BOLD MFG SUPPLY BAFEz6X6JU8 Curbside Mailbox Instruction Manual
- June 17, 2024
- BOLD MFG SUPPLY
Table of Contents
BOLD MFG SUPPLY BAFEz6X6JU8 Curbside Mailbox
CURBSIDE MAILBOX INSTALLATION
TOOLS & SUPPLIES
60″ CONCRETE POST 
- Locate the hole location 18″ back from the curb. Dig a hole about 20″ deep, and 12″ wide.
- Mix the concrete in the bucket. Follow mixing instructions on the bag.
- Set the top of the post 42″ above the ground. Use the level to check plumb. Let the concrete cure at least 2 hrs.
- Once post is set, use provided machine screws and alien wrench to secure mailbox to the post.
42″ FOOTING POST 
INSTRUCTIONS
- Mark out the hole locations for the concrete anchors, centering the post 18″ back from the curb.
- Drill the holes for the anchors. (Use a 3/8″ masonry bit for 3/8″ steel expansion wedge anchor)
- Set the anchors through the baseplate holes to ensure alignment. (the side with square holes goes up.)
- Tighten the post down and check plumb with level. Shim if necessary.
- Once post is set, use provided machine screws and alien wrench to secure mailbox to the post.
Per U.S. Postal Service Standard – Mailboxes, Curbside, paragraph 3.12.1
Assembly and Installation:
A complete set of instructions for assembling and mounting the mailbox shall
be furnished with each unit. The instructions must include the following
conspicuous message:
PURCHASER IS REQUIRED TO CONTACT THE LOCAL POST OFFICE BEFORE INSTALLING THE
MAILBOX TO ENSURE ITS CORRECT PLACEMENT AND HEIGHT AT THE STREET. GENERALLY,
MAILBOXES ARE INSTALLED AT A HEIGHT OF 41 – 45 in. FROM THE ROAD SURFACE TO
INSIDE FLOOR OF THE MAILBOX OR POINT OF MAIL ENTRY (LOCKED
DESIGNS) AND ARE SET BACK 6 – 8 in. FROM FRONT FACE OF CURB OR ROAD EDGE TO
THE MAILBOX DOOR.
Have questions? Please contact us at
sales@boldmfg.com
Printed in the USA
© BOLD MFG & SUPPLY 2023
boldmfg.com
sales@boldmfg.com
877-BOLD MFG
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>