DA-LITE 10101484 Extensa 84 Inch Electric Projector Screen Instruction Manual

: May 15, 2024
: Da-Lite

Table of Contents

DA-LITE 10101484 Extensa 84 Inch Electric Projector Screen
Included Hardware
Optional Hardware (on request)
Installation
CEILING MOUNTED (included)
Read User Manual Online (PDF format)
Download This Manual (PDF format)

DA-LITE 10101484 Extensa 84 Inch Electric Projector Screen

Included Hardware

Optional Hardware (on request)

Bracket weight distribution
Please make sure the structure and mounting materials used are capable of carrying the weight of the screen. For safety please ensure each bracket can carry the full screen-weight. See chart for reference.

Instructions for Use
Please see the ‘Instructions for Use’ for detailed instructions for the wiring diagram and how to connect, operate and maintain this projection screen.

Installation

WALL MOUNTED (optional)

Define the position of the screen case on the wall. Position wall brackets (C) within 10 to 100 cm of either end of the case and one approximately in the middle (case length /2 +/- 50 cm).
Move the sliding brackets on top of the case to match the exact positions of the 3 brackets on the wall.
Raise the screen case to the height of the wall brackets. Make sure the sliding brackets on top of the case align with the wall brackets.
When the sliding bracket on the case and the wall bracket align, take the security bolt (C) and screw it in place.
Tighten the security bolt on all 3 brackets until the case is fully secured.
Please note! Remove transport-safety brackets from the slat bar before operating the screen.

CEILING MOUNTED (included)

Define the position of the screen case on the ceiling.
Position 2 ceiling brackets (A) within 10 to 100 cm of either end of the case and one approximately in the middle (case length /2 +/- 50 cm).
Move the sliding brackets on top of the case to match the exact positions of the 3 brackets on the ceiling.
Raise the screen case to the height of the ceiling brackets.
Make sure the sliding brackets on top of the case align with the ceiling brackets.
When the sliding bracket on the case and the ceiling bracket align, take the security bolt (B) and screw it in place.
Tighten the security bolt on all 3 brackets until the case is fully secured.
Please note! Remove transport-safety brackets from the slatbar before operating the screen.