Cinlinso ZETX10U01A 60W 10 Port USB Charging Station User Guide
- May 15, 2024
- Cinlinso
Table of Contents
Cinlinso ZETX10U01A 60W 10 Port USB Charging Station
Instructions
- Plug the charger to the 100V-240Vpower supply.
- Connect your devices to the charger by USB charging cable.
Feature of Product
- Built-in intelligent control chip, with over-heated over-voltage,short circuit, over-charging and over- load protection.
- Compact size and space-saving design,Keepping your smart phone, tablet and other devices organize on your desktop or counter. 150 cm power cable makes it charging friendly, anti-slip mats makes it steadily
- Support 10 devices charged at the same time, each port intelligently identifies your device and seeks a maximize its charge speed.
- Board compatibility and wide use, works with most of mobile phones,tablets as well as other USB charging supported devices.
Specification
| Model | ZETX10U01A YFY-A80 |
|---|---|
| Material | ABS Fireproof Material |
| Input Voltage | 100V-240V,50Hz/60Hz |
| Output | DC60W (total) |
| Interface | USB A*10 |
| Color | Black/ White |
| Power Cabile | 150cm |
Attention
- Before using please read user guider and surfacemark of charger camaged
- Don’t open or modified the charger to prevent the charger damaged.
- Don’t use your wet hand to touch the charger it will be automatic cut off if touch water or other liquid.
- Don’t get wet in the rain or be affected with damp, to prevent short-circuit.
- Must put your devices and charger at 10-55 degree and ventilated place when charging.
- To be safe please put the charger on the safe place that children can’t touch
Keep away from Fire&Water&Child
Warranty
we offer 12 months warranty.
This product is electronic products, the internal componets vulnerable to
shell protetion.At the same time components fear that heat, water and dust.
Please note the below cases are not in the scope on free warranty.
- Careless collision, drop caused by damaged of components.
- Water splashed into the shell, water flooded, rain damaged components.
- Used in exposure under the sun (more than 40 degrees), to damage the inside components.
- Dust accumulated too much to damage of components.
- The appearance of wear and tear scratches or other damage.
- Offline after the damage caused by force majeure(flood, fire,lightning, and earthquakes)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>