Maxblue MB-PT-56BC Water Filter Jug with 1x 60 Days Filter Instruction Manual
- June 17, 2024
- Maxblue
Table of Contents
Maxblue MB-PT-56BC Water Filter Jug with 1x 60 Days Filter
Replacement for pitcher filter
Model: MB-PF-56B Filter life: 2 months or 60 gallons
REPLACEMENT ELEMENT
Tested and Certified by NSF International against NSF/ANSI Standard 42 in model MB-PT-56BB/MB-PT-56BC/MB-PT-56BL/MB-PT-56BW for the reduction of the claims specified on the Performance Data Sheet, and to NSF/ANSI 372 (≤0.25% lead).
NOTE: This filter should not be used with water that is microbiologically unsafe or of unknown quality without adequate disinfection.
Getting started
STEP 1.
Remove all packaging of the filter.
STEP 2.
Place the filter in a bowl full of clean, cold water. Submerge it into the
water until there are bubbles released. Leave it to stand for 15 minutes.
[Figure 1.1]
STEP 3.
Take it out of the water and rinse it under the tap. [Figure 1.2]
STEP 4.
Install it into a reservoir of a pitcher. Press it down forcibly to ensure a
tight seal. [Figure 1.3]
STEP 5.
Fill the reservoir with cold water. Allow the filter to filter the water and
then discard it. Please repeat this step for at least two times. [Figure
1.4]
STEP 6.
Hold the button for 5 seconds until the blue light flashes to activate the
indicator. [Figure 1.5]
Note: repeat this step after each new filter replacement.
Storage and maintenance
-
To get refreshing, great-tasting water, we recommend that you store your filter in the refrigerator or in a cool area that is not in direct sunlight.
-
If the tap water has a lot of turbidity (such as if the water tank has been cleaned or the tap water hasn’t been used for a long time), please flush it for a few minutes until the water turns clean before using.
-
If the water filter is not going to be used for a long time, please put it in a clean container with a lid.
Then place it in the refrigerator, which will prolong its filter life. -
The filter must be protected from freezing; otherwise it might cause cracking and water leakage from the filter.
-
It is advised that all filtered water be stored in the refrigerator and discarded after 48 hours if not consumed.
Warning
- To reduce the risk of property damage due to water leakage, this filter MUST be installed in accordance with the manufacturer’s specifications and instructions.
- The operating temperature of this pitcher filtration system is 41-100°F/ 5-38°C.
- Failure to follow instructions and operating specifications will void your quality assurance. Further, the manufacturer assumes no responsibility or liability for damages arising out of misuse of the product.
Frequently asked questions
Q: Why does my filter get slow?
A: The filter cartridge may be clogged. Please check the indicator to see
if it’s time to change the filter cartridge. If yes, please replace the filter
cartridge immediately. If not, take out the filter and shake it intensely in
order to shift the granules inside, which will improve the speed of water
flow.
Q: Why does the water taste bad?
A: The product is unclean, or the filter cartridge is not installed
properly. It could also be time to change the filter cartridge. Please clean
the pitcher and install the cartridge correctly or replace the filter
cartridge.
Q: Do I have to change my filter every 2 months?
A: Yes, you must replace the filter every 2 months or sooner if water
flow is reduced or if heavy sediment/rust is present.
Performance data sheet
System Model No. : MB-PT-56BB/MB-PT-56BC/MB-PT-56BL/MB-PT-56BW
Substance reduction
The system has been tested and certified by the NSF International according to NSF/ANSI Standard 42 and NSF/ANSI Standards 372. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for the water leaving the system, as specified by NSF/ANSI Standard 42. While testing was performed under standard laboratory conditions, actual performance may vary.
Performance Data Sheet
Substance
| Inf. Average| NSF Specified Challenge Concentration| Ave. % Reduction
Chlorine Taste and Odor| 2.0 mg/L| 2.0 mg/L ± 10%|
93.9%
Average Product Water Concentration
| Max Permissible Product Water Concentration| NSF Reduction Requirements| NSF
Test Report
0.05 mg/L| N/A| ≥50%|
J-00355921
System to be used with municipal or well water sources treated and tested on regular basis to ensure bacteriological safe quality. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
Testing was performed under standard laboratory conditions, actual performance may vary.
Customer Support
Manufacturer Technical Support
Tel: 1-888-352-3558 (U.S.)
E-mail:service@maxbluefilter.com
Made in China V041
Qingdao Ecopure Filter Co., Ltd.
Documents / Resources
|
Maxblue MB-PT-56BC Water Filter Jug with 1x 60 Days
Filter
[pdf] Instruction Manual
MB-PT-56BC Water Filter Jug with 1x 60 Days Filter, MB-PT-56BC, Water Filter
Jug with 1x 60 Days Filter, Filter Jug with 1x 60 Days Filter, Jug with 1x 60
Days Filter, 1x 60 Days Filter, 60 Days Filter, Days Filter
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>