McALPINE Trapped Shower Gullies for Tiled Floors Instructions
- June 4, 2024
- McALPINE
Table of Contents
McAlpine Trapped Shower Gullies for Tiled Floors
Installation and Maintenance Guide
Trapped Shower Gullies for Tiled Floors
McAlpine SHOWER GULLIES SHOULD ONLY BE INSTALLED BY A COMPETENT PLUMBER AND/OR
SPECIALIST FLOORING CONTRACTOR 
The above simply illustrates a selection of Gullies available. For the full range see the enclosed leaflet
IMPORTANT NOTES
- The integrity of the Gully is dependent on a good seal between the underside of a Waterproofing Membrane and the Gully Body; see instruction 10. If a silicone sealant is used care should be taken to use only a neutral sealant. Acetoxy sealants must not be used as they may be detrimental to the plastic used in the manufacture of the Gully.
- The minimum dimension between the Gully Flange and the top surface of the Gully Tile or Grating, which requires to be flush with the finished flooring, is 13m m. This dimension cannot be reduced but if required the Gully Tile or Grating can be raised. To do this remove the center from the Dust Cap/Extension Ring and solvent weld the Extension Ring to the upstand of the Clamp Ring. If additional height is required an appropriate length of 110mm soil pipe can be solvent welded between the Extension Ring and the underside of the Gully Tile or Grating.
- All Gullies have a flow rate in excess of 40 liters per minute when tested in accordance with EN 1253-2:1999 and are variable dependent on Gully Tile or Grating used. The flow rate can be seriously impaired if an adequate fall is not maintained throughout the length of the waste pipe.
INSTALLATION INSTRUCTIONS
The following instructions refer to all one-piece Gullies. For two-piece Gullies, code prefixed TSG52 see additional note at foot of instructions.
- Unpack the box and check the contents.
- Remove Gully Tile or Grating from Gully Body and keep it safe in the box until required.
- Cut a hole in the floor to accommodate Gully Body (timber floor max. 160mm diameter).
- Set Gully Body into the floor sub-structure to a sufficient depth to enable the Gully Tile or Grating to be flush with, or slightly below, the finished floor level (see important note 2).
Instructions continued on reverse
Documents / Resources
|
McALPINE Trapped Shower Gullies for Tiled
Floors
[pdf] Instructions
Trapped Shower Gullies for Tiled Floors, Trapped Shower Gullies, Tiled Floors
Trapped Shower Gullies, Shower Gullies, Gullies
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>