The Home Depot D0147-6 Light Fixture Instructions
- June 17, 2024
- THE HOME DEPOT
Table of Contents
The Home Depot D0147-6 Light Fixture
Specifications
- Light fixture components: 1 topper part, 2 light arms, 1 light fixture, 1 canopy, 2 cap nuts, 5 screw lock nuts, 1 teeth lock washer, 1 short hanging tube, 3 long hanging tubes, 2 grub screws, 1 hex key, 6 cylinder tubes
- Product code : D0147-6
Product Usage Instructions:
Installing the Arms on the Light Fixture:
- Attach the arms to the light fixture using the screw lock nut and teeth lock washer. Be careful not to damage the wires during installation.
-
- Adjust the arms to the correct position as shown in the picture. If the arms are not tight enough, go back to step 1.1 to secure the nuts and washers again.
Installing the Topper Part:
- Ensure all wires are inside the box before installing the topper part on the light fixture using screws. Only loosely put the screws in place initially. Once all three screws are in position, tighten them securely.
Installing Hanging Tubes:
- Thread the wire through the hanging tube and rotate it to install it on the light fixture.
- Secure the hanging tube with grub screws using the provided hex key.
- Pass the wire through the canopy and rotate the canopy ontothe fixture. Additional tubes can be connected for the desired height.
Final Installation Steps:
- Attach the bracket to the junction box using screws.
- Connect the wire to your home line.
- Secure the fixture to the bracket using cap nuts.
- Place the cylinder tube on the bulb holder and install the bulb.
FAQ
- Q: Can I install this product myself?
- A: No, it is recommended that only a professional electrician installs this product. Please ensure that the electricity is powered off during installation for safety.
PARTS AND TOOLS
INSTALLATION INSTRUCTION
- Install the arms 2 on the light fixture 3 with lock nut & teeth lock washer D. (Be careful when install the arms to avoid damaging the wires!
- Adjust the arms 2 to the right position as the picture shows. (If the arms are not tightened enough, please back to step 1 to lock the nuts and washers again.)
- Make sure that all the wires in box 3, after that install the topper part * on the light fixture with screw 5. (First only put screw 6 on the holes but no tighten, when all 3 screws are on the holes, then make it fasten finally.)
- Let the wire go through hanging tube ®, rotate to install the tube ® on the light fixture 4, and after that lock it with a grub screw & (use hex key 9), let the wire go through canopy 10, and rotate the canopy ® to the fixture. (Can connect more tubes to get suitable height.)
- Install the bracket to the junction box with screw 12.
- Connect the wire to your home line.
- Install the fixture to the bracket with with cap nut I.
- Put the cylinder tube * on the bulb holder and install the bulb 5.
D0147-6
Please read carefully before installation!!!
Note: Please make sure that the electricity is powered off during
installation ! Only a professional electrician should install this kind of
product
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>