SAMSUNG VCA-SAE90 Clean Station User Manual

June 4, 2024
Samsung

SAMSUNG logo

Clean station
User manual
**VCA-SAE90***

SAMSUNG VCA SAE90 Clean Station fig

VCA-SAE90 Clean Station

  • Before operating this unit, please read the instructions carefully.
  • For indoor use only

Product specifications

SAMSUNG VCA SAE90 Clean Station

Model VCA-SAE90*
Power 230 V, 50 Hz
Weight 5.6 kg
Size W 180 mm x D 185 mm x H 600 mm

NOTE

  • The wave pattern on the exterior of the product is a natural appearance due to the use of pearl plastic materials and its pearl distribution.

Accessories

| | |
---|---|---|---
Dust bag: 3 units (Inside the product:
1 unit / Spare: 2 units)| Power cord| Dustbin| User manual

NOTE

  • If you want to purchase an additional dust bag, check the model name (VCA-ADB90) and Samsung logo (SAMSUNG logo ) first and contact a Samsung Electronics retailer nearest you.

PREPARATION

Safety Information

The following contents are written for users’ safety and the prevention of property damage. Before using the product, please read this manual thoroughly and use the product correctly.
❇For safety reasons, people with physical, sensory difficulties, or mental disorders, lack of experience, and knowledge should not use this product without the supervision of their guardians.

Caution/Warning symbols used
WARNING
Indicates that a danger of death or serious injury exists.
CAUTION
Indicates that a risk of personal injury or material damage exists. Other symbols used
NOTE
Indicates that the following text contains additional important information.

Failure to meet these requirements could cause damage to the internal parts of the vacuum and void your warranty.

General

  • This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children should not play with the appliance. Children should not clean or perform maintenance on the product without adult supervision.

Installation

CAUTION

  • The clean station should be placed and used on a stable floor.
    – If the product falls over, an injury or product and floor damage may occur.

  • Do not place or use the product on an uneven floor, a carpet, a living room table, a desk, etc.
    – If the product falls over, an injury or product and floor damage may occur.

  • Do not place the product at a wall behind which pipes (gas or water etc.) or electrical cables are installed.

  • Do not install the product near water, in an area with excessive moisture, or near windows, etc.

  • Do not install the product in a place where people frequently pass by, near an entrance, or a narrow passage.
    – If people trip over the product, an injury or product damage may occur.

Power related

WARNING

  • Do not bend the power cord with excessive force or put heavy objects on the power cord.
    – Otherwise, electric shock or fire may occur.

  • If there is dust, water, etc. on the contact point of the power plug pins, wipe them carefully.
    – Otherwise, abnormal operation or electric shock may occur.

  • Do not pull the power cord and do not touch the power plug with wet hands.
    – Otherwise, electric shock or fire may occur.

  • Do not use a power source with the incorrect voltage. Do not use a multi-plug outlet or power strip for the product. Do not leave the power cord lying on the floor. Attach the cord close to a wall.
    – Otherwise, electric shock or fire may occur.

  • Do not use a damaged power plug, power cord, or loose power outlet.
    – Otherwise, electric shock or fire may occur.

  • If the power cord is damaged, have a Samsung authorized service center’s qualified repairman replace the power cord with a new power cord.
    – Otherwise, electric shock or fire may occur.

  • Except for an authorized repairman, do not disassemble or modify the clean station.

  • When using the product on a veranda, make sure the power cord and the power plug do not touch the water.

Operation
WARNING

  • Static electricity may occur depending on the humidity, temperature, floor material, etc. of your operating environment. If it happens repeatedly, contact a Samsung service center.

  • Do not cause a short circuit by touching the power terminal with chopsticks, metal screwdrivers, etc.
    – Otherwise, product malfunction or electric shock may occur.

  • Make sure that any liquid such as water or juice does not touch the inside or outside of the product.
    – Otherwise, electric shock or fire may occur.

  • The clean station is manufactured for Samsung Jet wireless vacuum cleaners only, so do not use the clean station for other purposes.

  • Do not use the product near heating appliances such as heaters, or in areas containing combustible sprays, or flammable materials.
    – Otherwise, fire or product deformation may occur.

  • If there is a gas leak, or a combustible spray is used such as a dust remover, do not touch the power outlet and open the window for ventilation.
    – Otherwise, an explosion or fire may occur.

  • If the product makes a strange sound or emits a smell or smoke, turn off the product immediately, and then contact a Samsung service center.
    – Otherwise, electric shock or fire may occur.

CAUTION

  • Do not allow children or a pet to ride on or play with the product.
    – If the product falls over, an injury or product and floor damage may occur.

  • When moving the product, you should grip it with both hands.

