ExBrite EBMC3630V8DX Bathroom Medicine Cabinets with Light Instruction Manual
- June 17, 2024
- ExBrite
Table of Contents
ExBrite EBMC3630V8DX Bathroom Medicine Cabinets with Light
INSTALLATION INSTRUCTIONS
WARNING AND SAFETY INSTRUCTIONS
Before installing your LED Medicine Cabinet fixture, please make sure that you
carefully read through this instruction sheet, refer back to them during
installation to ensure your product is fitted safely and correctly. Keep these
instructions for future use.
WARNING Risk of Fire and Electric Shock
- All fittings must be installed by current IEE wiring regulations. If in doubt, consult a qualified electrician.
- Switch off the electrical supply at the main circuit board BEFORE installation and maintenance.
- Suitable for indoor use only. This product should be positioned well away from curtains and fabrics. Never cover the mirror.
- Regularly check the cord, the transformer, and all other parts for damage, if any part is damaged the product should not be used.
INSTALLATION SAFETY
- Inspect the product immediately upon receipt for any possible damage during transportation or missing parts. Handle the product with care and protect against knocks to all sides and edges of the glass.
- Ensure there are no hidden pipes or cables in the wall before drilling.
- Wear suitable eye protection when drilling. Take care if drilling on tiled surfaces in case the drill slips.
CAUTION
The light source of this product is non-changeable light diodes (LED). Do not
disassemble the product, as the light diodes can cause damage to the eyes.
NOTE : The important safeguards and instructions that appear in this manual are not meant to cover all possible conditions and situations that may occur. It must be understood that common sense, caution and care are factors that can’t be built into any product. These factors must be supplied by the person(s) caring for and operating the fixture. Do not install this fixture in hazardous locations.
REQUIRE TOOLSET
PARTS SUPPLIED
Cabinet Installation Instructions for Hanging Walls
Cabinet embedded Installation Instructions
*All diagrams are for reference only. All model dimensions and proportion positions will vary.
Instructions for assembling the doors and cabinet–
Suit for the items which doors and cabinet are separately packaged (considering the huge weight, we suggest installing the cabinet first, then assembling the door with cabinet as below steps)
- Insert the things to the base,then connect the doors with the cabinet
- Adjust corresponding screws on the hinge to align the doors, ensure that gaps are even and the doors open and close smoothly
- Insert the wire on the door into the terminal on the cabinet and tighten the screw.
Manual to turn on/off light, dimming, CCT changing with touch switch
Short – touch the button to turn on/off the mirror.
- Adjusting color temperatures (CCT) between warm white and cool white by long-touching the button for seconds.
- Finish setting by withdrawing your finger when the color reaches the one you need.
- Optional to be wired to wall switch by ON/OFF memory function.
- Short – touch the button to turn on/off the mirror.
- Long touching the button to adjust the brightness (Dimming).
- Finish setting by withdrawing your finger when the brightness reaches the one you need.
- The mirror begins to be warm and defog after pressing the defogger button.
- Press again to quit the anti-fog function.
- Long press the button to turn on/off the blue backlight
Note : The defogger will stop automatically after 60 minutes of continuous operation to prevent any damage caused by prolonged high temperatures.
Sensor Light
Inside Sensor Light
- The Sensor Light inside the cabinet will be Auto-on/off according to the opening and closing of the cabinet door.
- Don’t cover the light sensor