Hydrogen Water 4U Hydro V Hydrogen Water Bottle User Manual

Hydrogen Water 4U Hydro V Hydrogen Water Bottle

Product Usage Instructions

Set up:

How to remove protective cap inside the bottle?

1. Untwist the glass from the bottom of the generator.
2. Untwist the cap and remove it from the bottle.
3. Twist the glass body back on the generator.

Quick Set Up:

1. Charge the generator using the USB-C cable. The green light will indicate fully charged. One charge usually lasts about 20, 10 min cycles.
2. Gently wash the body and lid with warm soapy water and dry completely before reassembling.

DO NOT wash or submerge generator/bottom of the bottle at any time.

How to use: Switching On/Off

1. Fill with filtered, mineral, or spring water. Fill to just below top threads of the bottle to allow for gas pressure.
2. To power on the bottle, press the power button located on the bottom of the generator.
   • Press once = 3 min cycle and produces up to 1800 ppb
   • Press twice = 10 min cycle and produces up to 3000 ppb
3. Once a cycle is complete, untwist the lid to allow excess pressure to release.
4. To power off the bottle before the hydrogen cycle ends and automatically turns off, press the power button again.

Drink within 30-60 minutes of a cycle for maximum hydrogen consumption.

Charging The Device:

1. When the battery is low, the LED will blink blue while it’s running.
2. Remove the rubber cover from the USB-C port located on the back of the base of the generator.
3. Plug the provided USB-C power cable into the bottle and the other end into a USB adaptor. When charging, the bottom will light up red.
4. Once fully charged, the LED will turn green. Unplug and replace the cover to the USB-C port.

Using the Inhaler Option:

1. Remove the rubber cap and locate the inside of the lid. Keep it in a safe location. DO NOT DISCARD.
2. Open the cover on the top of the lid.
3. Rinse cannula tube with warm soapy water. Drink the rest of the water or discard.

Active Self-Cleaning Mode:

1. Fill halfway with water.
2. Press and hold power button down until LED turns green. Light will go off when cycle is complete.
3. Dump water out. Rinse with warm water.
4. Disassemble the bottle and wash body and lid with warm soapy water.
5. Dry completely and reassemble.

FAQ

Q: How often should I clean my Hydro VTM?

A: It is recommended to clean your Hydro VTM after every use or at least once a day to maintain optimal performance and hygiene.

Overview of the Hydro V™

Features

Specifications

Set up

• How to remove protective cap inside the bottle?

  • Untwist the glass from the bottom the generator.

  • Untwist the cap and remove it from the bottle.

  • Twist the glass body back on the generator.
    Do not through cap away. You may require it for storing in the future.

  • If storing for longer time. Put a bit of distilled water on generator plates and seal back with the cap. This help keep the plates and membrane protected.

Quick Set Up

1. Charge the generator using the USB-C cable.
   The green light will indicate fully charged. One charge usually lasts about 20, 10 min cycles.

2. Gently was the body and lid with warm soapy water and dry completely before reassembling.
   DO NOT wash or submerge generator/ bottom of the bottle at any time.

How to use: Switching On/Off

1. Fill with filtered, mineral, or spring water.
   Fill to just below top threads of the bottle to allow for the gas pressure.

2. To power on the bottles, press the power button located on the bottom of the generator.
   Press once = 3 min cycle and produces up to 1800 ppb Press twice = 10 min cycle and produces up to 3000 ppb once cycle is complete, untwist the lid to allow for excess pressure to release.

3. To power off the bottle before hydrogen cycle is ends and automatically turns off. Press the power button again.
   Drink with in 30-60 minutes of a cycle for maximum hydrogen consumption.

Charging The Device

When the battery is low the LED will blink blue while it’s running.

1. Remove the rubber cover from the USB-C port located on the back of the base of the generator.
2. Plug the provided USB-C power cable into the bottle and the other end into a USB adaptor. When charging the bottom will light up red
3. Once fully charged the LED with turn green. Unplug and replace the cover to the USB-C port.

Using the Inhaler Option

1. Remove the rubber cap and locate the inside of the lid.
   Keep in safe location. DO NOT DISCARD.

2. Open the cover on the top of the lid.

3. Insert the cannula tube firmly to the opening in the center of the lid.

4. Fill the bottle with 3/4 water.

5. Screw the lid back on the bottle with the tube attached.

6. Place the loop end of the cannula tube around your ears and insert the breathing prongs into you nostrils

7. Power to 10 min cycle. and relax for 30-45 minutes, restarting the cycle as needed.

8. When you are done, remove the tubes from your nose, remove the tube from the lid, unscrew the lid and place the rubber protector cap back on the inside of the lid.

Rinse cannula tube with warm soap water. Drink the rest of the water or discard.

Active Self-Cleaning Mode:

1.  Fill 1/2 way with water

2. Press and hold power button down until LED turns green.
   Light will go off when cycle is complete.

3. Dump water out. Rinse with warm water.

4. Disassemble the bottle and wash body and lid with warm soapy water

5. Dry completely and reassemble.

Here is a simple cleaning schedule:

Daily: Fully assembled rinse with warm water to clear out any particles that are left over from daily use.
Weekly: Disassemble and wash the body and lid with warm soapy water and let fully dry before reassembling. Increase frequency as desired.
Weekly or Monthly: Deep clean the generator using the instructions below.

Deeper Clean (if needed)
If you notice your plates getting white film on them or your bubbles start to decrease this is a sign that there is calcium build up on the plates.

Follow the instructions for an easy deep clean.

1. Add 5ml or 1 tsp of vinegar, lemon juice, or citric acid and
2. parts water into the bottle.
3. Shake well and leave mixture for 10-20 minutes.
4. Dump mixture out and rinse with fresh warm water.

Care Instructions

1. We recommend using the self-cleaning mode every 30 days or as needed
2. To keep the membrane from drying out, keep water in the bottle.
3. Keep the USB-C port protected by replacing the back cover.
4. Store it in a dry and cool place, away from direct sunlight or heat.
5. Use and recharge the battery regularly maintain battery performance.
6. Do not store or place the device in the oven or near an open Same
7. Do not use boiling water, carbonated drinks, or anything other than water.
8. Do not pull out the charging cable from bottle with wet hands.
9. Do not operate the generator without water in the bottle.
10. Rinse and clean out your bottle regularly with warm water and light soap.

Hydro VT™
Hydrogen Water Bottle User Manual
www.hydrogenwater4u.com

References

• Hydrogen Water 4U - Infusing your water with he power of hydrogen

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>