MICROLOCK N30-4 Hybrid Jet Helmet Instruction Manual
- May 15, 2024
- MICROLOCK
Table of Contents
MICROLOCK N30-4 Hybrid Jet Helmet
“MICROLOCK1 ” RETENTION SYSTEM
Your new helmet is equipped with the exclusive “Microlock 1 ” retention system, which is one of the most comfortable and modern systems available today thanks to its micrometric regulation. In order to have the maximum protection and to appreciate the advantages of the “Microlock 1 ” system, carefully read the instructions contained in this label. Put your new on, making sure the size is correct {see enclosed instructions manual).
-
Attach the “Microlock 1 ” by inserting the dented tongue in the buckle (1).
Warning: Do not twist the strap; the dented part of the tongue must be facing the outside of the helmet.
Pull on the chin strap to make sure the locking mechanism is engaged. -
Press the dented tongue completely, until! you feel the strap press against your cheek.
Warning: The tongue should not move freely in the locking mechanism. -
Now try to take off your helmet by puling it from the back edge, rotating it towards the front; the helmet must remain well fixed on your head (see enclosed instructions).
-
If while performing step 3 you notice that the chin strap is too loose (this can be determined by insufficient pressure on the jaw when the dented tongue is fully inserted in the locking mechanism), then the strap must be pre-adjusted (shorten the chin strap).
If while performing step 3 you notice that the chin strap is too tight (this condition can be determined if the chin strap is too tight when the dented tongue is on the third or fourth click), then the chin strap must be lengthened. -
To make a pre-adjustment, release the helmet by lifting the red lever. Slip the helmet off (2).
Adjust the chin strap length by passing the strap through the metal adjusting buckle (3). -
Repeat steps 1 through 3 taking care that the dented tongue has effected at least 5 clicks into the body of the locking mechanism.
(We recommend performing the pre-adjustment by sliding the fastening flap by least 5 notches so as to make the most of the adjustment function of the “Microlock 1 ” system. By sliding or releasing the fastening flap by one notch as to the pre-adjustment, the system ensures the best comfort guarantying the fastening safety). -
WARNING!!! LIFT THE RED LEVER ONLY WHEN YOU ARE REMOVING YOUR HELMET! NEVER RELEASE THE LEVER WHILE DRIVING!
CARE OF “MICROLOCK 1 ” RETENTION SYSTEM
The effectiveness of the adjustment and retention system can be impaired by dust or sand. We suggest periodic cleaning of the “Microlock 1 ” retention system using only a solution of luke-warm water and neutral soap.
USE NOT SOLVENT, DO NOT LUBRICATE.
Manipulations or unusual events, which can compromise the working of the
retention system cannot be excluded.
If the “Microlock 1 ” system is not functioning properly discontinue the use
of the helmet.
CUSTOMER SUPPORT
www.nolan-helmets.com
CISG000000008 – 10. 2023 (Eletta)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>