K2AUDIO KIRA-Q Gen 2 Sky Control System User Guide
- June 4, 2024
- K2AUDIO
Table of Contents
K2AUDIO KIRA-Q Gen 2 Sky Control System
Quick Start Guide.
The detailed instructions can be found at www.info.keene-
electronics.co.uk.
-
Step 1
Connect the supplied KT9USB cable to a suitable USB power outlet or use a DC adaptor rated between 7.5v and 9v >200mA -
Step 2
Scan for and connect to the wireless network called K2AUDIO_AP. The default password is K2AUDIO! (all caps). Once connected enter 192.168.4.1 into your browser address bar. You should now be able to see the web page for the KiraQ module. -
Step 3
From the top menu select “network” and click to scan for available networks. Once the list is populated select your wireless network, enter the password then click
“connect”. After a few seconds you should see a success message and the newly assigned IP for the KiraQ module. Browse to this address to finish configuration. -
Step 4
From the top menu select “Box Setup”. The module can store up to 10 boxes (0 through 9) and you can assign each one a friendly name, eg “study, Kitchen, Room3” etc. If you know the IP address for the box simply enter it into the appropriate slot, type the friendly name and then check the box and click on “Save Changes”.
If you do not know the box IP address you an initiate a search checking the box and clicking on “Save changes”. This will scan the network and attempt to resolve a valid IP address
Operation
- To control the boxes you can either use the “web buttons” control page or aim the Sky remote at the module. To switch between boxes use the “box setup” page or press the BLUE button on the remote followed by the box number.
- Wired ethernet and RS232 require the optional expansion module K2GEM. Please refer to the full instructions at www.info.keene-electronics.co.uk
K2Audio Ltd
28 Parker House Mansfield Rd Derby DE21 4SZ
sales@k2audio.co.uk
References
- K2Audio Keene Electronics User Guides
- K2Audio Ltd infrared over IP specialists Bluetooth Audio Amplifier