LIFESPAN KIDS 3y+ Atlas Cubby House User Manual
- June 17, 2024
- LIFESPAN KIDS
Table of Contents
USER MANUAL
Atlas Cubby House
3y+
LIFESPAN KIDS 3y+ Atlas Cubby House
WARNING: The disassembled product may contain small parts which pose a
choking hazard to children under 3.
IMPORTANT:
The owner’s manual contains safety, assembly, use and maintenance
instructions. This product must be assembled by an adult who has read and
understood these instructions. Keep the packaging away from children and
dispose of all packaging before use.
For the installer and your children’s safety, it is important to fully read
and understand the instructions and safety hazards before commencing the
assembly of the product.
NOTE:
This manual should not be used to guide your purchasing decision. Your
product, and the contents inside its carton, may vary from what is listed in
this manual. This manual may also be subject to updates or changes. Updated
manuals are available through our website at
www.lifespankids.com.au.
GENERAL SAFETY INSTRUCTIONS
NOTE: This product is intended for outdoor domestic use only.
1.1 DANGER FOR CHILDREN
WARNING: No eating while using the product at the same time.
- Children do not recognize potential dangers from this product. The unassembled product must be stored out of reach of children and pets.
- This product may only be used with adult supervision at all times.
- The packaging material is not suitable for children due to choking and suffocation hazards.
1.2 RISK OF INJURIES
- Do not use the product if it is damaged or defective. If it is damaged or defective, please contact a qualified technician.
- Check the product before each use. Defective parts must be changed immediately as they can impair the function and the safety of the product.
- No more than 2 children to use the product at the same time.
- Use the product only on even and non-slipping surfaces. Never use it near water and keep sufficient space around for safety.
- Beware of moving parts such as the springs or elastics, which could catch your arms and legs. Do not place any objects or body parts in the product’s openings.
1.3 PRODUCT DAMAGE
- Do not make alterations to the product. Only use original spare parts. Qualified technicians should only carry out repairs – improper repairs can lead to danger for the user. Use this product only as described in this manual.
1.4 ASSEMBLY ADVICE
- Toy must be assembled by an adult before use exactly in accordance with the instructions.
- Children must not use this product until properly installed.
- Check all parts are present before you start to assemble the product. Place small parts on a tray or similar to ensure they are not lost. The manufacturing process can very occasionally result in sharp edges/waste material so please take care when assembling this product.
- If any parts are missing do not use the product until the replacement parts are fitted.
- Ensure your product is sited on level ground. Failure to do this may put additional stress on connections and joints and in time could cause them to fail.
- Ensure your product is located on a soft impact surface like grass. Never locate your product on hard surfaces like concrete.
- Avoid locating this product in full sun.
- Remove all packaging before giving to your children.
- Equipment should be checked by an adult at the beginning of each season and at regular intervals during the usage season to ensure it is safe. Pay special attention to all connections and fastenings.
- Parts may need to be replaced if they show signs of wear and tear. Replace any defective parts in accordance with these instructions.
- Due to the natural characteristics of timber, it is vital to check your product regularly for splintering, lifting of surface layers of wood or exposure of rough wood. Affected areas must be rubbed down using coarse sandpaper to restore a smooth, safe surface.
- Any changes to this toy eg changing or adding an accessory, must be done in accordance with our instructions. Failure to do this will render your guarantee null and void and may make your product unsafe.
- Ensure children’s clothing is appropriate for the play activity.
- Never place toys near a fire.
- In high winds, ensure outdoor toys are moved to a sheltered position and/or securely staked down.
- The age recommendation for this product is clearly stated on the packaging and in these instructions. Please adhere to it at all times. Adult supervision is required at all times to ensure children play safely.
- When you dispose of this equipment please do so responsibly.
SAFETY INSTRUCTIONS
-
The safety instructions of the product should always be considered and obeyed.
-
Using the product may result in permanent injury such as paralysis, or even death. Falling off the product may lead to injuries, particularly to the back, neck or head.
-
No clothes with hooks or lose parts should be worn or carried during product usage in order to avoid hooks getting caught and causing injury.
-
Strong winds can result in the product being blown away or damaged. If strong winds are predicted the product must be disassembled and moved to a sheltered area or sufficiently anchored down.
-
Moving the product whilst assembled may affect the integrity of the frame. Should it be necessary to move the product, please consider the following:
1. Force to be evenly spaced around the frame to lift the product off the ground
2. The product must be carried horizontally
3. Use caution whilst moving as it could bend the product frame. -
Users should be familiar with the assembly manual. This manual contains assembly guidance; selected precautionary measures as well as recommendations for servicing and maintenance of the product, in order to ensure a secured and fun use of the product.
