EZBREZ YM-803 Wearable Hands Free Breast Pump User Manual

EZBREZ YM-803 Wearable Hands Free Breast Pump

Product View

2pcs in a box

Designed By Mothers. For Mothers.

Congratulations on being a mother! If this is your first experience with a breast pump, it may take you some time familiarize with its usage.

It is important for you to relax during the process even if you may not be able to express as much milk as you would like to at the start. Your body will adapt accordingly so that after several attempts, you will be able to express more milk.

Before Using Instruction

PLEASE READ BEFORE USE

• Please limit the usage to not more than 15 minutes at a time. It is perfectly normal when not much milk is expressed within this period at first but with regularly usage, your body will eventually adapt to produce more milk.
• Research have shown that to achieve optimum breast milk production, you should be in a totally relaxed state. It helps you release the hormone oxytocin that stimulates your let-down reflex for milk ejection. So, sit back on your favourite couch while listening to your favourite tunes, try deep breathing exercises or get your partner to give you a massage!
• The device comes with a massage function that you may use (1 – 3 mins) before pumping. This allows you to release the hormone oxytocin and increase milk production.
• Clean regularly. Clean any pump parts that have been in contact with your breast milk and wash your hands before and after use.
• Choose the right optimum suction level. Gradually increase the breast pump suction until it becomes slightly uncomfortable, and then turn it down a notch. The pump will resume from the last used suction level when restarted.
• Since this is a wearable breast pump, please ensure that you use a proper breast shield.

PRODUCT DESCRIPTION

Accessories include

CONTROL PANEL

Follow the principle of massage first, then deep pumping.

3 Modes

Massage function: 9 levels
(Massage first to stimulate milk production.)

Suction function: 9 levels
(Please choose the optimum level, the pumping mode is designed for slow suction, deep suction.)

Nipple correction: 3 levels
( Massage and suction used simultaneously which is excellent for sunken nipples or first-time new mother, open milk adopts 3+1 mode, 3 short-frequency massages and 1 deep suction.)
Turn on/off: Press and hold the power button for 3 seconds.
Mode Change: Press the mode key .
Level change: Press the and to increase or decrease level.

Battery Indicator and Milk Alarm

Flash Red: Low battery (require charging)
Solid Green: Battery is fully charged (Flash green while charging)
Milk Warning: The alarm will flash red last for 30 seconds and make a beep sound(beep beep beep 5 times and last for 4 seconds) every 10 mins to remind it’s time to take out the milk collector and pour out the milk. The pump will auto off every 30 mins.

CLEANING INSTRUCTIONS

Before Use

1. Remove the pump motor.
2. Place all the silicone parts in boiling water for 3 to 5 minutes.
3. Wash the milk collector and Linker with warm soapy water and rinse well.
4. Wipe down the parts with cloth or air dry before use.

After Use

1. Rinse the milk collector, valve and Linker immediately after use.
2. Place all the silicone parts in boiling water for 3 to 5 minutes. 3 Wipe down the parts with cloth or air dry before storage.
3. Do not submerge pump motor in water.

ASSEMBLY

STEP 1
Put the silicone gas cup into the linker, and press it with your hands to make the edges fasten tightly to ensure a perfect seal.

STEP 2
Install the valve into the bottom of the linker, make sure it is installed in the correct direction.

STEP 3
Put the assembled linker into the milk collector.

STEP 4
Place the silicone massage petal into the milk collector and ensure it is sealed properly to prevent leakages.

STEP 5
Install the pump motor.

DIRECTION FOR USE

Press the silicone massage petal firmly against the breast, leave no gaps and make sure your nipples are centered. Keep it upright. Be careful not to distort the position of the product and the chest, otherwise the breast pump will not have suction.

Note: Do not Lie down while using the breast pump. If you feel any discomfort while expressing or notice blisters or chafing on your nipple or breast, try reducing the breast pump suction level.

SITTING POSITION FOR SUCTION

Relax the body, sit in a comfortable chair and lean slightly forward ( use cushion to support back). Make sure to keep the breast pump and milk collector upright.

POUR MILK

Please keep breast pump upright, and remove the pump motor from pump body carefully. To pour the milk into the bottle, make sure the gap of milk collector is against the bottle mouth.

INSTRUCTIONS FOR BRA ADJUSTING BUCKLE

Adjust the length of bra straps, make suction more comfortable. One end of the bra adjustment buckle hung on the inside buckle of nursing bra. The length of the bra strap can be adjusted by hanging the nursing bra buckle on the other end of the bra adjustment buckle.

TROUBLESHOOTING

Weak or No suction|

1. Check that the valve is properly installed.
2. Charge the device before use.
3. Check that the product is placed correctly, otherwise the breast pump will not have suction.

---|---
Nipple pain|

1. Massage first and adjust the comfortable suction level.
2. Seek a lactation consultant or breastfeeding specialist for advice.

No / little milk expressed|

1. No / little milk expressed
2. If you’ve been pumping for 10-15 minutes, take a break and try again at the right time.
3. Ensure optimum suction level during use.
4. Relax and try again.

Note: Please feel free to contact us if you have any product related questions.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>