BENEHIKE BH-SK2725-130 270° Freestanding Batwing Awning User Manual
- May 15, 2024
- BENEHIKE
Table of Contents
BENEHIKE®
270° AWNING
USER MANUAL
Please read this manual carefully before installation, and retain it for future reference.
IMPORTANT INFORMATION
BENEHIKE® is not liable for damage or accidents resulting from non-observance
of the instructions, changes to parts, or the use of parts other than
BENEHIKE®’s original parts. The warnings, safety and operating instructions in
this manual cannot cover every imaginable situation, so it is the user’s
responsibility to exercise common sense and caution. It is your responsibility
to pass these instructions on to third parties using this rooftop tent,
including second-hand sales.
WARNINGS AND SAFETY INSTRUCTIONS
Rooftop Tent:
- Before installing the BENEHIKE° rooftop tent, ALWAYS refer to your vehicle and roof rack manuals and ensure that you are following their instructions and It is recommended to carry your vehicle manual, roof rack manual and the user manual of this rooftop tent in your vehicle.
- BENEHIKE° recommends that you should NOT transport your rooftop tent over 100kmh and that you adhere to speed limits.
- With the BENEHIKE° rooftop tent, you should measure the overall height of your vehicle with the tent fitted as you will need this information to decide if the vehicle can enter carparks, etc.
- The attachment of the rooftop tent to your vehicle will alter its centre of Adjust your driving accordingly.
- At the beginning and at regular intervals during each trip, please check that your tent is firmly installed by ensuring all nuts and bolts and all accessories are safely ALWAYS check your tent is in a safe and appropriate place.
- ONLY open and close the rooftop tent when the vehicle is parked and ALWAYS ensure the tent is dry prior to closing. If this isn’t possible, open immediately when you arrive at your home or next destination. Storing a wet tent can lead to the formation of mold & mildew. It is recommended to store your tent indoors if its not going to be used for a long time. When storing indoors, be sure to place the tent on a padded surface and away from heavy loads and debris.
- Ensure that the roof rack or roof bars can support the full weight of the rooftop tent while in Ensure the rooftop tent’s weight is centred over the middle of the vehicle and its sides are not over hanging the vehicle.
- DO NOT use your rooftop tent if there is any visible damage to any part or its components, instead contact BENEHIKE° to see how we can help.
- Incorrectly mounted roof racks, rooftop tent or cross bars can come loose during travel and cause serious
- Make sure you give due consideration to the change in your vehicle height and driving behavior (e.g. wind sensitivity, corner and braking behavior) to accommodate the change in vehicle
- NEVER force any of the components which could result in damage when opening and closing the tent. Metal components may need to be cleaned with a brush or soft cloth to ensure proper operation.
- DO NOT use cleaning fluids containing bleach, alcohol or ammonia or any other chemicals that would otherwise damage your tent.
- DO NOT drill holes in the ladder. This will weaken the structure of the ladder and can cause injury.
- NEVER leave the tent open for a long time where insects, rodents, or moisture could occur, and regularly inspect your tent for damage and check hardware for signs of rust.
- Keep children away from a stored tent, and ensure it can’t be tipped over accidentally.
- Be aware of low entrances, low hanging branches, and other hazards that could damage your roof top tent or vehicle.
- When washing your vehicle, your rooftop tent must be removed first.
- For reasons of fuel economy and the safety of other road users, your roof tent and roof rack should be removed when not in use.
- Keep ALL flame and heat sources away from the tent. Under NO circumstance should ANY naked flame sources or heating devices be used inside the tent.
- Keep a look out for ANY airborne burning embers that may come into contact with the tent. Keep a fire extinguisher or water bucket nearby.
- DO NOT smoke within the tent.
- Keep EXIT clear.
PARTS LIST
Item| Description| Qty|
---|---|---|---
1| Metric Wrench 10/13 mm| 2|
2| Double wholes washer| 2|
| 20mm Stainless Steel M8 Bolt| 4|
4| 55mm Stainless Steel M8 Bolt| 4|
5| M8 Self-Locking Nut| 8|
| String| 3|
7| Tent pegs| 3|
OPERATING INSTRUCTIONS
Locating Tent on your Vehicle
Step 1:
Peel the Velcro PVC cover back at each end of the awning to expose the backing
plate tracks. Insert the boltsheads into the backing plate tracks, then
reattach the PVC covers.
Step 2:
Position and attach the brackets in the required position using the provided
nuts and washers, then tighten.
Step 3:
Mount to the vehicle using the provided U-bolts, nuts and washers.
