction
Wireless transmission brings a more convenient connection experience and greatly enhances the owner’s experience of using CarPlay.
Product specification parameters
Product Name: Wireless CarPlay Adapter
Configuration: Synchronize Mobile Phone Configuration
Network Communication: Sync Cellular Network
Material:ABS
Power Supply: Vehicle
Powered Interface: USB-A or USB-C
Power Input: 5V 1A-2.1A
Product Power: 0.15W
Output Resolution: Adaptative
Compatible car models and iPhone devices
Search for compatible models:
https://www.apple.com/ios/carplay/available-models/
supports iPhone 6 and above, software version iOS 10 and above
Product connection
If the factory car supports CarPlay connection via USB cable, please plug the product into the USB port in the car. Such USB ports may be marked with CarPlay car icon or smartphone icon. Select CarPlay function in the car system, it will enter the following interface.
Version update description
In case your Bluetooth can not connect the “ConnectBoxBt” try to connect the
WiFi “ConnectBoxBt”, enter the password “88888888”
After connecting to wireless CarPlay, scan this QR code with your camera or
enter 192.168.2.1 in safari to update firmware.
Note that some head units cut off the power to the USB adapter while updating
and leaving the process stuck at 1%.
If this is the case please connect the adapter to a USB port with constant
power supply, such as a computer port.
Note: You need an iPhone and open mobile data function to access the browser.
FCC warning statements:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly
approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement This
equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>