PARROT PRODUCTS IC1000 OPS PC User Manual
- May 15, 2024
- PARROT PRODUCTS
Table of Contents
PARROT PRODUCTS IC1000 OPS PC
Product Information
Specifications:
- Product Name: Parrot OPS PC – IC1000
- Components: 1 x OPS PC Module, 2 x Wi-Fi / BT Antenna
- Connectivity: Wi-Fi, Bluetooth, USB Type C, DisplayPort, HDMI, USB 3.0, LAN
- Indicator: Power, Line Out, Reset/Restore
Product Usage Instructions
Install OPS PC Module:
- Disconnect the display from mains power.
- Insert the OPS into the OPS slot ensuring the arrow labelled ‘front’ points to the front of the display.
- Align the vent holes of the OPS PC with those of the display.
- Reconnect mains power to the display.
- If the display does not automatically restart, manually turn on both the display and OPS PC.
- Select OPS/PC as the input source on the display.
CAUTION: Incorrect insertion can result in damage to the OPS PC or display. Always disconnect power before inserting or removing the OPS.
Most displays provide LAN connectivity to the OPS PC if there is an existing LAN connection to the display.
Connectivity Panel:
- Wi-Fi Antenna x2
- Mic
- USB Type C
- DisplayPort (DP)
- Indicator Power Line Out
- HDMI
- USB 3.0 x6
- LAN
- Reset/Restore
FAQ
- Q: What should I do if the OPS PC does not power on after installation?
- A: Check the power connection and ensure both the display and OPS PC are powered on. If needed, manually turn on both devices.
- Q: Can I remove the OPS PC while the display is powered on?
- A: No, always disconnect the power before inserting or removing the OPS PC to avoid damage.
- Q: How do I switch between Wi-Fi and Bluetooth connectivity?
- A: The OPS PC automatically switches between Wi-Fi and Bluetooth based on the connected devices. No manual switching is required.
Packing Checklist
Install OPS PC Module
STEPS
- Disconnect the display from main power.
- Insert the OPS into the OPS slot. Make sure the arrow labelled ‘front’ points to the front of the display. In this orientation, the vent holes of the OPS PC is facing vent holes of the display.
- Reconnect the main power to the display.
- If the display doesn’t automatically restart after reconnecting the power, turn on both the display and OPS PC manually. Look for the icon on the OPS PC.
- Select OPS/PC as the input source on the display.
- For both inserting and removing the OPS, make sure to disconnect the power before doing so. (See step 1)
- Most displays provide the OPS PC with LAN if there is an existing LAN connection to the display.
Connectivity Panel
- Tel: (RSA) 010 140 4900
- Email: [email protected]
- www.parrot.co.za
Read User Manual Online (PDF format)
Loading......