TYPE S LM58285 TERRA PRO 2 Inch Flush Mount Flood Spot Light Instruction Manual

LM58285 TERRA PRO 2 Inch Flush Mount Flood Spot Light
Instruction Manual

Important, retain for future reference:
Read carefully

WARNINGS

IMPORTANT SAFETY INSTRUCTIONS

1. SAVE THESE INSTRUCTIONS– This manual contains important safety and operating instructions.
2. Before using this product, read all instructions and cautionary markings.
3. Do not expose the bare wires to rain, moisture, or snow.
4. Use of an attachment not recommended or sold by the manufacturer may result in a risk of fire, electric shock, or injury to persons.
5. Do not operate with damaged Spot Light – replace it immediately.
6. Do not operate Spot Light if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified service person.
7. Do not disassemble Spot Light; take it to a qualified serviceperson when service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire.
8. To reduce the risk of electric shock, unplug Spot Light before attempting any maintenance or cleaning. Turning off controls will not reduce this risk.

CAUTIONS

Check your state or provincial laws before installing. The vehicle owner must comply with all applicable laws. This product is intended solely for off-road purposes. The manufacturer and seller assume no liability for installation or use, which are solely the responsibility of the purchaser. This product is not DOT approved and is designed and intended for off-road uses only.

1. Do not install or use the product if it, in any way, impairs the safe operation of your vehicle.

2. Follow the manufacturer’s instructions to ensure the product is properly and safely installed.

3. Check your state or provincial laws before installing. The vehicle owner must comply with all applicable laws.

4. This product is intended solely for off-road purposes.
   Manufacturer and Seller assume no liability for installation or use, which are solely the responsibility of the purchaser.

5. This product is not DOT approved and is designed and intended for off-road uses only.

6. The Manufacturer and Seller are not responsible or liable for consequential, incidental, or indirect damages, whether to person or property, resulting from the installation or improper use of this product.

WARNING: This product can expose you to chemicals including DEHP and DINP, which are known to the State of California to cause cancer and birth defects or other reproductive harm.
For more information go to www.P65Warnings.ca.gov.

SPECIFICATIONS

Wire connection

Black wire (-) negative, ground connection.
Red wire (+) positive, driving light.
Fuse light at the power source.
Use 16-14 gauge wire.

PACKAGE INCLUDES

TOOLS NEEDED (NOT INCLUDED)

ECOMMENDED MOUNTING POSITIONS

INSTALLATION

1. Before installation, inspect the light to ensure that it is functioning properly. Simply connect the RED power wire to the Positive (+) terminal and then connect the BLACK  wire to the Negative (-) terminal.

2. Use the provided Measuring Template as a guide. Drill 4 holes with a 6.5mm Drill Bit. Cut out a flush mount housing on your bumper.
   Make sure there is enough space beneath the bumper surface to fit in the Flood / Spot Light, and nothing beneath will be damaged after the holes are drilled.

3. Flush mount the Flood / Spot Light and secure it with the provided hardware.

Inserting the Flood Beam Lens:

a. Loosen the Front Screws with the 2.5mm Allen Key.| c. Insert the Flood Beam Lens.
---|---
b. Remove the Front Screws and Mountings.| d. Reinstall the Mountings and tighten the Front Screws.

WARRANTY

TYPE S
LIMITED WARRANTY
TYPE S warrants, to the original purchaser, that its products are free from defects in material and workmanship for 1 year from the date of original purchase. Where permitted by law, TYPE S’s liability shall be limited to that set forth in this limited express warranty. This limited express warranty shall be the exclusive remedy of the purchaser and  TYPE S makes no other warranty of any kind aside from the limited express warranty stated above.
NOTE: Warranty only applies for North American customers of purchases made in North America.

CONDITIONS OF WARRANTY
If during the 1 year warranty period your new product is found to be defective, TYPE S will repair such defect, or replace the product, without charge for parts or labor subject  to the following conditions:
1. All repairs must be performed by TYPE S.
2. All warranty claims must be accompanied by a copy of the sales receipt or bill of sale.
3. The equipment must not have been altered or damaged through negligence, accident, improper operation, or failure to follow the product instructions for installation, use, or care.
4. The replacement of parts is excluded from the warranty when replacement is necessary due to normal wear and tear.
5. Repair or replacement parts supplied by TYPE S under this warranty are protected only for the unexpired portion of the original warranty.
6. This is a “repair or replace” warranty only, and does not cover the costs incurred for the installation, removal, or reinstallation of the product, or damage to any mobile phone, electronic device, or vehicle.

OWNER’S RESPONSIBILITIES:
TYPE S will make every effort to provide warranty service within a reasonable period of time. SHOULD YOU HAVE ANY QUESTIONS ABOUT SERVICE RECEIVED  OR IF YOU WOULD LIKE ASSISTANCE IN OBTAINING SERVICE, PLEASE CALL TOLL FREE 1.866.294.9244 DURING REGULAR BUSINESS HOURS,  MONDAY THROUGH FRIDAY 8:00 AM TO 5:00 PM (Pacific Standard Time). For customer service and technical support, please call us at 1.866.294.9244 or email us at info@typesauto.com. If at that time it is determined that a replacement unit is needed, the support representative will issue a Return Authorization and instruct on how to get a  new unit. TYPE S makes no other warranty of any kind aside from the limited express warranty stated herein.

DISCLAIMER OF WARRANTIES, INCLUDING WARRANTY OF MERCHANTABILITY AND WARRANTY OF FITNESS FOR PARTICULAR  PURPOSE: EXCEPT AS SPECIFICALLY SET FORTH HEREIN, NO WARRANTY OR REPRESENTATION, EXPRESS OR IMPLIED, IS MADE AS TO  THE SPOTLIGHT. TYPE S AND/OR ITS AFFILIATES EXPRESSLY DISCLAIM, WITHOUT LIMITATION, ANY STATUTORY WARRANTIES AND  ALL IMPLIED WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

TYPE S and/or its affiliates are not responsible for a user’s intended or actual use of the Spot Light. In no event shall TYPE S and/or its affiliates have any liability for any losses (whether direct or indirect, in contract, tort, or otherwise) incurred in connection with the Spot Light, including but not limited to damaged property, personal injury and/or loss of life. Neither shall TYPE S and/or its affiliates have any liability for any decision or action taken based on relying on the stability or performance of the Spot Light.  TYPE S and/or its affiliates, the manufacturer, distributor, and seller shall not be liable for any injury, loss, or damage, incidental or consequential, arising out of the use or intended use of the product.

Terra Pro™ 2” Flush Mount Flood / Spot Light
LM58285
Responsible Party:
TYPE S
2975 Red Hill Ave., Ste. 100, Costa Mesa,
CA 92626, U.S.A.
Tel: 1.866.294.9244

A Horizon Brands Company
2975 Red Hill Ave., Ste. 100, Costa Mesa,
CA 92626, U.S.A.
1.866.294.9244 | info@typesauto.com
©2021 TYPE S. All rights reserved.
www.typesauto.com

CONNECT WITH US

Made in China

References

• P65Warnings.ca.gov
• TYPE S Auto

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>