-
It is the responsibility of the owner or the supervisor to guarantee that all users of the product are informed sufficiently of all warning references and safety instructions.
For the supervisor
The supervisor’s role is to make sure users are aware of all safety
precautions and that these precautions are enforced. When a supervisor is not
available, the product may be disassembled or covered to limit access.
- The product can be only used if it is in good condition, worn or damaged parts should be replaced.
- Objects, which could be dangerous to the user, should be away from the product.
- Avoid unauthorized and unsupervised use of the product.
- Do not use the product under influence of alcohol or drugs (incl. medicines).
- Do not use the product as a jumping platform for other articles.
Consumer Information Sheet for Playground Surfacing Materials
The US Consumer Product Safety Commission (CPSC) estimates that about 100 000
playground equipment-related injuries resulting from falls to the ground
surface are treated annually in US hospital emergency rooms. Injuries
involving this hazard pattern tend to be among the most serious of all
playground injuries, and have the potential to be fatal, particularly when the
injury is to the head. The surface under and around playground equipment can
be a major factor in determining the injury-causing potential of a fall. It
is self-evident that a fall on to a shock-absorbing surface is less likely to
cause a serious injury than a fall onto a hard surface. Playground equipment
should never be placed on hard surfaces, such as concrete or asphalt, and
while grass may appear to be acceptable, it may quickly turn to hard-packed
earth in areas of high traffic. Shredded bark mulch, wood chips, tine sand or
the gravel are considered to be acceptable shock absorbing surfaces when
installed and maintained at a sufficient depth under and around playground
equipment.
Table B.1 Lists the maximum height from which a child would not be expected to
sustain a lifethreatening head injury in a fall on to four different loose-
fill surfacing materials if they are Installed and maintained at depths of 150
mm, 225 mm and 300 mm.
Table B.1 Fall height in millimetres from which a life-threatening head injury would not be expected.
| Type of Material | Depth of surfacing material |
|---|---|
| 150mm | 225mm |
| Double Shredded Bark Mulch | 1800 |
| Wood Chips | 1800 |
| Fine Sand | 1500 |
| Fine Gravel | 1800 |
However, it should be recognised that all injuries due to falls cannot be
prevented, no matter what surfacing material is used.
It is recommended that a shock absorbing material extend a minimum of 1 800 mm
in all directions from the perimeter of stationary equipment such as climbing
frames and slides. However, because children may deliberately jump from a
moving swing, the shock absorbing material should extend in the front and
rear of a swing a minimum distance of twice the height of the pivot point
measured from a point directly beneath the pivot on the supporting structure.
This information is intended to assist in comparing the relative shock-
absorbing properties of various materials. No particular material is
recommended over another. However, each material is only effective when
properly maintained. Materials should be checked periodically and replenished
to maintain correct depth as determined necessary for the equipment in
question. The choice of a material depends on the type and height of the
playground equipment, the availability of the material in a particular area,
and its cost.
ASSEMBLY INSTRUCTIONS
3.1 SET UP
MAINTENANCE
WARNING: Please keep for future reference.
We recommend regular maintenance to be conducted at the beginning of each season as well as at regular intervals during the usage session for your play equipment to ensure all main parts/fixings are tightly secured, well-oiled and intact to avoid failure, injury or hazards.
GENERAL ADVICE
It is of particular importance that this is followed at the beginning of each
season as well as at regular intervals during the usage season.
-
Check the accessories monthly as well as the play equipment’s structure to prevent falling risks.
-
Check and retighten screws, bolts, and all other hardware elements as necessary.
a. Do not over tighten to avoid damaging the thread or cracking the surrounding wood. -
Check all coverings and bolts for sharp edges and replace when required.
-
Lubricate all moving metallic parts.
-
When signs of oxidation and / or rust appear on various metallic parts of your equipment, sand rusted areas and tubular members and repaint using a non-lead-based paint when required.
-
Where applicable: check swing seats, chains, ropes, and other means of attachment for evidence of deterioration.
-
Replace when required in accordance with the owner’s manual.
If your play structure is disassembled, be sure to clearly mark any attached
metal plates to prevent accidents. Check all bolt covers and sharp edges and
replace them if necessary.
For longer accessory life, we suggest storing them during the winter.
WOOD ADVICE
Our products are manufactured from premium timber. Great care is taking in selecting, machining, and treating the timber before it is sold to you.
- Inspect wood parts monthly. The grain of the wood sometimes will lift in dry periods causing splinters to appear. Light sanding may be necessary to maintain a safe environment. Treating your Product with protection (sealant) after sanding will help prevent severe checking/splitting and other weather damage.
