BLACK DECKER GS0311-0PD Easy Store Garment Steamer User Manual

BLACK DECKER GS0311-0PD Easy Store Garment Steamer User Manual

Please Read and Save this Use and Care Book.

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should always be followed, including the following:

• READ ALL INSTRUCTIONS BEFORE USING.
• To reduce the risk of contact with hot water emitting from steam vents, check appliance before each use by holding it away from body and operating steam button.
• Use steamer only for intended use.
• To reduce the risk of electric shock, do not immerse the steamer in water or other liquids.
• Always turn the unit off before plugging or unplugging the unit from the electrical outlet.
• Never pull on the cord to disconnect from the electrical outlet; instead grasp plug and pull to disconnect.
• Do not allow cord to touch hot surfaces. Let steamer cool completely before putting away. Loop cord loosely around appliance when storing.
• Always unplug steamer from the electric outlet before filling with water, emptying, or cleaning, and when not in use.
• Do not operate the steamer with a damaged cord, or if the appliance has been dropped or damaged, or if it is leaking. To reduce the risk of electric shock, do not disassemble or attempt to repair the steamer; take it to a qualified service person for examination and repair, or call the appropriate toll-free number in this manual. Incorrect reassembly or repair could cause a risk of fire, electric shock, or injury to persons when the steamer is used.
• Close supervision is necessary for any appliance being used by or near children. Do not leave the steamer unattended while connected.
• Burns can occur from touching hot water or steam. Appliance should not be turned upside down
  • there may be hot water in the reservoir. Avoid rapid movement of steamer to minimize hot water spillage.
• To reduce the likelihood of circuit overload, do not operate another highwattage appliance on the same circuit.
• If an extension cord is absolutely necessary, a minimum 10-ampere rated cord should be used. Cords rated for less amperage may overheat. Care should be taken to arrange the cord so that it cannot be pulled or tripped over.
• Do not use outdoors.
• Do not use anything other than water in the steamer while in use or during cleaning.
• Never steam clothing while on a body.
• Never aim the steam directly towards people, animals or plants. The steam is very hot and can results in burns. Burns can occur from touching hot parts (including the steamer head and frames), hot water, or steam.
• This unit should be used in an upright position only. Never hold the steam head down while at rest or tilt it as this may result in hot water discharge and possibly injury.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliances by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• The steamer should be used or placed on a flat, firm surface.
  • When placing the steamer on the heel rest, make sure the surface is flat and firm.
  • The steamer should not be used if it has been dropped, damaged or leaking

SAVE THESE INSTRUCTIONS.

This product is for household use only.

POLARIZED PLUG (120V models only)
This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to modify the plug in any way.
Note: If the power supply cord is damaged, in order to avoid a hazard, it should be replaced by qualified personnei

TAMPER-RESISTANT SCREW
Warning: This appliance is equipped with a tamper-resistant screw to prevent removal of the outer cover. To reduce the risk of fire or electrical shock, do not attempt to remove the outer cover. There are no userserviceable parts inside. Repair should be done only by authorized service personnel.

PARTS AND FEATURES

1. Steam Trigger Lock
2. Steam Trigger
3. Handle
4. Water Inlet Cover
5. Power Button
6. Light
7. Fabric Brush
8. Cord Clip
9. Heat-proof Storage Bag GS0311-1PD model only (not shown)

Product may vary slightly from what is illustrated.

GETTING STARTED

• Remove all labels, tags and stickers attached to the body, or cord of the steamer and the plastic band around the power plug.
• Remove and save literature.
• Please go to www.prodprotect.com/blackanddecker to register your warranty.
• Read all the instructions before using your steamer.
• Use fresh distilled water only. DO NOT FILL PAST MAX LINE.
• Any water droplets visible inside the tank are from individual quality control tests.
• Do not use perfumes, oils, or other additives.
• Always review the garment manufacturer’s care label instructions before steaming. Test fabrics for colorfastness in inconspicuous areas (such as an inseam). Do not use on leather, suede, vinyl, or plastic.
• During use the steamer and accessories will become HOT. Never try to fit or remove attachments while still hot.
• After preheating, prime the water pump by holding the steam trigger until steam forms.
• It is normal to feel or hear the water pump inside the device. It may become louder when the water level in the tank is low. Check and refill the tank when required.
• Small amounts of dripping might occur during use. If excessive, your steamer needs time to get back up to full temperature. Just allow the steamer a minute to reheat.
• Wearing clothes immediately after ironing or steaming can actually create wrinkles. Always allow the clothing to cool for about 5 minutes before wearing.

HOW TO USE
ATTACHMENTS

Fabric Brush
The fabric brush is recommended for thicker fabrics. It helps steam penetrate deeper into the fibers to smooth wrinkles. Fitting/Removing ( Fig. A)

1.  Make sure that the steamer and attachment are cool.
2. Hook the top of the attachment over the top edge of the steamer. Click the bottom edge into place. Make sure it is fully fitted and not loose or it may detach itself during use.
3. Remove the attachment using the tab. When removing the attachment, watch out for condensation that may have built up during use.

