DLLI8I8O Dry Contact Interface and LED Driver Installation Guide
- May 15, 2024
- DLLI8I8O
Table of Contents
Dry Contact Interface and LED Driver
Installation Guide
DLLI8I8O
Dry Contact Interface
and LED driver
Installation Instructions
Devices must be installed by a qualified electrician in accordance with all national and local electrical and construction codes and regulations.
Federal Communications Commission (FCC) Compliance Notice: Radio Frequency
Notice – This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures: Reorient or
relocate the receiving antenna. Increase the separation between the equipment
and receiver. Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected. Consult the dealer or an
experienced radio/TV technician for help. Any modifications not approved by
the manufacturer of this device could void the user’s authority to operate
this device.
Installation of a home and building automation and control system shall comply
with IEC 60364 (all parts). The temperature limits and current-carrying
capacities for the communication wires specified in IEC 60364-5-52 shall not
be exceeded.
This Class B digital apparatus complies with Canadian ICES-003: CAN
ICES-3(B)/NMB-3(B). Cet appareil numerique de la Classe B est conforme a la
norme NMB-003 du Canada: CAN ICES-3(B)/NMB-3(B).
Do not connect inputs to mains.
© 2023 Signify Holding. All rights reserved. Specifications are subject to
change without notice. No representation or warranty as to the accuracy or
completeness of the information included herein is given and any liability for
any action in reliance thereon is disclaimed. Philips and the Philips Shield
Emblem are registered trademarks of Koninklijke Philips N.V. All other
trademarks are owned by Signify Holding or their respective owners.
AZZ 420 0823 R20
www.dynalite.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>