Leon TrLS50 Spike Terra Luminsound Instruction Manual
- June 4, 2024
- Leon
Table of Contents
Leon TrLS50 Spike Terra Luminsound
INCLUDED HARDWARE
TrLS50 – Spike
TrLS50 – Hardscape
TrLS50 – Inground
Drawings not to scale
All -Halo models include 2 additional connectors.
INSTALLATION TIPS
Choose an installation location free of physical obstructions. Working near electrical equipment and wires poses an electrocution hazard. Turn off nearby electrical circuits from the breaker. Use a non-contact voltage tester to confirm that the installation location is free of live electrical wires and equipment prior to installation. Contact a qualified electrician before making any modifications to electrical wiring.
Determine the potential hazards of working with hand or power tools and take the appropriate safety precautions. Use personal protective equipment (PPE) as appropriate, including, but not limited to: vision, hearing, and respiratory protection. Consult local building and/or electrical codes prior to installation of speakers, cabling, or electrical equipment.
Cable Routing
To utilize the provided waterproof connectors, strip each conductor ½”.
Insert each bare wire into a hole of the connector. Press down on the top
‘button’ until a click is heard and the wires are secure.
Setting the 70v Transformer
Set the 70v transformer tap wattage prior to installation. The tap switch is
located on the bottom of the speaker and can be turned with a small flathead
screwdriver.
INSTALLATION INSTRUCTION
Ground Mounting with Spike
For ground mounting with TrLS50-Spike, screw spikes A into the bottom of the TrLS50. Proceed to Figure 4.
Hardscape Mounting
For hard surface mounting with TrLS50-Hardscape, install the hardscape pan C with appropriate anchors for the substrate. Speaker wires must be pulled through the center hole prior to installation. Any of the three mounting holes can be designated as the front of the speaker. Proceed to Figure 4.
Burial Mounting with Inground
For burial mounting with TrLS50-Inground, begin by assembling the burial
hardware. Screw the three threaded rods H into the burial plate E.
Place the hardscape pan C onto the threaded rods and secure it with three nuts
G and three washers F. Tighten the hardware.
Pull any wiring through the center hole of the hardscape pan and bury the unit
in the ground, backfilling with the material until only the hardscape pan is
above the surface.
Making the Connection
If
necessary, trim excess cable both on the speaker and input side. Strip the
individual wires and use the waterproof connector B to connect the speaker and
lighting (if a -Halo model), and daisy-chain to the next speaker (if
applicable).
Complete the Installation
For TrLS50-Spike, hide the connectors under the
speaker and press the spikes into the ground. For TrLS50-Hardscape or
-Inground, tuck the connectors between the speaker and hardscape pan and
attach the speaker using three button head screws D.
For assistance call 888-213-5015 or visit www.leonspeakers.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>