NOTE:
lt is recommended that the awning is assembled and installed by two (2)
people. We further recommend having theawning installed by experienced 4×4
accessory installer.The awning brackets supplied have been designed to fit the
most common configurations of roof racks and railsystems.
However, due to the ever-increasing variations being offered by vehicle and
accessory manufacturers, wecannot guarantee that these will fit all available
options.
It is recommended that you speak to your roof rackspecialist for further
advise or recommendations on thebest system for your requirements.
Ensure that the minimum spacing between themounting brackets is to be 47”
(1200mm) to allow theawning to be supported correctly and the weight
isdistributed evenly.
OPERATING INSTRUCTIONS
- Open the zipper and flip the bag off the hinge.
- Undo the three Velcro straps and grab all the tent crossbar ends and lift out of the tent
- Grab the upper arm straps and pull on them as you walk to the rear of the vehicle.
- Clip the straps to the track at the back of the vehicle. Pull the loose end of the straps away from the cam buckle to fighten the straps.
CARE AND MAINTENANCE
The BENEHIKE® rooftop tent is designed to be a reliable companion on your adventures. In order to keep it performing at its best, BENEHIKE® recommends some care and maintenance steps that will help prolong its life. Prior to each use, inspect your rooftop tent mounting hardware. If necessary, clean with wet cloth. Dry your rooftop tent thoroughly before you close it. If unable to properly dry your rooftop tent prior to closing, open it up and air dry it at your next opportunity. Failure to properly dry your tent out can lead to the growth of mold and mildew which can degrade the tent material, cause discoloration, and foul odor. Mold and mildew growth is not covered under your rooftop tent warranty. To clean your rooftop tent use with cold water and a sponge. DO NOT use soap or detergent. Rinse with a clean wet sponge and allow to thoroughly dry. DO NOT expose to petrol, oil or solvents.
STORAGE AND HANDLING
Ensure it is fully dry prior to storage and store in a cool dry location free
from sunlight. Zippers should be pulled with even force and ina gentle manner.
Keep your zippers free from dust and dirt and periodically apply non-scented
bees wax to the zipper teeth as lubrication.
This will prolong the life of your zippers. Ladder should be wiped free of any
dirt or dust prior to collapsing the tent. Keep your mattress dry and free
from dirt. Prior to closing your rooftop tent lift your mattress and ensure
the underside is dry. Remove mattress and air dry if necessary. To clean
mattress cover, remove cover and machine wash gentle cycle. Hang dry, DO NOT
TUMBLE DRY. You should ALWAYS wipe your ladder free of any dust or dirt prior
to collapsing it for storage. Failure to do so can result in debris contacting
your tent which can lead to damage to your tent fabric.
WARRANTY
BENEHIKE® (“Manufacturer”) warrants, to the original purchaser (“User”) that its rooftop tent, if purchased from manufacturer or an authorized distributor or dealer, will be free of defects in material and/or workmanship under normal usage from the date sold and for the duration (the “Warranty Period”) of 2 YEARS. This warranty shall ONLY be effective for the original purchaser and apply ONLY to the BENEHIKE® rooftop tent that is correctly installed on the vehicle for which it is intended. BENEHIKE® will either replace the product or provide you with a refund at our discretion provided that the fault is found to have been caused by a design or manufacturing defect that results in its failure to perform correctly as described. The limited warranty is the only one that applies to this product, and it sets forth all the responsibilities of BENEHIKE®
EXCLUSIONS
This warranty does not cover defects, failure or damage caused by incorrect installation, intentional damage, misuse or abuse. It is recommended that the installation should be performed by suitably qualified technicians or the warranty will be voided. For further clarity, this warranty is also void if the rooftop tent: is repaired, altered or modified carried out by anyone other than BENEHIKE®, or without BENEHIKE®’s authorization, is damaged by mold and mildew as the tent is not properly dried prior to closing, is damaged by extreme weather (e.g. storm, hail or strong wind), extreme temperature, accidents, negligence, daily wear and tear, incorrect setup, or failure to check the condition of tent before each use, is damaged by UV degradation or acid rain to the tent/awning and its components, is damaged from improper storage, or a failure to provide routine maintenance, is used on permanent sites or commercial displays.
CLAIMS
If a BENEHIKE® product is suspected of being defective, you’ll need to provide proof of purchase (e.g. a screenshot of the order) and a picture and a video of the damaged goods in their entirety to service@benehike.com or +1 951-691-3943. If the product is found to be defective and covered by this limited warranty, the remedy is replacement or refund, at BENEHIKE®’s option. No charges will be accepted fo r external labour or materials.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>