spinlock 3R411A_9 Safety Line Instructions Outlined Instruction Manual

HIGH SPECIFICATION SAFETY LINE
FOR PERFORMANCE SAILING

3R411A_9 Safety Line Instructions Outlined

• Single handed double action safety hooks in   non magnetic stainless steel
• Overload indicator displays when the line loads exceeds 300kg and needs replacing
• Tested to ISO 12401

WARNING: THE SAFETY LINE HOOK MUST BE FREE TO ROTATE TO ALIGN WITH THE LOAD.
LATERAL LOADING OF THE HOOK MUST BE AVOIDED.
WARNING: THE DECK SAFETY HARNESS AND SAFETY LINE ARE INTENDED TO PREVENT THE USER FALLING OVERBOARD. THEY DO NOT PROVIDE PROTECTION AGAINST FALLS FROM A HEIGHT.
WARNING: THE DECK SAFETY HARNESS AND SAFETY LINE MAY TRANSMIT VERY LARGE FORCES.
ONLY ATTACH TO STRONG HOOKING POINTS OR JACK-LINES.
IMPORTANT: DO NOT REMOVE PRIOR TO SALE.
It is essential you read these instructions before using your safety line.
EN ISO 12401:2009 Deck harness
For users at least 16 years of age and 50 kg

SPINLOCK.CO.UK
For continuously updated user guidance go to www.spinlock.co.uk

Instructions for use

HOW TO USE
A. Anchorage point should be located at the centre of the chest. Note: safety harness for illustration only. Ensure no sharp edges on safety line attachment point. Use with approved deck safety only.
Warning: The safety line hook must be free to rotate to align with the load. Lateral loading of the hook must be avoided.
Guidance
Attach to Jackstays/fixed eyes.
Anchorage points shall be able to withstand forces of more than 1 tonne. Never attach to Lifeline/standing and running rigging/going aloft.

GENERAL INFORMATION

Important notice: Specific training is essential before use
Read this notice carefully before use. This technical notice illustrates ways of using this product. Many types of misuse exist, which are impossible to list or even imagine. Only the techniques shown in the diagrams and not crossed out are authorised. All other uses are expressly excluded; danger of death. In case of doubt or problem of understanding, contact Spinlock. Water sports are dangerous activities which may lead to severe injuries or even death. Adequate training in appropriate safety techniques and methods is essential and acquiring this is your own responsibility. You personally assume all risks and responsibilities for all damage, injury or death which may occur during or following wrong use of our products in any manner whatsoever. If you are not able, or not ina
position to assume this responsibility or to take risk do not use this equipment.

USE

This product must only be used by competent and responsible persons, or those placed under the direct and visual control of a competent and responsible person. Check that this product is compatible with other components of your equipment.
To prolong the life of this product, care in use is necessary. Avoid rubbing against abrasive surfaces or sharp edges. As the user you are responsible for checking the product is safe to use. We advise that you check the product before each use, examining for damage or excessive abrasion, wear and tear of the stitching and webbing. If in doubt, please contact Spinlock for review.
The safety line is intended to prevent the user falling overboard, they do not provide protection against falls from height. In a fall the safety line may transmit very large forces to the anchorage point.

MAJOR FALLS

In the event that your full bodyweight is dropped a distance and then stopped, do not continue to use this product. Even if no external changes visible, internal damage may have reduced its strength and its margin of safety. Do not hesitate to contact Spinlock in case of doubt.

CLEANING, MAINTENANCE, STORAGE

Clean by hand or in a machine set for delicate material wash and rinse in clean water (maximum temperature 30° C). Dry in a cool, ventilated dark room. Grease spots may be removed with trichlorethylene. Webbing shrinks very slightly in drying. Though UV protected, this product is best stored away from direct light, in a well ventilated place away from extreme temperatures.
CHEMICALS
All chemicals, (including petrol, battery acid), corrosive materials and solvents should be regarded as harmful. If your safety line comes in contact with chemicals, please notify us, Stating the precise chemicals concerned. We will investigate and give our advice.

LIFETIME = SHELF LIFE + USEFUL LIFE

After first use this product should last 3 years. Certain environmental elements will considerably accelerate wear: salt, sand, moisture, chemicals. In exceptional circumstances, wear or damage could occur on the first use which reduces the lifetime of the product to that one single use. However wear or damage could shorten the product life. Shelf-life of this product in good condition is up to 5 years before first use.
TEMPERATURE
Use this product only above a minimum of -40° C and below a maximum of +80° C.

DISINFECTING THE PRODUCT

When necessary, use a disinfectant that is compatible with polyamide, polyester, polycarbonate, PVC etc. Use diluted with clean water at a maximum temperature of 30° C. After soaking for an hour, rinse in clean cold water. Dry slowly, away from direct heat.

RESPONSIBILITY
Spinlock is not responsible for the consequences, direct, indirect or accidental, or any  type of damage befalling or resulting from the use of its products.

2 YEAR WARRANTY

This product is warranted for 2 years from the date of manufacture against any faults in materials or manufacture. Exclusions from the waranty are: normal wear and tear, modifications or alterations, incorrect storage, damage due to accident, negligence and any use for which the product was not designed. Certain environmental elements will considerably accelerate wear: salt, sand, moisture, chemicals. In exceptional circumstances, wear or damage could occur on the first use which reduces the lifetime of the product to that one single use.

Temperature Storage Dangerous products Cleaning / Disinfection Drying

Spinlock Ltd
41 Birmingham Road
Cowes PO31 7BH
United Kingdom
EU conformity assessment carried out by:
0200 FORCE Certiication A’S, Park Alle 345, 2605 Brondby, Denmark
in accordance with PPE Regulation (EU) 2016/425 0200
UK conformity assessment carried out by:
0514 Fleetwood Notified Body, Broadwater, Fleetwood, FY7 82, UK in accordance with PPE Regulation 2016/425 as brought in to UK law and amended
EU and UK declaration of conformity can be accessed at wwwspinlock.co.uk

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>