Panasonic i-PRO camera User Manual
- May 15, 2024
- Panasonic
Table of Contents
**Panasonic i-PRO camera User Manual
**
The Installation Guide of this model is posted on the website linked from the
two-dimensional bar code on this carton box.
Please be sure to confirm it.
- Refer to the link from the two-dimensional barcode on the right for the operating instructions of the i-PRO camera and other related information.
https://i-pro.com/products_and_solutions/en/surveillance/documentation- database
This document describes important safety instructions. For further information, please refer to each manual available on the following website.
WARNING:
- Operation of this product in a residential environment could cause radio interference.
Caution:
- The DC power supply connected to the camera must be in the same building.
- The network camera is only intended for a connection to an ethernet or PoE network without routing to the outside plant.
- This product has no power switch. Be sure to install disconnect devices such as a circuit breaker to shut down the main power of power supplying equipment to this product.
- Only connect 12 V DC Class 2 power supply (UL 1310/CSA 223), limited power source (IEC/ EN/UL/ CSA 60950-1, IEC/EN/ UL/CSA 62368-1 Annex Q) or IEC/EN/UL/CSA 62368-1 PS2.
- Before attempting to connect or operate this product, please read these instructions carefully.
Notice:
- This product is not suitable for use in locations where children are likely to be present.
- Do not install this product in locations where ordinary persons can easily reach.
- This product is a professional equipment.
- For information about screws and other parts required for installation, refer to the corresponding section of this document.
Precautions
- In order to prevent harm to people and damage to property, it explains what must be observed without fail. The safety statements common to all i-PRO network camera models are posted on the website linked from the two-dimensional barcode on the right.
Please be sure to confirm it.
https://i-pro.com/products_and_solutions/en/surveillance/learning-and-support
/knowledge-base/safety-instructions
Do not install this product in a restricted or prohibited environment.
Failure to observe this may result in injury, accident, or malfunction due to
falling. Please check the safety precautions common to all models on the
website above and the installation precautions in the Installation Guide.
Install the product accurately and securely on an installation area in
accordance with the installation instructions.
Failure to observe this may cause injury or accidents.
Take measures of protection against this product falling.
Failure to observe this may cause a drop resulting in injury. Securely fix the
product to the installation surface using screws or anchors.
If the fall prevention wire is included, be sure to install it
Stop the operation immediately when something is wrong with this product.
When smoke goes up from the product, the smell of smoke comes from the
product, or the exterior of the product has deteriorated, continued use will
cause a fire or fall of the product resulting in injury, or damage to
property. In this case, turn the power off immediately and contact qualified
service personnel for service.
Conduct periodic inspections.
Rust on the metal parts or screws may cause a fall of the product resulting in
injury or accidents.
Consult the dealer for the inspections. Be sure to turn off the power before
inspection or maintenance.
Refer installation work to the dealer.
Installation work requires technique and experience. Failure to observe this
may cause fire, electric shock, injury, or damage to the product. Be sure to
consult the dealer.
Direct current symbol
Alternating current symbol
For indoor use only
Caution, infrared radiation
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>