Uhlmann Zacher CX2178 Electronic Double Knob Cylinder User Manual

Uhlmann Zacher CX2178 Electronic Double Knob Cylinder User Manual

Prepare door

Assemble the square pin

1. Insert the square onto the retaining pin and into the square holder.
2. Insert the spiral clamping pin into the square.
   

Installation

Slide latch into edge bore of the door. Check that the faceplate does not project outside door, but it should also not be installed sunk. Use washers(s) to adjust penetration depth of the latch.

1. Insert the square pin of the electronic door handle into the square nut of the lock. Insert the threaded bolts provided.
2. Insert the mechanical door handle from the other side and screw it along with the electronic door handle through the door panel.
   

Attach the covers of both the door handles by placing it on the holder and turning it.

Insert the locking screw from the bottom of the mechanical door handle and tighten it.

FCC Compliance Statement

This device (EDH420 – FCC ID : 2APV6-EDH420) complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2.  this device must accept any interference received, including interference that may cause undesired operation.

The Federal Communications Commission (FCC) warns the users that changes or modifications to the unit not expressly approved by the party responsible for compliance could void the user´s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Canadian Compliance Statement

This device (EDH420 – IC : 24382-EDH420) complies with Industry Canada´s license-exempt RSSs.

Operation is subject to the following two conditions

1. This device may not cause interference; and
2. This device must accept any interference, including interference that may cause undesired operation of the device.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>