HIGHLANDS JC11142-Commander Can Am Commander Bed Cover Owner’s Manual
- May 15, 2024
- HIGHLANDS
Table of Contents
HIGHLANDS JC11142-Commander Can Am Commander Bed Cover
Product Information
Specifications
- Product Name: Can-Am Commander Bed Cover
- Model: JC11142_Commander
- Manufacturer: HIGHLANDS
- Address: 22000 Industrial Blvd Ste 250 Rogers, MN 55374
- Contact: 866.527.7637
Product Usage Instructions
Installation Instructions
- Open your new HIGHLANDS bed cover and locate the four drilled holes on the base section of the cover.
- Unthread the four included anchors and put the rubber section on the bottom of the base and put the bolt with the washer through the holes on the inside of the base.
- Loosely re-thread the bolts so that the anchor assembly is secure.
- Place the bed cover on your machine. It may take a few tries to carefully lower the cover so the anchors go into the factory locations on your machine.
- Once the cover is fully seated on the bed, open the lid and tighten the bolts while pressing down on the bed cover to ensure a tight seal.
Contact Information
For more information or assistance, please contact HIGHLANDS at
www.motoalliance.com or via email at
motoinfo@motoalliance.com. You can also
reach them at 866.527.7637.
FAQ (Frequently Asked Questions)
Q: How do I ensure a proper fit of the bed cover on my Can-Am Commander?
A: Carefully follow the installation instructions provided, ensuring that the anchors align with the factory locations on your machine for a secure fit.
Q: Can I use this bed cover with other models besides the Can-Am Commander?
A: It is recommended to use this bed cover specifically with the Can-Am
Commander model for optimal fit and performance.
Parts Included
| Part # | Qty. | Item |
|---|---|---|
| 1 | 1 | HIGHLANDS JC11142_Com- |
mander Bed Cover
2| 4| JC_Anchor_5
INSTALLATION INSTRUCTIONS
- Open your new HIGHLANDS bed cover and locate the four drilled holes on the base section of the cover.
- Unthread the four included anchors put the rubber section on the bottom of the base and put the bolt with the washer through the holes on the inside of the base.
- Loosely re-thread the bolts so that the anchor assembly is secure.
- Place the bed cover on your machine. It may take a few tries to carefully lower the cover so the anchors go into the factory locations on your machine.
- Once the cover is fully seated on the bed, open the lid and tighten the bolts while pressing down on the bed cover to ensure a tight seal.
- www.motoalliance.com
- motoinfo@motoalliance.com
- 866.527.7637
- Rogers, MN
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>