RAY5 Series Longer Laser Engraver Camera Instruction Manual

RAY5 Series Longer Laser Engraver Camera

Thank You

LONGER LASER ENGRAVER CAMERA INSTRUCTIONS

Thank you for choosing our products.
Please read this manual carefully before use.

Please reference more details on digital manual about the operation of Laser Engraver and installation of Laser GRBL or Light Burn.

PACKING LIST

• Connector

• Camera

• Basswood

• Focusing piece

• Bracket

• Base

• M5*10 Screw x4

• Ruler

INSTRUCTIONS STEPS

Connect the following components according to the steps shown in the figure

Determine the center position of the camera

1. Connect the engraving machine, and click Home to complete, change the X position to 225mm in the mobile option, and change the Y position to 220mm (the engraving format is 450440mm, X is changed to 225mm, Y is changed to 220mm; if the engraving format is 400400mm, X is changed to 200mm, Y is changed to 200mm), click go. After completion, put the 100mm100mm basswood flat on the center of the working area and draw a 5050 file like“ ” in Light Burn software. Select the Current Position as the Start Form, and select the center point as the Job Origin click Frame to adjust the position of the basswood.
   

2. Modify the engraving parameters and click to start engraving. After the engraving is completed, it is shown in the figure below.

3. Align the center of the camera lens with the intersection point on the basswood board as vertically as possible.

Make the distance between the working plane and the camera lens 545 mm, make sure the camera sees the entire work area.

Camera calibration

1. Connect the camera to the computer with a USB cable, and open the Light Burn software to connect to the engraving machine.
   

2. According to the software prompts and follow the steps, a total of 9 positions in the working area need to be calibrated, which are the exact center, the middle of the 4 sides of the working area and the positions of the 4 corners. Placing a similar paper with a slightly larger area under the calibration plate can better improve the capture effect.
   

3. Make location markers.
   

4. Set the engraving parameters (refer to the laser parameter table), and set the scale value according to the actual positioning size.
   Scale| Size(mm²)
   ---|---
   100| 200200
   150| 300300
   200| 400*400

5. Before clicking Frame, select Current Position as the Start Form, the lower left corner point is used as the Job Origin.
   Patrol to see if there is a collision machine, you need to set a smaller Scale value or recalibrated the camera.

6. Set the printing parameters and click to start printing.
   Follow the software prompts until the calibration and positioning of the camera is completed.
   

After simple calibration, It can realize high-definition video recording and real-time monitoring. It can be engraved point-by-point engraving, automatically locate the position of the workpiece for engraving, no need to deliberately engrave the material, solve the problem of positioning different patterns, and can complete multiple independent tasks at the same time.
Put a sculpted object into the working area, click Update Overlay, and you can see the object in the left working area of the software. Use the drawing tool to draw graphics on the surface of the object, set the engraving parameters, and click Print. After printing, you can find the graphics you drew engraved on the object.

CUSTOMER SUPPORT

Please join our Facebook Group:
LONGER Laser Engraver Official Group
Email: support@longer.net
If you have any question, please feel free to contact us as above.
*Copyright © Shenzhen Longer 3D Technology Co.,Ltd. All Rights Reserved
Support Email : support@longer.net
  facebook ID: longer3dprinter
Facebook Group: Longer Laser Engraver Official Group
Youtube channel: Longer 3D

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>