KitchenAid KRFF577KPS French Door Bottom Mount Refrigerator User Guide
- May 15, 2024
- KitchenAid
Table of Contents
French Door Bottom
Mount Quick Start Guide
KRFF577KPS French Door Bottom Mount Refrigerator
OPERATING INSTRUCTIONS
WARNING: To reduce the risk of fire, electric shock, or injury to
persons, read the IMPORTANT SAFETY INSTRUCTIONS, located in your appliance’s
Owner’s Manual, before operating this appliance.
IMPORTANT: Before operating this appliance, make sure it has been
properly installed according to the appliance’s Owner’s Manual.
The control center is located at the top front of the refrigerator
compartment.
TEMPERATURE CONTROLS
For your convenience, your temperature controls are preset at the factory.
When you first install your refrigerator, make sure the controls are still set
to the recommended set points as shown. IMPORTANT:
■ The recommended settings should be correct for normal household refrigerator
use. The controls are set correctly when milk or juice is as cold as you like
and when ice cream is firm.
IMPORTANT: When the power is on, the temperature display shows the set
point temperature of the compartment.
■ Wait 24 hours for your refrigerator to cool completely before adding food.
If you add food before the refrigerator has cooled completely, your food may
spoil.
NOTE: Adjusting the refrigerator and freezer controls to a colder than
recommended setting will not cool the compartments any faster.
■ If the temperature is too warm or too cold in the refrigerator or freezer,
first check the air vents to be sure they are not blocked before adjusting the
controls.
To Turn Your Refrigerator Off/On:
Press the freezer (+) touch pad repeatedly until “Off” appears in the freezer
display. Allow a few seconds for the refrigerator to shut off. Neither
compartment will cool.
Adjust Set Points
The first touch of the (+) or (-) touch pad displays the current temperature
set point.
Press the (+) or (-) touch pads until the desired temperature set point is
displayed.
NOTE: Except when first turning on the refrigerator, do not adjust either
temperature control more than one setting at a time. Wait 24 hours between
adjustments for the temperature to stabilize.
Adjusting the Controls
The Refrigerator control adjusts the refrigerator compartment temperature. The
Freezer control adjusts the freezer compartment temperature.
If you need to adjust the temperature in either the refrigerator or freezer
compartment, use the settings listed in the chart below as a guide.
CONDITION: | TEMPERATURE ADJUSTMENT: |
---|---|
Refrigerator too cold | Refrigerator setting 1° higher |
Refrigerator too warm | Refrigerator setting 1° lower |
Freezer too cold | Freezer setting 1° higher |
Freezer too warm / too little ice | Freezer setting 1° lower |
MAX ICE
The Max Ice feature assists with temporary periods of heavy ice use by
increasing ice production. ■ Press the Max Ice touch pad to set the freezer to
the lowest temperature setting. Press the Max Ice feature touch pad again to
return to the normal freezer set point.
NOTE: The Max Ice feature will shut off automatically in approximately 24
hours.
MAX COOL
The Max Cool feature assists with periods of high refrigerator use, full
grocery loads, or temporarily warm room temperatures. ■ Press Max Cool to set
the freezer and refrigerator to the lowest temperature settings.
Press Max Cool again to return to the normal refrigerator set point.
NOTE: The Max Cool feature will shut off automatically in approximately
12 hours.
DOOR ALARM
The Door Alarm feature sounds a chime every few seconds when the refrigerator
door has been left open for 5 continuous minutes. The chime will sound until
the door is closed or Door Alarm is turned off. ■ Press the Door Alarm touch
pad to turn this feature on or off. The indicator light will be lit when the
Door Alarm feature is on.
TEMP ALARM
The Temp Alarm feature provides temperature information in the event of a
power outage.
Temperature alarm: An alarm will sound repeatedly if the freezer or
refrigerator compartment temperatures exceed normal operating temperatures for
an hour or more.
The temperature displays will alternately show the current temperatures and
the highest temperatures the compartments reached. ■ Press the Temp Alarm
touch pad once to stop the audible alarm and alternating temperature displays.
The Temp Alarm light will continue to flash until the refrigerator returns to
the set temperature.
Power outage: During a power outage, if the temperatures in the refrigerator
and freezer compartments exceed normal operating temperatures, the highest
temperature reached will be displayed.
■ Press the Temp Alarm touch pad until the indicator light is lit, to turn on
this feature. Press and hold Temp Alarm for 3 seconds until the indicator
light goes off to turn off this feature.
HUMIDITY CONTROL
The Humidity Control feature turns on a heater to help reduce moisture on the
door hinge seal.
Use in humid environments or when you notice moisture on the door hinge seal.
The refrigerator uses more energy when Humidity Control is on. ■ Press
Humidity Control when the environment is warm and more humid, or if you notice
moisture on the door hinge seal. The indicator light will be lit when humidity
control is on.
■ Press Humidity Control to off to save energy when the environment is less
humid.
WATER FILTER STATUS
The water filter status lights will help you know when to change the water
filter. When the Order light is on, it is almost time to change the water
filter. When the Replace light is on, a new water filter should be installed.
IMPORTANT: The disposable water filter should be replaced at least every
6 months. If the water flow to the water dispenser or ice maker decreases
noticeably before 6 months have passed, replace the water filter more often.
FILTER RESET
The filter reset control allows you to restart the water filter status
tracking feature each time you replace the water filter. See “Water Filtration
System” in the Owner’s Manual.
■ After replacing the water filter, press and hold Filter Reset for 3 seconds,
until the Order or Replace light turns off.
USER PREFERENCES
The control center allows you to set user preferences, if desired.
Temperature Display (F_C) | Alarm (AL) |
---|---|
This preference allows you to change the temperature display. | This preference |
allows you to turn off the sound of all alarms.
F – Temperature in degrees Fahrenheit| On – You will hear the alarm sound.
C – Temperature in degrees Celsius| Off – You will not hear the alarm sound.
To Access the User Preferences Menu:
- Press and hold the Door Alarm touch pad for 3 seconds. The preference name will appear in the freezer display and the preference status (F or C) or (On or Off) will appear in the refrigerator display.
- Use the freezer (+) or (-) touch pads to scroll through the preference names. When the desired preference name is displayed, press the refrigerator (+) or (-) touch pads to change the preference status.
- Set your preferences by pressing and holding the Door Alarm touch pad for 3 seconds, or by closing the refrigerator compartment door.
Online Ordering Information
For detailed installation instruction and maintenance information, winter
storage, and transportation tips, please see the Owner’s Manual included with
your appliance.
For information on any of the following items, the full cycle guide, warranty,
detailed product dimensions, or for complete instructions for use and
installation, please visit https://www.kitchenaid.com/service-and-support,
or in Canada https://www.kitchenaid.ca/service-and-support. This may save
you the cost of a service call. However, if you need to contact us, use the
information listed below for the appropriate region.
United States:
1–800–253–1301
KtichenAid Brand Home Appliances
Customer eXperience Center
553 Benson Road
Benton Harbor, MI 49022–2692
Canada:
1–800–807–6777
KitchenAid Brand Home Appliances
Customer eXperience Center
200–6750 Century Ave.
Mississauga, Ontario L5N 0B7
SAVE THESE INSTRUCTIONS
W11402367B
W11411659B-SP
06/23
®/™ ©2023 KitchenAid. All rights reserved.
Used under license in Canada.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>