QAZQA 106035 Ostrava Ceiling Lamp Instruction Manual

QAZQA 106035 Ostrava Ceiling Lamp

Specifications:

• Power Supply: 220-240V~ 50Hz
• IP Rating: IP20
• Available Models:
  • Ostrava CL 40 Bamboo 106029
  • Ostrava CL 40 Black 106034
  • Ostrava CL 50 Bamboo 106030
  • Ostrava CL 50 Black 106035
• Suitable Light Source: E27, Halogen Max 25W
• Dimensions:
  • Ostrava CL 40: 10cm x 40cm
  • Ostrava CL 50: 10cm x 50cm

Product Usage Instructions

Safety Instructions

1. The luminaires should only be installed by authorized and qualified technicians according to electrical installation regulations.
2. Maintenance should be limited to the luminaire surfaces to avoid moisture contact with terminal connections or voltage control parts.
3. Always switch off the electrical supply before installation, maintenance, or repair work.
4. Avoid installing exterior lighting during rain.
5. Maintain minimal separation distance from other objects and ensure sufficient room around the fitting.
6. If unsure, consult a professional considering local installation requirements.
7. Ensure clamping screws in electrical connections are tightened adequately.
8. When replacing a halogen lamp, allow it to cool for at least 5 minutes.
9. Clean with a clean, dry cloth or brush without using solvents or abrasives. Avoid dampness on electrical components.

Additional Usage Guidelines

• Follow symbol indications for wire connections: N = Neutral, L = Live, Earth symbol.
• For indoor use only where direct water contact is impossible.
• The luminaire should not be disposed of with normal domestic waste; dispose of it at an electrical waste staging area.

Technical Information

• The luminaire is designed for use with a specific voltage range (220-240V~) and frequency (50Hz).
• The luminaire can be used with a dimmer and can be dimmed using a wall switch.

Light Angle

This luminaire features a specific light angle for optimized illumination.

FAQ:

Q: Can I use a different light source with a higher wattage than the specified maximum?

• A: No, it is recommended to use the specified E27 Halogen Max 25W light source to prevent damage to the luminaire.

Q: Is it safe to install the luminaire outdoors?

• A: It is not recommended to install exterior lighting during rain to ensure the safety and proper operation of the luminaire.

Q: Can I clean the luminaire with solvents?

• A: No, it is advised to clean the luminaire with a clean, dry cloth or brush without using solvents or abrasives to avoid damaging the electrical components.

Q: How should I dispose of the luminaire?

• A: The luminaire should not be disposed of with normal domestic waste; instead, it should be taken to an electrical waste staging area for proper disposal.

Features

INSTALLATION INSTRUCTION

SAFETY INSTRUCTION

• Please study the instruction manual and the below information carefully before installing or using this product.
• Please keep this user manual for further reference

1. The luminaires may only be installed by authorized and qualified technicians according to the valid regulations for electrical installation.
2. Maintenance of the luminaires is limited to their surfaces. During maintenance, no moisture can come into contact with any areas of the terminal connections or voltage control parts.
3. The electrical supply must be switched off at the outset, preferably through a switch in the distribution box, before any installation, maintenance, or repair work is undertaken.
4. Exterior lighting must not be installed during rain.
5. Take account of the minimal separation distance from other objects and the room required around the fitting.
6. If in any doubt, consult a professional, taking local installation requirements into account. Some countries stipulate that lighting may be installed only by registered installers.
7. Clamping screws in electrical connections must be adequately tightened. This is particularly the case with 12V low-voltage conductors.
8. When replacing a halogen lamp, wait for it to cool, for a minimum of 5 minutes.
9. Clean with a clean, dry cloth or brush, use no solvents or abrasives. Avoid dampness on all electrical components
10. Take account of all available technical information.
11. Take note of the symbols when connecting wires:
    • N = Neutral L = Live =Earth
12. Meaning of symbols:

• For indoor use only, where direct contact with water is impossible
• This icon indicates the level of water-proof and dust-proof
• Protection Class I: the fitting must be earthed
• Protection Class II: the fitting is doubled insulated and does not require earthing
• Protection Class III: the fitting is low-voltage
• Minimum distance from lighted objects (meters)
• Only the self-shielded halogen lamp should be used with the luminaire
• Strip the wire to the indicated length (mm); different items require different length
• Connect using the specified cable; different items require different cables
• The type of lamp and maximum size and wattage indicated in each lighting unit must not be exceeded; different items require different kinds of light sources with different bulb icons
• The armature is designed to work only with the indicated voltage. Different items require different working voltages.
• The luminaire can be used in combination with a dimmer
• The luminaire can be dimmed by a wall switch
• The reference light angle and light space of the luminaire
• This luminaire cannot be disposed of together with normal domestic waste in a standard rubbish can, but you have to bring it to a staging area for electrical waste
• FittinQ B.V.
• Smaragdweg 52, 5527 LB Hapert, The Netherlandswww.qazqa.nl

References

• QAZQA - Quite Unique | QAZQA

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>