Antec NX416L Fan Controller Instruction Manual
- May 15, 2024
- Antec
Table of Contents
NX41BL FAN MANUAL
NX416L Fan Controller
Figure 1
120mm x 1 (Installed at the rear)
| A: 3-Pin Fan
Header
For fan speed
---|---
| B: 3-Pin ARGB
Signal Header
Connect to motherboard or fan controller.
Can be in sync with the ARGB lighting
Figure 2
160mm x 2 (Installed at the front)
| A: 3-Pin Fan
Header
For fan speed
---|---
| B: 3-Pin ARGB
Signal Header
Connect to motherboard or fan controller.
Can be in sync with the ARGB lighting
Figure 3
Fan Controller
| C: ARGB 3-Pin Header
ARGBfemale
---|---
| D: Fan Header
Case fan connector
| E: LED Control 2-Pin Header
LED Control female
| F: SATA Connector
Power connector
| G : 3-Pin ARGB Signal Header
Connect it to the motherboard.
Can be in sync with the motherboard
| H : 4-Pin Fan Connector
Connect to motherboard fan header for PWM function
FAN INSTALLATION
- Please make sure A (Figure 1&2) and D (Figure 3) are connected.
- Please make sure B (Figure 1&2) and C (Figure 3) are connected.
- Please make sure E (Figure 3) is connected to the Reset (LED) switch of the 1/0 panel.
- Connect F (Figure 3) to power supply SATA header to power it on.
- Connect H (Figure 3) to motherboard fan header to control fan speed.
- Press the LED button on the I/O panel to switch the lighting modes.
- For ARGB Lighting working in sync with other components, please connect G (Figure 3) to 3-pin motherboard ARGB header and press the LED button on the I/O panel for 3 seconds to switch to the motherboard synchronization mode.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>