DOLGABA Wall Mount Kitchen Sink Faucet with Pull Out Sprayer Instruction Manual
- June 17, 2024
- DOLGABA
Table of Contents
DOLGABA Wall Mount Kitchen Sink Faucet with Pull Out Sprayer
INSTALLATION AND USING INSTRUCTION
- Before installation, please turn on the water source and rinse for three minutes, and rinse the sand and gravel in the water pipe to avoid affecting the service life of the faucet.
- First use glass glue to seal the gap between the NPT1/2 water outlet and the wall, and the center distance of the two water outlets must be within the interval of 3/ 6/9in,70/145/225mm.
- There are two functions here:
- Rotate clockwise to adjust the water flow
- Turn clockwise to the end, there is a water-stop function
- First wrap an appropriate amount of raw material tape on the thread of the curved foot, and then use a wrench to screw the two curved feet into the hot and cold water outlets respectively.
- Twist the curved feet so that the centre of the two curved feet is 3in/70mm apart. Use a spirit level to measure whether the two bent feet are level.
- As shown in the picture, install the decorative cover on the curved feet in sequence, and then fix the faucet with a wrench.
- Note: The mesh rubbesequencer ring in Figure 2 must be installed to prevent garbage or gravel from clogging the faucet and affecting the service life.
- Note: The mesh rubbesequencer ring in Figure 2 must be installed to prevent garbage or gravel from clogging the faucet and affecting the service life.
- The 360° rotating and foldable design not only provides you with convenient cleaning but also saves valuable space for you.
- At this point, the installation steps are all completed! It is convenient and quick to stretch out when you need to use it!
- Due to different measurement tools and measurement methods, there may be slight errors, please refer to the actual product!
- Rotate the switch outwards respectively to get out the water.
Read User Manual Online (PDF format)
Loading......