FILLING

1. Place the steamer on its base on a stable surface.

2. Open the water inlet cover (F ig. B).
   

3. Pour slowly, to allow the air in the reservoir to escape, and avoid an airlock (Fig. C).

4. Don’t fill past the max mark on the reservoir, or water will escape in use.

5. Wipe up any spillage.

   • To refill at any time during use, turn the steamer off by pressing the power button until the blue indicator light goes out, unplug from outlet, and follow the above procedure.
   • After refilling, allow to reheat for 45 seconds and then prime the pump by holding the steam trigger until steam forms

USING

1. * If the label says “do not steam”, do not steam the garment.

2. Hang the garment in an area that will not be affected or damaged by the heat and steam, such as on a shower curtain rail, or in an open doorway.
3. Fit any attachment you wish to use.
4. Plug the steamer in then press the power button. The power button light will slowly flash, indicating that the steamer is heating.
5. After about 45 seconds the power light will stay on, indicating the steamer is preheated.
6. Prime the water pump by holding steam trigger until steam forms.
7. To generate steam, press the steam trigger. As long as the trigger is held, steam will emit from the steamerWhen the trigger is released, the steam will stop.
   • To generate a constant flow of steam without holding the trigger, press the steam trigger and then slide the steam trigger lock downwards. You can then release pressure on the steam trigger. To turn the steam off, press the trigger, slide the steam trigger lock upwards, then release the trigger.
8. With your free hand keep the fabric taut. Steam the garment with slow, downward strokes, keeping the head of the steamer in contact with the fabric.
9. When you have finished, press and hold the power button until the light goes out (about 3 seconds) and unplug.
10. Stand the steamer on its base and allow it to completely cool off before storing. To avoid mineral buildup, empty the tank after each use.

Auto shut off
Your steamer will automatically switch to auto shut-off mode after being left inactive for 15 minutes. The power button light will flash rapidly to indicate this. To resume steaming, press the steam trigger or power button and wait for your steamer to fully reheat.

TROUBLESHOOTING

Press the steam trigger or press the power button to activate the steamer.
Not enough steam or no steam is coming out of the steamer.| The steamer isn’t heated up to full temperature.| Always allow steamer to preheat at least 45 seconds.
There is not enough water in the water tank.| Follow the instructions on “How to Use”.
The water pump hasn’t been primed.| After preheating, always prime the water pump by holding the steam trigger until steam forms.
Calcium deposits have built up.| Follow the instructions under TIPS on how “To remove mineral buildup”.
Discolored water is coming through the holes and staining the fabric.| Residue has built up in the water tank.| Empty the water tank after each use. Only use fresh distilled water.
Perfumed or scented additives were used.| Regularly clean steamer and refrain from using perfumed or scented additives.
Starch was used.| Always clean steamer ironing plate after using starch.
Steamer is leaking or spitting.| Steamer is not hot enough.| Allow the steamer to heat for about 45 seconds.
Condensation has built up.| Gently wipe the steam head with a soft, damp cloth to remove condensation.
Tap water or other filtered water is being used.| Only use fresh distilled water.
Unit is tilted while using.| Only use in upright position.

TIPS

• Sensitive items (such as items with embellishments) should be steamed from the inside of the garment to avoid damage.
• Allow clothing to cool for about 5 minutes after steaming to set the press
• To remove mineral buildup, mix 1/2 white vinegar with 1/2 fresh distilled water. Plug in steamer and run half of the solution through the steamer. Unplug and let it sit for 30 minutes. Dump out. Repeat as needed until steam output improves. Run fresh distilled water through steamer before using on clothes.

CLEANING AND CARE
This product contains no user serviceable parts. Refer to qualified service personnel.

CAUTION: Allow the iron to fully cool before storing.

1. Make sure steamer is off, unplugged and completely cool.

2. Wipe all surfaces with a clean damp cloth.

3. After the steamer has been thoroughly dried, turn it back on and lightly steam over an old cloth. This will help remove any residue left in the steam holes.

4. To avoid mineral buildup, empty the tank after each use.

5. For storage purposes it is possible to fold the steamer by pushing the head downwards (Fig. D).
   

6. The cord can be wrapped around the heel of your steamer for storing. Use the clip to secure the last section of cord as shown (Fig. E).
   

CLEANING ATTACHMENTS

• Wipe with damp cloth to clean.

Please do not throw this product away with normal household waste. If possible, take it to an official collection point in your area that recycles this type of product. Thank you for considering the environment.

BLACK+DECKER® and the BLACK+DECKER® logos are trademarks of The Black & Decker Corporation, used under license by Empower Brands, LLC, a subsidiary of Spectrum Brands, Inc. for its manufacturing and sale of this product. All rights reserved. All other marks are trademarks of Empower Brands, LLC.

© 2023 Empower Brands, LLC. Todos los derechos reservados / All rights reserved. Empower Brands, LLC, Middleton, WI 53562 09/2023
Fabricado en China. Made in China

References

• prodprotect.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>