AEG DBE5960HB Cooker Hood User Manual
- May 15, 2024
- AEG
Table of Contents
User Manual | Cooker Hood DBE5960HB
DBE5660HB
DBE5960HB Cooker Hood
aeg.com/register
https://www.aeg.com/support/user-manuals/
Welcome to AEG! Thank you for choosing our appliance.
Get usage advice, brochures, trouble shooter, service and repair information: www.aeg.com/support
Subject to change without notice.
SAFETY INFORMATION AND INSTALLATION
WARNING!
Refer to the separate Installation Instructions booklet for Safety Information
and Installation. Read carefully the Safety chapters before any use or
maintenance of the appliance.
PRODUCT DESCRIPTION
2.1 Control panel overview
| Function| Description
---|---|---
1| On / Off| Turns the hood on and off.
2| First speed| The motor switches to first speed level.
3| Second speed| The motor switches to second speed level.
4| Third speed| The motor switches to third speed level.
5| Maximum speed| The motor switches to maximum speed level.
6| Breeze| The hood operates on the lowest speed. After 60 minutes the
appliance turns off.
7| Filter notification| Reminds to change or clean the charcoal filter and
clean the grease filter.
8| Hob²Hood| Indicator of the function to control hood from hob.
9| Lamp| Turns the lights on and off.
DAILY USE
3.1 Using the hood
Check the recommended speed according to the table below.
| While heating up food, cooking with covered pots.
---|---
| While cooking with covered pots on multiple cooking zones or burners, gentle
frying.
| While boiling and frying big quantities of food without a lid, cooking on
multiple cooking zones or burners.
| While boiling and frying big quantities of food without a lid, big humidity.
| Refreshes the air in kitchen after cooking at a very low noise level.
It can be activated and de-activated by touching the symbol. The function
turns off automatically after 60 minutes. Use after cooking only.
It is recommended to leave the hood operating for approximately 15 minutes
after cooking.
The control Panel is a sensor field. Touch the symbols for 1 second to
activate the functions.
To operate the hood:
-
Turn on the appliance by pressing the symbol.
You can now activate the functions. -
To activate the function touch the symbol.
-
If needed, touch the light symbol to illuminate the cooking surface.
To turn off the appliance press the symbol again.
3.2 Hob²Hood function
It is an automatic function which connects the hob with a hood. Both the hob
and the hood have an infrared signal communicator. Speed of the fan is defined
automatically on basis of mode setting and temperature of the hottest cookware
on the hob. You can also operate the fan using the hob manually. The function
can be activated from panel of the hob.
For more information how to use the function refer to the hob user manual.
3.3 Activating Maximum Motor Speed
When you touch , the Maximum Motor Speed starts to operate for 8 minutes.
After that time, the appliance returns to its previous speed settings.
When the function is turned on, additional touch on does not have any effects.
3.4 Filter notification
Filter alarm reminds to change or clean the charcoal filter and clean the
grease filter. The filter indicator is turned on for 30 seconds if the grease
filter must be cleaned. The filter indicator flashes for 30 seconds if the
charcoal filter must be replaced or cleaned.
Refer to cleaning the grease filter in care and cleaning chapter.
Refer to cleaning the charcoal filter or replacing the charcoal filter in care
and cleaning chapter.
To reset the function touch for 3 seconds.
To activate or deactivate function:
-
Switch on the control panel.
-
Make sure that the icons are turned white.
-
To activate function touch for 3 seconds.
If the function is activated, the filter icon flashes five times. -
To deactivate function touch for 3 seconds.
If the function is deactivated, the filter icon turns on for 4 seconds.
CARE AND CLEANING
4.1 Notes on cleaning
Cleaning Agents| Do not use abrasive detergents and brushes.
Clean the surface of the appliance with a soft cloth with warm water and a
mild detergent.
---|---
After cooking some parts of appliance can get hot. To avoid stains appliance
must be cooled down and dried with clean cloth or paper towels.
Clean stains with a mild detergent.
Keep the hood clean| Clean the appliance and grease filters each month.
Clean the interior and grease filters carefully from fat. Fat accumulation or
other residue may cause fire.
Follow the instructions for cleaning the accessories when filter notification
is on. Refer to Filter notification in daily use chapter.
Grease filters can be washed in a dishwasher.
The dishwasher must be set to a low temperature and a short cycle. The grease
filter may discolour, it has no influence on the performance of the appliance.
Charcoal filter| The time of saturation of the charcoal filter varies
depending on the type of cooking and the regularity of cleaning the grease
filter.
4.2 Cleaning the grease filter
Filters are mounted with the use of clips and pins on the opposite side.
To clean the filter:
-
Press the handle of the mounting clip on the filter panel underneath the hood (1).
-
Slightly tilt the front of the filter downwards (2), then pull.
Repeat the first two steps for all filters. -
Clean the filters using a sponge with non abrasive detergents or in a dishwasher.
The dishwasher must be set to a low temperature and a short cycle. The grease filter may discolour, it has no influence on the performance of the appliance. -
To mount the filters back follow the first two steps in reverse order.
Repeat the steps for all filters if applicable.
4.3 Replacing the charcoal filter optional
WARNING!
Depending on type, filter can be or cannot be regenerated. Refer to the
leaflet provided with the filter.
To replace the filter:
-
Remove the grease filters from the appliance.
Refer to “Cleaning the grease filter” in this chapter. -
press the tab (1) and slightly tilt the front of the filter.
-
To install a new filter, perform the same steps in reverse order.
In any case, it is necessary to replace the filters at least every four months.
4.4 Replacing the lamp
This appliance is supplied with a LED lamp and separate control gear (LED
driver).
These parts can be replaced by a technician only. In case of any malfunction
refer to “Service” in the “Safety Instructions” chapter.
ENVIRONMENTAL CONCERNS
Recycle materials with the symbol . Put the packaging in relevant containers to recycle it. Help protect the environment and human health by recycling waste of electrical and electronic appliances. Do not dispose of appliances marked with the symbol **** with the household waste. Return the product to your local recycling facility or contact your municipal office.
aeg.com
867382455-A-352023
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>