OLIGHT Warrior Nano Rechargeable High Lumen Dual Switch EDC Flashlight User Manual

OLIGHT Warrior Nano Rechargeable High Lumen Dual Switch EDC Flashlight User Manual

IN THE BOX

Table 1:

SPECIFICATIONS

Table 2:

USB Magnetic charging cable

Multi-language dictionary

1. Product specification, see Table 1 and Table 2.
2. Remove the insulating film, see Figure 1.
3. Charging, see Figure 2.
4. Side switch operating instructions below：

4.1 On/Off, see Figure 3.

Press the side switch to turn the flashlight on/off.
When the light is turned on again, it will return to the previously memorized mode.
Note: Memorized Modes: Moonlight, Low, Medium, and High Modes (Strobe and Turbo can’t be memorized) entered by pressing the side switch will be memorized when the light is turned off (the High Mode is only memorized for 1 minute and then converts to Medium Mode).

4.2 Lockout / unlock, see Figure 4.

When the flashlight is off, press and hold the side switch (for about 2 seconds) to access lockout mode (the flashlight will enter Moonlight Mode briefly and then switch off to signal lockout mode activation). In lockout mode, if you press and hold the side switch or tail switch for less than one second, the indicator at the center of the side switch will light up red for two seconds to signal that the light is still in lockout mode. To unlock it, please press and hold the side switch for over one second until the moonlight mode is on again.

4.3 Moonlight, see Figure 5.

When the flashlight is off, press and hold the side switch for over one second to access the moonlight mode. When the flashlight is turned on again, it returns to the moonlight mode due to its memory function.

4.4 Turbo, see Figure 6.

Quickly double press the side switch to enter into Turbo, double press again to return. If the memorized mode were High or Medium, the output is Medium; if the memorized mode were Low or Moonlight, the output is the memorized mode.

4.5 Strobe, see Figure 7.

When the flashlight is on, triple-press the side switch to activate strobe mode. To quit this mode, single press or press and hold the switch.

4.6 Change brightness level, see Figure 8.

When the flashlight is on, press and hold the side switch and it will, starting from the present brightness level, automatically cycle through Low, Medium, and High mode. The mode is selected when the side switch has been released. (Please note: moonlight and turbo are not in the automatic cycle ).

5. Tail switch operating instructions below：

5.1 Press slightly (only for Configuration 1), see Figure 9.

Press slightly for Medium Mode. Press and then release quickly to turn on/off the flashlight.

5.2 Press hard (only for Configuration 1), see Figure 10.

Press hard for Half-Turbo Mode. Press and then release quickly to turn on/off the flashlight.

5.3 Press slightly and hold, see Figure 11.

Press slightly and hold to turn on the flashlight’s Medium Mode, and the flashlight will be turned off when the switch is released.

5.4 Press hard and hold (only for Configuration 1), see Figure 12.

Press hard and hold to turn on the flashlight’s Half-Turbo Mode, and the flashlight will be turned off when the switch is released.

5.5 Press hard and hold to turn on the flashlight’s Strobe Mode (only

for Configuration 2), see Figure 13.

Press hard and hold to turn on the flashlight’s Strobe Mode and the flashlight will be turned off when the switch is released.

5.6 Switch between Configurations, see Figure 14.

Press hard and hold the tail switch and then press the side switch, the program will switch between Configuration 1 and Configuration 2 in a cycle. When Configuration 1 and Configuration 2 are switched successfully, the flashlight will strobe. When
configuration 2 is switched to configuration 1 successfully, the strobe will be changed into Half-Turbo.

5.7 Switch between pressing hard to access Half-Turbo and pressing hard

to access Turbo, see Figure 15.

When charging the flashlight in the off state, press and hold the side switch for 2 seconds to enter lockout mode. Then it will switch between pressing hard to access Half-Turbo and pressing hard to access Turbo.
After switching successfully, the corresponding Configuration will also be changed synchronously.
Please press and hold for 1 second to unlock it for use.

6. Battery Indicator：

6.1 Normal mode, see Figure 16-1.

6.2 Moonlight mode, see Figure 16-2.

7. L-shape stand application, see Figure 17.

Table 3

Multi-language dictionary

WARRANTY
Within 30 days of purchase: Contact the original seller for repair or replacement.
Within 5 years of purchase: Contact Olight for repair or replacement.
Battery warranty: Olight offers a one-year warranty for all rechargeable batteries.
USB magnetic charging cable: One year.
If you experience quality problems or damage with low-value fittings like lanyards or clips within 30 days of purchase under normal use conditions, please contact our after-sale service. For issues that occur after 30 days or for damage caused by abnormal use conditions, we provide a conditional quality assurance as appropriate.

USA Customer Support
cs@olightstore.com
Global Customer Support
contact@olightworld.com
Visit www.olightworld.com to see our complete product line of portable illumination tools.

Dongguan Olight E-Commerce Technology Co., Ltd.
4th Floor, Building 4, Kegu Industrial Park, No 6
Zhongnan Road, Changan Town, Dongguan City,
Guangdong, China.
Made in China

CAN ICES-005 (B) / NMB-005 (B)
3.4000.0671
B. 08, 15, 2023

References

• Olight | Illuminate Your World.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>