NOESIS F10 Florio 2in1 Robot Vacuum and Mop Combo Instruction Manual

NOESIS F10 Florio 2in1 Robot Vacuum and Mop Combo

QUICK START GUIDE

1. Remove all tape
   • Remove the tape on the front cover and the mop pad boxes in the base station.
2. Place base station
   • Place the base station on a hard, horizontal floor against the wall. Ensure enough space on each side of the base station as shown below.
3. Power on
   • Take out the power cord and then insert it into the base station (please insert the power cord firmly).
4. Install guide plate
   • Align the buckles of the guide plate with the slots in front of the base station and snap to install as shown.
5. Install mop tray
   • Push the mop tray into the back of the base station. Follow the directional arrow on the tray.
   • Note: The base station will provide a voice alert The mop tray has been installed*.
6. Draw out a new mop pad box
7. Slide up the front cover of the base station.
8. Pull out the new mop pad box.
9. Insert new mop pads
10. Unpack new mop pads and turn the granular textured side down as per label instructions.
11. Align support rods in mop pads with positioning posts of new mop pad box, insert mop pads and remove support rods.
12. Insert the new mop pad box into the base station and close the front cover.
13. Fill water
14. Open the top cover of the base station and take out the water tank.
15. Unscrew the lid and fill the water.
16. Screw the lid and put the water tank back into the base station.

  *  **NOTE:** Mix 2.5 floz (75ml) of cleaning solution with a full tank of water. It is recommended to use NOESIS special cleaning solution.![NOESIS-F10-Florio-2in1-Robot-Vacuum-and-Mop-Combo-FIG-1 \(4\)](https://manuals.plus/wp-content/uploads/2024/02/NOESIS-F10-Florio-2in1-Robot-Vacuum-and-Mop-Combo-FIG-1-4.png)

9. Remove protectors on the robot and turn it on
10. Remove the protective strips on either side of the robot.
11. Open the cover of the robot. Push the ON/OFF button to the right to turn on the robot.
12. Install mop plate
    • Install the top plate onto the robot as shown.
    • NOTE: The robot will provide a voice alert “Mop plate has been installed:
13. Charge the robot
    • Gently push the robot into the base station to charge.
    • NOTE: The robot will provide a voice alert “Charging started” when charging has started.

APP DOWNLOAD AND OPERATION GUIDE

For the best experience, download the NOESISHOME app to customize your cleaning, set a schedule and access even more features.

1. Scan the QR code below to download the APP and register.
2. Click the *+” in the upper right-hand corner to begin the connection process. Choose (F10 Pro) from the list.
3. Turn on the robot and short press . It will enter network connection mode after voicing “WIFI has been reset. Waiting to connect.”.
4. Select your home Wi-Fi (2.4G) and enter your password.
   • NOTE: 5G networks are not currently compatible.
5. Follow the directions on the app to connect to the “NOESIS-XXX” network under your Wi-Fi networks. Return to the app after confirming successful connection. If the robot network cannot be found in the list, please restart from Step 3.
6. Keep the APP open on the configuration page until completed.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>