OLIGHT Baton Turbo S 900 Lumen Flashlight User Manual

USER MANUAL
Baton Turbo
Portable, long-range EDC flashlight.

IN THE BOX

Table 1:

SPECIFICATIONS

0-40°C
| |
(L)77(D)29mm (L)3.03 (D)1.14in| 88g/3.11oz (Including Battery)|

• Above data are tested per ANSI/PLATO FL 1-2019 standard in Olight’s labs for reference.

Table 2:

USB Magnetic charging cable

Figure 1

Remove the insulating film before use

Figure 2
Charge

Figure 3
Turn on/off the light

Figure 4
Lock/Unlock Figure 5
Moonlight

Figure 6
Turbo Figure 7
Strobe

Figure 8
Change the brightness level

Figure 9
Auto Shut-Off function

Figure 10-1
Brightness level indicator

Figure 10-2
Battery level indicator

How to operate:

1. Product specifications, see Table 1 and Table 2.

2. Operating instructions as below:
   2.1 Remove the insulating film before use, see Figure 1.
   2.2 Charge, see Figure 2.
   2.3 Turn on/off the light, see Figure 3.
   Press the button to turn on/off the light. When turned on, the light will light up at the memorized brightness level. (Moonlight, Low, Medium, and High will be memorized when turned off. Turbo will be memorized as High; High output will last for 1 minute before switching to Medium: Strobe will not be memorized.)
   2.4 Lock/Unlock, see Figure 4.
   To lock the switch button, when the light is off press and hold the button (for about 2 seconds) until the Moonlight turns on and off. When the button is locked, press the button once to display the remaining battery level without turning on the light. Press and hold the button for 1 second or more to unlock the button and activate Moonlight.
   2.5 Moonlight, see Figure 5.
   To activate Moonlight, press and hold the button for 1~2 seconds when the light is off. lf the last used was Moonlight, simply press the button.
   2.6 Turbo, see Figure 6.
   Double press the button quickly for Turbo, and press again to turn it off.
   2.7 Strobe, see Figure 7.
   Press the button three times or more quickly to enter Strobe, and press once or press and hold the button to exit.
   2.8 Change the brightness level, see Figure 8.
   When the light is on, press and hold the button, and the light will cycle through Low, Mid, and High, starting from the present brightness level. Release the button to select the desired brightness level. (Note: Moonlight and Turbo are not included in this cycle.)
   2.9 Auto Shut-Off function, see Figure 9,
   The light can be set to automatically turn off after two preset periods: a long period (9 minutes) and a short period (3 minutes). To enable the Auto Shut-Off function, double press and hold the button when the light is on. The light will flash once to indicate that the short period is set, and twice for the long period. To switch between timing periods, double press and hold the button during a timing period. When reactivating the Auto Shut-Off function, the previous timing setting will be used.

3. Indicators instructions as below:
   3.1 Brightness level indicator, see Figure 10-1.
   3.2 Battery level indicator, see Figure 10-2.

WARNING

• Do not use damaged, deformed battery, or battery with broken sleeve.
• Do not short the charging port with metallic object intentionally.
• Keep the light locked out when carrying or transporting to prevent burning accidents caused by abnormal startup.

CAUTION

• Do not look directly at the light source or shine to eyes, may cause temporary blindness or permanent damage to the eyes.
• Do not cover the light outlet at close range, as the energy radiated by the light may damage the product’s light emitting components, and even cause external objects to burn.
• Do not charge the light with any other non-specified chargers.
• CAUTION HOT: Do not touch the hot surface place, it may cause skin burns.
• Dedicated battery, do not take it out for charging.

NOTICE

• Do not put a hot light into any type of fabric bag or fusible plastic container.
• Do not activate the maximum brightness mode multiple times continuously to prevent the high temperature on the surface.
• When the light gets hot, please switch it to low brightness, or shut off the light temporarily.
• Active thermal management: The built-in thermistor monitors the temperature of the light in real time and suppresses overheating by reducing the output.
• Do not leave the light in a car where the inside of the temperature may be over 60℃, or similar places.
• Do not put the light in the mouth or lick it, leakage of the charging port can cause discomfort.
• Non-pet toys.
• Do not disassemble the product.
• Do not immerse the light in seawater or other corrosive media as it will damage the product.
• For long-term storage, please remove the battery.
• If the light is left unused for a long period of time, or carried and transported, please loosen the light body a half turn to disconnect the power supply. (Only for models that cannot be turned on by screwing off half a turn.)

REMARK

• A USB adapter with 10W (5v2A) or above is recommended. Otherwise, the charging time will be longer.
• Keep the charging port clean and dry.
• It is normal that the light flickers when the battery is close to running out.
• Operating time in Turbo or High varies with ambient temperature and heat dissipation conditions, better heat dissipation longer runtime.
• The light will memorize current brightness level when it is powered off, including Moonlight, Low, Medium, and High. (After the light is turned off, High will be memorized for 1 minute before reverting to Medium.)
• When using non-rechargeable battery, the maximum output brightness is 500 lumens.
• When the voltage of Olight rechargeable battery is less than 3.4V, it is normal to see no battery level display after removing the battery and reinstalling it.
• When the voltage of a disposable batteries is less than 2.6V, it is normal to see the brightness is lower than the nommal in moonlight mode.

EXCLUSION CLAUSE

Olight is not liable for damages or injuries sustained resulting from the usage of the product inconsistent with the warnings in the manual, including but not limited to using the product inconsistent with the recommended lockout mode.

WARRANTY

Within 30 days of purchase: Contact the original seller for repair or replacement.
Within 5 years of purchase: Contact Olight for repair or replacement.
Battery warranty: Olight offers a one-year warranty for all rechargeable batteries.
USB magnetic charging cable: One year.
If you experience quality problems or damage with low-value fittings like lanyards or clips within 30 days of purchase under normal use conditions, please contact our after-sale service. For issues that occur after 30 days or for damage caused by abnormal use conditions, we provide a conditional quality assurance as appropriate.
USA Customer Support
cs@olightstore.com
Global Customer Support
contact@olightworld.com
Visit www.olightworld.com to see our complete product line of portable illumination tools.
Dongguan Olight E-Commerce Technology Co., Ltd.
4th Floor, Building 4, Kegu Industrial Park, No 6 Zhongnan Road, Changan Town, Dongguan City, Guangdong, China.
Made in China

3.4000.0706
D. 10, 07, 2023

Documents / Resources

| OLIGHT Baton Turbo S 900 Lumen Flashlight [pdf] User Manual
Baton Turbo S 900 Lumen Flashlight, Baton Turbo, S 900 Lumen Flashlight, Lumen Flashlight, Flashlight
---|---

References

• Olight | Illuminate Your World.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>