- The wood is treated via high temperature drying, degreasing and is stained against wood rot and insect damage (Termites not included). This is not a permanent treatment as weather conditions can wear it down. We recommend once or twice a year, depending on your climate conditions, you must apply some type of protection (sealant) to the wood of your unit. Prior to the application of sealant, lightly sand any “rough” spots on your set. Please note this is a requirement of your warranty.
Bear in mind that timber is a natural product and may experience changes throughout the course of its life. It may:
- Develop openings/checks (gaps, slits, apertures, cracks) along the line of the grain.
- Fade as the timber reacts with sunlight.
All woods are hygroscopic, that is, it will absorb or discharge moisture to
attain equilibrium with the surrounding atmosphere. Timber openings/checks
occur due to the moisture content between internal and outer surfaces of the
timber. No two pieces of wood are exactly alike. Each piece has its own
characteristics and personality and reacts differently to climate changes.
When any wood products are exposed to the elements, it develops ‘wood checks’.
A check is the radial separation of the wood fibres running with the grain of
the wood. These are caused by the varying temperature and moisture conditions.
A check does not affect the strength or durability of the wood or structural
integrity of the play set.
WHEN SHOULD WOOD CRACKS BE A CONCERN?
Most of the wood splits will never become large enough to affect the
reliability and strength of our products, however, there can be rare cases
where splits can occur. This happens when a crack develops past the halfway
point from the timber, splitting it into two separate pieces.
Feel free to contact us with detailed pictures of your product so we can
assess and ensure that your playground remains safe.
3. Mould and Mildew
Protecting against mould and mildew on your outdoor equipment is an important
step in maintaining your backyard. Mould may develop for several reasons, such
as certain weather conditions, improper drainage or infrequent usage. Here
we’ll share our tips for keeping your outdoor areas free of mould and mildew
so that you can enjoy your backyard with peace of mind.
Once you spot mould on your equipment, it’s important to start clearing it up
straight away. The first step is to scrub it off with soap and water, until
all the visible signs of mould are removed. It’s important to remember
however, that just because you can’t see it anymore doesn’t mean it’s gone.
The next step is to kill off the remaining mould so that it doesn’t grow back.
Here are a few options, but keep in mind these should be used independently.
Don’t mix or combine these methods at the same time.
Mould Killer or Removal Spray
You can purchase off-the-shelf removal sprays that destroy mould either
indoors or outdoors. For these products, make sure to follow the product
instructions as well as wearing protective gloves to avoid contact with skin.
Bleach
A solution of bleach and water can also be highly effective in killing mould.
For this method, mix the water and bleach on a 1 to 1 ratio, then use a sponge
or brush to scrub the affected area. You can also use a higher concentration
of bleach for spot treating. After bleach treatment, make sure to rinse off
your equipment and allow to dry.
Vinegar
If mould is still lingers after applying bleach or a mould spray, vinegar will
be an effective option for removing stubborn remnants. Vinegar will kill most
types of mould and is best for nonporous materials like hard plastics or
metal. The best method is to fill a spray-bottle with undiluted white vinegar
of at least 5% acetic aced. Spray the affected area, then let sit for around
an hour. Make sure to thoroughly rinse off afterwards.
For wooden equipment, you can add a coat of paint or stain after it has thoroughly dried.
Some people may find that mould keeps resurfacing after cleaning on certain areas. This can be due to a few reasons, such as poor sunlight. Areas without direct sun are more likely to become damp and take longer to dry off after rain. Consider removing obstacles or rearranging your equipment so that it receives more sunlight, which will also help to kill the mould once it develops.
CLEANING
Do not use any abrasive cleansers for the cleaning. Use a soft, damp cloth to eliminate dirt and dust.
WARRANTY
AUSTRALIAN CONSUMER LAW
All of our products come with a guarantee or warranty from the manufacturer.
In addition, they come with guarantees that cannot be excluded under the
Australian Consumer Law. You are entitled to a replacement or refund for a
major failure and compensation for any other reasonably foreseeable loss or
damage.
You are entitled to have the goods repaired or replaced if the goods fail to
be of acceptable quality and the failure does not amount to a major failure.
Full details of your consumer rights may be found at
www.consumerlaw.gov.au.
SUPPORT
Please send all warranty and support inquiries through our ticketing system
via the website: www.lifespankids.com.au/warranty-
form
Our goods come with guarantees that cannot be excluded under the ACL. You are
entitled to a replacement or refund for a major failure and for compensation
for any other reasonably foreseeable loss or damage. You are also entitled to
have the goods repaired or replaced if goods fail to be of acceptable quality
and the failure does not amount to a major failure.
Head Office and Customer Service:
Global Fitness and Leisure Pty Ltd
23-25 Maygar Blvd
Broadmeadows, VIC 3047
Australia
PH: 1300 169 600
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>