Rilextec YX-TW-White Towel Blanket Child Lock Warmer User Manual

User Manual

YX-TW-White

Towel Blanket Child Lock Warmer

Instruction

Thanks for your favor in Rilextec towel and blanket warmer with child lock and timer settings. With normal care and proper treatment, it will provide years of reliable service.
To avoid body injury or property loss caused by misoperation, please read all instructions carefully before using this product.
Please retain this manual for future reference.

FEATURES

1. The generous cavity has the capacity to hold two large bath towels or one personal throw blanket.
2. Unique Child lock design for safety concerns Please warn children not to touch the hot inner wall of tower warmer.
3. Three timer settings: 20/40/60 minutes.
4. Hot surface indicator light to warn you ‘Do not touch’.

CONTENTS

Please unpack carefully and check if the product is correct or damaged referring to the picture.

1. Child Lock
2. Timer Indicator
3. ON/OFF Button
4. Hot Surface Indicator
5. Handle Lid with Child Lock
6. Power Cord

TECHNICAL DATA

Measurements:       19″(h) x 13″(w)x 13″(d)
Weight:                     10.7LBS
Voltage:                    AC 120V 60Hz
Nominal Power:      max.450Watt
Setting Timers:        20/40/60 minutes

Setup and Operation

Read Before Use

1. Push the child lock and open the lid and remove any packaging contents.

2. Put the device on a dry and at floor.

3. Plug into 120V electrical outlet
   NOTE: This device has a 3-prong grounded plug. To reduce the risk of electric shock, plug the power cord into a grounded electrical outlet.

4. Open the lid and place ONLY DRY towels or a blanket inside.
   NOTE: Placing damp towels inside the device may damage it and cause serious safety risks.

5. Close the lid.

6. Extended Press 2-3s the ON/OFF power button, the LED ring will turn red to indicate the device is warming up. Short press power button to select preferred timer settings (20/40/ 60 minutes).

7. When the temperature of the INTERIOR SURFACE exceeds 122°F, the hot surface indicator will light up. When it shows red, it indicates the INTERIOR SURFACE of the device is unsafe to touch.

8. 60 seconds rapid heating up, 6 minutes to reach high temperature.
   NOTE: The towel warmer can reach approx.266°F(130°C) and remain hot for the duration of the heating cycle.

9. Push the child lock and open the lid to remove the towels or blanket.
   NOTE: To avoid damage to the product, gently raise the lid when removing items.

10. Extended Press ON/OFF button at anytime to stop or start the heating cycle.

11. After the heating cycle is complete, the interior surface of the device will remain dangerous to touch until the HOT SURFACE light turns off.

• This device will switch off automatically after 20/40/60 minutes timer run out.
• Do not setup or use the device in a bathroom or similary wet / damp areas.

Plug into 120V electrical outlet

Press and hold the power button for 2-3s to boot, The highest temperature reaches 266°F

Tips for Best Results

• Before plug ,please check and make sure the power cord is undamaged.
• Do not use the wet hand to plug in the adapter.
• Please don’t stand or seat on the product.
• When moving the product, please don’t pull the power cord or drag the product directly to avoid any damaged caused.
• Please don’t let children and pets play the products for preventing any accident happened.
• Do not use the wet hand to pull out the power cord in order to avoid any electric shock.
• Do not use this product in damp environment to avoid electric shock.

Do not plug or unplug with wet hands

1. Use cotton or cotton blend towels or fabrics, not for clothes made of silk.
2. For fast and even heating, loosely pile one towel into the Towel & Blanket Warmer. Tightly rolled or folded towels will take longer to heat thoroughly. Two towels will take longer to heat than one
3. Use only with DRY fabrics. NOTE: Do NOT use with damp or wet articles.
4. Avoid using delicate fabrics that cannot withstand high heat. Any fabric indicating that a cool iron must be used may not be able to withstand the heat of the Towel & Blanket Warmer, resulting in damage to the fabric and the product.
5. Once the heating cycle has begun, keep the lid closed. This will prevent heat from escaping, Opening the lid mid-cycle may result in slower heating times.
   NOTE: Condensation on the lid and interior of the product is normal.

