GreatCut-S Installation and Activation User Guide

GreatCut-S Installation and Activation

GreatCut-S Installation and Activation

Auto Installation

1. Visit http://gccf.gcc.com.tw/gccclub/login.aspx and log in your GCC Club account.
   
   or create a new GCC club account if you do not have one. Click “I Agree”, fill in the required information and click “Submit” to sign up.
   
   You should receive an e Mails with activation link and click the link to activate your account.
   

2. Go to GCC Club, click “Great Cut-S voucher code” on the left side.
   

3. Enter your voucher code and click “submit”.
   

4. You will get your Great Cut-S serial number.
   

5. Visit https://www.gccworld.com/download.php click the product category and choose a proper model.
   

6. Download Great Cut-S to start the installation.
   

7. Press Next to continue, tick “Launch Great Cut-S” and then press “Finish” to compete the installation.
   

8. Run Great Cut-S and press “Activate…”to activate Great Cut-S. Please make sure it is connected to the internet.
   

9. Enter your name in the Name column and Great Cut-S serial number to the Serial column and press “OK” to complete the activation.
   

10. Great Cut-S is ready to use.
    
    Note
    ✓ If you use a trial version to output graphics, meaning you do not enter the software key to activate the Sure Cuts A Lot mentioned above, there will be two extra lines cut through the design, therefore, make sure the Sure Cuts A Lot software is activated before implementing cutting jobs.

Manually Activate Great Cut-S

If the computer connected to the cutter doesn’t have an internet connection to complete the software activation process, you can alternatively use the “Activate manually” function to enter the “Activation Code” and begin using Great Cut-S. However, you will need to find another computer with internet access in advance to obtain the “Activation Code” by following the instructions below.

1. Check the “Activate manually” checkbox and you should see the Site Code and Activation Code fields appear. The Site Code field will be pre-filled in and cannot be changed.
   

2. Visit https://craftedge.com/activation/greatcut/ via an internet connected computer. Enter your name, serial and site code.
   

3. Click on the “Generate Activation Code” button, and your activation code will be shown in the Activation Code field.
   

4. Copy and paste the activation code back into the activation dialog box of Sure Cuts A Lot program and hit ok.
   

5. Click OK and Great Cut-S is ready to use.
   

Re-install Great Cut-S Software

If you change a new computer, you may need to deactivate your Great Cut-S software and re-install it on your new device.

Go to “Deactivate…” under Help and press Yes to confirm, then follow the installation procedure and use the same code to activate it on another computer.

Reset Great Cut-S Serial Code

If you need to re-install the software again due to problems such as a computer crash/reformat where you were not able to de-activate your copy off the computer first, you may visit https://craftedge.com/activation/deactivateGC.php to reset your serial number

References

• GCC Club
• Craft Edge: Software Activation
• GreatCut-S: Software Activation
• Download Area | GCC Laser Engraving and Cutting Machines

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>