JUBEST TSQAL10-3FT 36 Inch Bifold Door Hardware Installation Guide
- May 15, 2024
- JUBEST
Table of Contents
JUBEST TSQAL10-3FT 36 Inch Bifold Door Hardware
Product Information
Specifications
- Model: TSQAL10-3FT
- Components:
- ST4.2×32 Screws (Quantity: 5)
- ST4.2×16 Screws (Quantity: 12)
- ST4.2×43 Screw (Quantity: 1)
- ST4.2×25 Screws (Quantity: 9)
Product Usage Instructions
- Identify the components included in the package.
- Refer to the provided manual for specific instructions on using each type of screw.
- Ensure the compatibility of the screws with the materials you intend to fasten.
- Use the appropriate screwdriver or tool to tighten the screws securely.
- Contact customer support at support@jubest.com for any assistance or queries.
FAQ
-
Q: How do I know which screw size to use for my project?
A: Refer to the provided manual or contact customer support for guidance on selecting the appropriate screw size based on your project requirements. -
Q: Can I use these screws for outdoor applications?
A: It is recommended to check the material and coating of the screws to ensure they are suitable for outdoor use to prevent corrosion. -
Q: What should I do if I encounter difficulties during installation?
A: Contact customer support at support@jubest.com for troubleshooting assistance and guidance on installation processes.
PRE-INSTALLATION
TOOLS REQUIRED
HARDWARE INCLUDED
INSTRUCTIONS
For 3/4″(19mm) to 1-3/4″(45mm) Panels weighing up to 40 lbs. (18 kgs) each
.
Mount track 3/4″ (19mm) from the front edge of the head jamb.
Mount hinges on the back of the door. Lay panels face down on a flat surface
.
Fasten pivot plates to the top and bottom of doors as shown
Mark the location of the Bottom pivot bracket on the jamb. Fasten in place
with one ST4.2 X 25 flat head screw.
Hang doors: Make sure the Track pivot lock is in the unlocked position
.
- (A) Fold doors and insert the Door hanger plate into the track groove. Place the Top pivot into the receptor of the Track pivot lock.
- (8) When firmly seated, slide the tab lock toward the pin. The door now should be hanging from the Toip pivot.
- (C) Depress the Bottom pivot bracket socket arm and insert the Bottom pivot. If no vertical adjustment is needed, secure the Bottom pivot bracket with other 2 screws. Use a wrench for horizontal adjustment of the Top pivot lock and Bottom pivot bracket.
Mount knob
Mount aligner on back side of lead doors(4 door sets only).
Adjust the Track stop Close doors, and slide the Track stop until it
touches the Door hanger plate. Open doors, move the Track stop 1/8″ (3mm)
closer to the Door hanger plate and tighten, Doors should “snap” shut yet open
easily by a slight pull on the knob.
Website: www.JuBest.com
Feel Free to Contact Us : support@jubest.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>