Please put dry towels/bath towels, not wet towels

Do not heat silk clothes or fabrics

Safety Instructions

Please read the following instructions carefully before putting your device into use. Please retain these instructions for further reference!

WARNING
To reduce risk of fire, electric shock or serious injury to persoms when using the appliance, adhere to the following basic precautions:

• Always unplug the product from the electrical outlet immediately after use. Do not use the device for anything other than its intended use.
• Do not place or store the device where it can fall or be pulled into a tub or sink.
• Do not place or drop into water or other liquid.
• Do not reach for the product after it has fallen into water. Unplug it immediately.
• Care should be taken so that objects do not fall into and/or liquids are not spilled onto the device.
• The device should never be left unattended when plugged in.
• Close supervision is necessary when this device is used near children or disabled persons.
• Only use the device for its intended use as described in this manual.
• Never operate the device if it has a damaged cord or plug, if it is not working properly or if it has been dropped, damaged or immersed in water.
• Keep the cord away from heated surfaces. Do not wrap the cord around the exterior of the device or let the cord hang over a table or counter edge.
• Do not use outdoors.
• Do not alter the safety plug or use an extension cord with this device.
• Do not operate with a voltage converter.
• Do not touch hot surfaces.
• Do not use accessory attachments not recommended by the manufacturer, as this may cause injuries.
• Do not use this product for medical treatment.

FCC INFORMATION

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This product may cause harmful interference
2. This product must accept any interference received, including interference that may cause undesired operation.

WARNING: Changes or modifications to this product not expressly approved by the party responsible for compliance could void the user’s authority to operate the product. Note: This product has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This product generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this product does cause harmful interference to radio or television reception, which can be determined by turning the product o ffand on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the distance between the product and receiver.
• Connect the product to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for assistance.

Care and Maintenance

1. Before cleaning, make sure the power supply is turned off and the plug has been pulled out from the socket.
2. Use a soft dry cloth to wipe the product when it the device is cool to touch.
3. Do not pull the power plug by damp hands.
4. Do not use water washing product ,do not spray the water or other liquids to the interior of the device.

Maintenance

Make sure the power supply is turned off and the plug has been pulled out from the socket.
Sweep off the dust . Keep the device clean and away from damp places.
Store the device in a cool, dry place out of reach of children.
Avoid contact with sharp edges or pointed objects which might cut or puncture the cover of the device.

Warranty

If you have any issue about the product, please do not hesitate to send an email to support@rilextec.com , our customer support will strive to provide the best service possible within 24 hours.

30-Day Money Back Guarantee for any reason
Rilextec product can be returned to receive a full refund for any reason within 30days. Please contact our customers service (support@rilextec.com), our staff will contact you within 48 hours.

90-Day Money Back Guarantee for quality related issue
Rilextec product can be returned / replaced within 90 days if the product break down in the period of proper use.

24-Month Warranty for quality related issue
If the product break down within 24 months in the period of proper use, customers can enjoy the relevant warranty to get them replaced.

Attention!
No warranty will be given to any force majeure and man-made causes to a defective product, such as improper care, personal tear down and willful damage, etc.

WARRANTY REGISTRATION TIP!

1) Find our Facebook page and like it: www.facebook.com/rilextec.
Enter “Warranty” to messenger to active your 1-year FREE warranty.
OR
2) Send message/email “Warranty” to support@rilextec.com to activate your 1-year FREE warranty.
Join as a member, you can get extra special Rilextec gift and discount for repeated orders. Unique coupon for new product models.
Email: support@rilextec.com
Facebook Messenger: m.me/rilextec

Contact for Customer Support Only

RILEXTEC INNOVATION CO., LTD.

support@rilextec.com
www.rilextec.com
www.facebook.com/rilextec

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>