Whirlpool YWED5010LW Electric and Gas Dryers User Guide
- May 15, 2024
- Whirlpool
Table of Contents
Whirlpool YWED5010LW Electric and Gas Dryers
Specifications
- Fuel Type: Electric / Gas
- Minimum Circuit Amperage Rating: 30A (Electric) / 15A (Gas)
- Maximum AMP Draw: 26A (Electric) / 6A (Gas)
- Operating Voltage: 120/240V AC only (Electric) / 120V AC only (Gas)
- Current Canada Rating: 24A (Electric) / N/A (Gas)
- Operating Frequency: 60Hz
Product Usage Instructions
Electrical Requirements
- Make sure to connect the dryer to a properly grounded electrical outlet with the recommended circuit amperage rating.
- Refer to the installation instructions for detailed electrical requirements.
Gas Connection
For gas dryers, ensure the gas connection is securely in place and follow all safety guidelines for gas appliance installation.
FAQS
- Q: What is the recommended clearance around the dryer?
- A: It is recommended to have additional spacing of 1 inch (25 mm) on all sides of the dryer to reduce noise transfer and ensure proper ventilation.
- Q: Can this dryer be installed in a closet?
- A: Yes, the dryer can be installed in a closet with proper ventilation openings at the top and bottom of the door. Louvered doors with equivalent ventilation openings are acceptable.
DIMENSIONS
DETAILED PLANNING DIMENSIONS
WARNING: To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS and INSTALLATION INSTRUCTIONS, located in your appliance’s Owner’s Manual, before installing and operating this appliance.
Electrical Requirements
Fuel Type| Electric| Gas
Minimum Circuit Amperage Rating| 30 A| 15 A
Maximum AMP Draw| 26 A| 6 A
Operating Voltage| 120/240 V – AC only| 120 V – AC only
Current Canada Rating| 24 A| N/A
Operating Frequency| 60 Hz
Product Dimensions
| in| mm
A| Height (With leveling legs not extended)| 401∕2| 1028
B| Width| 29| 737
C| Top Height (with min. feet)| 367∕8| 937
D| Depth| 283∕8| 722
E| Top Height (With leveling legs fully extended)| 381∕2| 978
F| Height (With leveling legs fully extended)| 421∕8| 1069
G| Depth with Door Open| 5011∕16| 1288
DETAILED PLANNING DIMENSIONS
Product Dimensions
| in| mm
H| Strain Relief from Side (elec)| 153∕4| 400
I| Strain Relief Height (elec) (With leveling legs not extended)| 281∕8|
714
J| Exhaust Duct from Side| 147∕16| 366
K| Power Cord from Side (gas)| 143∕4| 375
L| Power Cord Height (gas)| 323∕8| 822
M| Gas Connection (With leveling legs not extended)| 111∕16| 43
N| Gas Connection from Side| 93∕16| 234
O| Strain Relief Height (elec) (With leveling legs fully extended)|
293∕4| 755
P| Exhaust Duct Height (With leveling legs fully extended)| 611∕16| 170
Q| Gas Connection (With leveling legs fully extended)| 3 5∕16| 84
R| Exhaust Duct Height (With leveling legs not extended)| 51∕16| 128
S| Water Inlet Height (on steam models only)| 321∕8| 816
T| Water Inlet from Side (on steam models only)| 4| 101
| Gas Power Cord Length| 60| 1525
| Power Cord Length (Canadian)| 523∕8| 1330
Spacing for a recessed area or closet installation
The dimensions shown are for the recommended spacing allowed.
- Additional spacing should be considered for ease of installation and servicing.
- Additional clearances might be required for wall, door, and floor moldings.
- Additional spacing of 1″ (25 mm) on all sides of the dryer is recommended to reduce noise transfer.
- For closet installation, with a door, minimum ventilation openings at the top and bottom of the door are required. Louvered doors with equivalent ventilation openings are acceptable.
- Companion appliance spacing should also be considered.
®/TM ©2023 Whirlpool. All rights reserved. Used under license in Canada.
Tous droits réservés. Emploi sous licence au Canada.
Todos los derechos reservados. Usado en Canadá bajo licencia.