NOTE

  • When the dust bag of the clean station is filled with dust, the product may stop temporarily due to the overheating prevention device of the motor. Replace the dust bag and operate the product again.
  • As a new product, it may have a slight odor for the first 3 months after purchase.

Maintenance

WARNING

  • When cleaning the exterior of the product, unplug the product first and then wipe it with a dry towel. Do not spray water directly onto the product or wipe it with volatile materials such as benzene, thinner, or alcohol.
    – Otherwise, product damage such as plastic breakage, deformation, discoloration, printing deterioration, etc. may occur.

CAUTION

  • Do not push the clean station in case it falls over.
    – Personal injury, floor, and product damage may occur.

  • When the clean station emits a bad odor, replace the dust bag or clean the filters.

  • When you pull the power cord out of the groove at the bottom of the clean station, do not pull it hard. Turn the cord gently on its side so that it can come out without interruption.
    – Otherwise, the power cord may get damaged and could cause an electric shock or fire.

INSTALLATION

Installing the clean station

Installation guide

As the outlet is at the rear of the product, do not put the product close to a wall, allow 10 cm of space between the wall and the product, and place the product on a stable floor.

Put the power cord into the groove at the bottom of the clean station, arrange the cord neatly along the wall and plug the product in.

  • When the cord is placed on the floor carelessly, the power cord may be damaged or a person can trip over the cord.
  • When the clean station is plugged in, the product status indicator turns ‘blue’ and then goes off.

SAMSUNG VCA SAE90 Clean Station qr code

https://bcove.video/2JGb82R

❇ Please refer to the QR code for detailed information on the use of the product and cleaning methods.

OPERATION

Using the clean station

The clean station is compatible with the provided dustbin only.

SAMSUNG VCA SAE90 Clean Station clean station

Press the [PUSH] button on the upper cover of the clean station.SAMSUNG
VCA SAE90 Clean Station clean station1

Insert the dustbin into the clean station. Dust is ejected automatically.

  • When the clean station is in operation, the product status indicator turns ‘blue’.
  • Press the [Start/Stop] button to stop the operation.

SAMSUNG VCA SAE90 Clean Station clean station2

When the clean station’s operation stops completely, pull the dustbin out and close the clean station by pressing the upper cover firmly.SAMSUNG VCA SAE90
Clean Station clean station3

NOTE

  • When dust still remains inside the dustbin even after using the clean station, press the [Start/Stop] button to operate the clean station.
    – Press the button again to stop operation.

  • If the dustbin is filled with dust and will not eject it properly, use a hand to push down the top of the washable micro filter, and then operate the clean station.

  • When there are foreign object residues, remove them by referring to the ‘Maintaining the clean station’ section of the manual.

SAMSUNG VCA SAE90 Clean Station clean station4

CAUTION

  • After using the clean station, you should close the dustbin by pressing the bottom cover firmly until you hear it ‘click’.

MAINTENANCE

Maintaining the clean station

Dust bag

SAMSUNG VCA SAE90 Clean Station Dust bag

❇❇ When the product status indicator turns ‘red’, you should replace the dust bag.SAMSUNG VCA SAE90 Clean Station Dust bag 1

  1. Grip both sides of the front cover and pull the cover towards you.
  2. Open the cover by pulling the [PULL] button.

SAMSUNG VCA SAE90 Clean Station Dust bag2

Press the [PUSH] lever.

SAMSUNG VCA SAE90 Clean Station Dust bag3

Pull the [PULL] lever out in a diagonal direction and remove the dust bag.

SAMSUNG VCA SAE90 Clean Station Dust bag4

Insert a new dust bag towards the back and push the [PULL] lever upward firmly until you hear it ‘click’.
❇❇ Be cautious not to assemble incorrectly when inserting the dust bag.SAMSUNG VCA SAE90 Clean Station Dust bag5

After replacing the dust bag, assemble the clean station in reverse order.

NOTE

  • If the dust bag emits a bad odor even though it is not filled with dust, replace the dust bag.
  • When you operate the clean station after replacing the dust bag, the status indicator changes from red to blue.

Dustbin
After emptying the dustbin, clean it with water and dry it completely before use.SAMSUNG VCA SAE90 Clean Station Dustbin

Premotor Filter

  • Lift up the Premotor Filter inside the product and pull it out. Then, detach the nonwoven fabric from the filter.
  • Remove the dust on the nonwoven fabric by shaking it and reassembling the Premotor Filter.

SAMSUNG VCA SAE90 Clean Station Premotor Filter

Ultrafine Dust Filter

  • Do not clean the Ultrafine Dust Filter with water. Shake the filter.
  • To maintain the best performance of the Ultrafine Dust Filter, replace the filter once a year.

SAMSUNG VCA SAE90 Clean Station Dust Filter

SAMSUNG logo

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals