hansgrohe 76060 Finoris Single Lever Basin Mixer 230 with Swivel Spout Instruction Manual
- May 15, 2024
- hansgrohe
Table of Contents
Finoris 230
76060XXX
Safety Notes
Gloves should be worn during installation to prevent crushing and cutfing
injuries.
The product may only be used for bathing, hygienic and body cleaning purposes.
The hot and cold supplies must be of equal pressures.
Installation Instructions
- Prior to installation, inspect the product for fransport damages. After it has been installed, no transport or surface damage will be honoured.
- The pipes and the fixture must be installed, flushed and tested as per the applicable standards.
- The plumbing codes applicable in the respective counfries must be observed. ‘
- The drain valve may only be installed in basins with an overflow opening.
- The drain valve must only be used as intended. It is not allowed to attach other objects to the drain valve, for example a semi-pedestal.
Technical Data
| Operafing pressure: | max. 1 MPa |
|---|---|
| Recommended operating pressure: | 0,1-0,5 MPa |
| Test pressure: | 1,6 MPa |
| Hot water temperature: | (1 MPa =10 bar = 147 PSI) max. 60°C |
| Thermal disinfection: | 70°C / 4 min |
The product is exclusively designed for drinking water!
Symbol description
| ( Do not use silicone containing acetic acid!
---|---
| stment (see page E] To adjust the hot water limiter. Using a hot water
limiter in combination with a continuous flow water eater is not recommended.
| Dimensions (see page EJ)
| Flow diagram (see page BJ)
| Spare parts (see page XXX = Colors 000 = Chrome Plated
670 = Matt Black
700 = Matt White
| Cleaning (see page B9)
| Operation (see page
Hansgrohe recommends not to use as drinking water the first half liter of
water drawn in the morning or after a prolonged period of non-use.
Test certificate (see page
| Fault | Cause | Remed |
|---|---|---|
| Insufficient water | – Aerator calcified, dirty | – Clean aerator, replace as |
necessary
Mixer stiff| – Cartridge defective, calcified| – Exchange cartridge
Mixer dripping| – Cartridge defective| – Exchange cartridge
Water escaping at the threaded base| – connection hoses not completely screwed
into basic body| – Tighten connection hoses by hand
– 0-ring at the connection hose defective.| – Exchange 0-ring
Hot water temperature too low| – Hot water limiter incorrectly set| – Set hot
water limiter
Assembly
www.hansgrohe.com/cleaning-recommendation
Finoris 230
76060XXX
Hansgrohe · Auestraße 5 – 9 · D-77761 Schiltach
Telefon +49 (0) 78 36/51-1282 ·
Telefax +49 (0) 7836/511440
E-Mail:info@hansgrohe.com
Internet:www.hansgrohe.com