FUZ Luxury Freestanding Tub Faucet Instruction Manual
- May 15, 2024
- FUZ
Table of Contents
FUZ Luxury Freestanding Tub Faucet
INSTALLATION INS1RUCTION
INSTALLATION INSTRUCTIONS FOR FLOOR MOUNT TUB FILLER FAUCET BEFORE BEGINNING INSTALLATION:
- Open the package and inspect the faucet for any defect or missing parts prior to installation.
- This faucet should be located away from traffic areas; impact both by foot traffic or floor cleaning equipment may damage the faucet and might cause a leak which result in water damage.
- Please read this installation instruction throughhly, make sure that you have all the required tools and supplies needed to complete this installation.
- Due to the applicationa and design of this faucet, extensive consideration should given to its installation.
- Flush all supply lines prior to installation.
- Shut off both HOT and COLD supply line after flushing.
Step 1: Insert the faucet tube into the base cover.
Step 2: Thread the tube onto the mounting tripod.
Step 3: Hand tighen the hot and cold flexible water supply line onto
faucet body.
DO NOT USE wrench or Spanner to tighten as it could damage the O-Ring on the
supply lines. The flexible supply line are to be fitted onto correct inlets
for Hot and Cold water.
Step 4: Insert faucet body assembly onto the faucet tube from the top and hand tighen it.Make sure the flexible water supply lines go through the tube smoothly.
Step 5: Locate the faucet assembly onto the rough valves from floor, and secure the connection of inlet supply lines to the valves. DO NOT reverse the Hot and Cold supply.
Step 6: Secure the mounting tripod onto the floor using the attached mounting screws.
Step 7: Use the explosive screw to fix the base on the floor and place the base cover over the valve.
Step 8: Make sure the black gasket is in the hose end with flats, thread hose onto outlet and tighten it. Turn the supply lines on and turn the handle to full operate position, hold the hose inside the tub and let it flush for one minute.
Step 9: Install hand held shower to the hose and check for any leak between hose connection and hand held shower
Step 10: Remove the aerator from the spout (if any) and switch the diverter from hand held shower to spout mode and and let both hot and cold water flush for one minute to clear any debris from water lines. Replace aerator and faucet is ready to use.
WARNING!
DO NOT LEAN ON, STEP ON OR USE THIS FAUCET AS A SUPPORT TO GET IN AND GET OUT
FROM THE TUB.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>