McALPINE BOSSCONN-22mm Mechanical Boss Connector Instructions
- June 4, 2024
- McALPINE
Table of Contents
McALPINE BOSSCONN-22mm Mechanical Boss Connector
PRODUCT OVERVIEW
- Threaded Flange
- Rubber Seal for 110mm Soil Pipe and Round Rainwater Pipe
- Rubber seal for Square Section Rainwater Pipe
- Polythene Washer
- Backnut
- Rubber Compression Seal for 19/22mm Pipe.
- Compression Nut for 19/22mm Pipe
INSTALLATION INSTRUCTION
- Locate exact position where 19/22mm pipe is required to connect and create hole in the soil/rainwater pipe to the dimensions of ‘X’. Use the template if required.
- Select the required rubber seal ‘2’ or ‘3’ and along with the polythene washer ‘4’ plus backnut ‘5’ fit to the threaded flange ‘1’
- Insert the threaded flange into the hole at a slight angle and twist through 90°.
- Push rubber seal and polythene washer along the threaded flange ensuring they are tight to the soil/rainwater pipe. In the case of the rubber seal ‘2’ , ensure the two small round pins are locked inside the soil pipe.
- Check that the threaded flange is at 90° and fully tighten the back nut making sure that the rubber seal and washer do not move out of position.
- Fit 19/22mm pipe to the boss connector by placing ‘6’ and ‘7’ over the pipe, inserting the pipe into the connector and tightening the compression nut.
All water from sanitary pipework must be discharged via soil pipe
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>