Zhongshan Juyang Pump JY-820T Submersible Water Pump Owner’s Manual

Zhongshan Juyang Pump JY-820T Submersible Water Pump

introduce

Our pumps are carefully checked and tested to ensure safety and operational performance. However, failure to follow the instructions and warnings in this manual may cause pump damage and / or serious damage. Before operating this equipment, please read this manual carefully for future reference!

Operation introduction

• Unplug the power supply before operating the pump
• Ensure that the pump is fully immersed in water before it is plugged in to start.
• The pump receiving range has been set, and the receiving distance beyond the coil may not work.
• The pump cannot be adjusted and works if electrified. If the power supply is cut off, the water supply will be cut off .

Maintenance

• Plastic bearings, ceramic shafts and shaft sleeves will wear slightly after being used for a long time, so they will make noise. Please replace these spare parts after a period of use. Replacement method: unplug the power supply, open the impeller room, and replace it after removal
• A clogged or dirty water intake net hood will greatly reduce the performance, remove and move the impeller chamber to separate it from the motor body and remove the impeller and shaft. And you ca n then clean all the parts with a brush. If there is limestone in these areas, put it in vinegar for a f ew hours. Then assemble all the components according to the part requirements. Then reassemble all the components in the appropriate order.

Prudent

• The pump shall always be completely submerged in the pump while working
• Don’t let the pump dry up
• To prevent the Drive Coil and outlet, always disconnect the outlet prior to the cleaning, maintenance and handling of the pump.
• Do not use the pump in liquids above 35℃.
• Do not use it in saline water.
• If the plug or socket is indeed wet, do not unplug the power cord and disconnect the fuse or circuit breaker that supplies the appliance. Then remove the power supply and check for water in t he container.
• The wireless pump does not have a power cord. If the pump is not working, check the drive coil f or power supply.
• The pump is not suitable for unsupervised young children or frail persons.
• This appliance does not apply to persons wit h decreased physical, sensory or mental abilities, or persons (including children) without experience and knowledge, unless the person responsible for their safety gives them supervision or instructions on the use of the appliance.
• Children should be supervised to ensure that they do not play with the device

Disposal: Do not treat this product as an unclassified municipal waste. This waste needs to be collected separately for special treatment

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement

This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provide with antenna installation instructions and transmitter operating conditions for satisfying RF exposure

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>