FIOCCO B07YV28NSY Elevated Dog Bed Heavy Duty Dog Cot Instruction Manual
- May 15, 2024
- FIOCCO
Table of Contents
FIOCCO B07YV28NSY Elevated Dog Bed Heavy Duty Dog Cot
Product Information
- Specifications:
- Product Name: FIOCCO Elevated Dog Cot
- Dimensions: Leg (9.3′), various bar lengths and quantities as per instructions
- Materials: Metal bars, connectors, rubber foot covers, pet bed fabric
- Assembly Time: Approximately 20 minutes
- Tools Required: None
Product Usage Instructions
- Step 1 : Assemble Accessories
- Refer to the diagram and assemble the relevant accessories including bars, connectors, and rubber foot covers.
- Step 2: Assemble Product PartsFollow the arrows in Step 1 to assemble the AB rod, DE rod, and connectors.
- Step 3: Pass AB Rod
- Pass the AB rod through the corresponding hole as shown in the figure.
- Step 4 : Connect the AB Rod and Connector
- Connect the connector to the AB rod.
- Step 5: Connect C Rod
- Connect the C rod to the connector.
- Tip: Convenient assembly through vertical placement.
- Step 6-11:
- Connect DE Rod and C Rod
- Follow the steps to connect the DE rod to the connector and C rod. Tips are provided for easier assembly.
- Step 12-14: Final Assembly
- Connect the AB rod to both connectors, connect the C rod with connectors on both sides and use Velcro to secure for completion.
- Frequently Asked Questions (FAQ):
- Q: Are additional tools required for assembly?
- A: No additional tools are needed for assembling the FIOCCO Elevated Dog Cot.
- Q: How long does it take to set up the dog cot?
- A: The approximate time for setup is 20 minutes.
- Q: Any tips for easier assembly?
- A: Tips are provided throughout the installation instructions to facilitate smooth assembly, such as connecting one end of the rods first.
PARTS LIST
| Leg (9.3’) | 4 |
|---|---|
| Long side bar-A（17） | 2 |
| Long side bar-B（17） | 2 |
| Short side bar-C（14） | 6 |
| Rounded bar-D | 2 |
| Rounded bar-E | 2 |
| Connector | 4 |
| Connector-Middle | 4 |
| Rubber foot cover | 4 |
| Pet bed fabric | 1 |
NO ADDITIONAL TOOLS NEEDED
TIPS:
- If you have problems tightening/disassembling during installation, you can try rotating and pulling the bar at the same time to solve this problem.
- Pay attention to the connector, its length and width are the same length (there is no cylinder in the hole), and its height is longer (there are cylinders in the hole).
- Make sure that the Velcro is never closed during the installation process, otherwise you may encounter some trouble.
- Pay attention to the difference between bars， which need to be connected, we have sorted them for you(Bar A connect with Bar B, Bar D connect with Bar E).
INSTALLATION STEPS
- Assemble relevant accessories according to the diagram.
- Assemble the product parts according to the arrows in Step 1 to obtain the AB rod, DE rod, and connector.
- Tip： Convenient assembly through vertical placement.
- Tip： When connecting the DE rod, it can be achieved by installing the connector on one side and the DE rod, and then connecting the other side to facilitate assembly.
- Tips： To facilitate a better connection of AB, one end should be connected first, and then the other end.
- Tip： Convenient assembly through vertical placement.
Read User Manual Online (PDF format)
Loading......