Bubbles WC-FRAME002 Scudo WC Frame Toilet Cistern Installation Guide

Bubbles WC-FRAME002 Scudo WC Frame Toilet Cistern

PARTS LIST

Attention! Before using, turn on the water and clean the silt and mud in the cistern if any.

DIMENSION

INSTALLATION

1. Assemble the fixation frame to the tank in the correct position, As in Picture 1
   • Assemble: Push down the fixation frame, and keep the hole withhold the button up.
   • Disassemble: Press the raised round button, and push the fixation fame up.
2. Screw the angle metal parts, bolts(each 2pcs), hex nut and washer(each 2pcs) to the metal frame and fix tightly.
3. Loosen the 2 screws on the metal frame feet counter-clockwise by wrench, and adjust the metal frame height needed, then tighten the 2 screws. As pictures 1 and 2
4. Position the 90-degree soil elbow into the securing clip and lock the clip into the closed position indicated by a loud “click”.
5. Check the rear of your chosen toilet pan and measure the distance between the bolt holes for the securing bolts. Insert the 2 bolts (part number 4) into the correct bolt holes within the wall frame structure ready for attaching the toilet pan.
6. Position the frame within the cabinet and mark up the appropriate fixing points ready for drilling and screwing.
7. Using appropriately sized drill bits & screws, secure the cabinet in your chosen location.
8. Secure the frame kit into the cabinet using supplied securing bolts & fixings.
9. Prepare the soil pipe by cutting it to the correct length and insert it into the frame kit ready for the installation of the toilet pan.
10. After assembling and finishing the decoration, take out the protection cover
11. Cut off the extra raised parts by the blade.
12. Loosen the angle valve, and connect the inlet pipe to the angle valve.Anale valve diameter: G1/2
13. Connect the vacuum pipes to the appropriate fixings marked right & left. Lift the spring clip to secure the flush plate into the frame.
14. Secure the assembly using the bolts provided.
15. Once the toilet is installed and the front panel secured, fit the flush panel control.
16. Disassembly: As per illustration, push the button plate upward and then pull it out as per illustration 2.
17. Prepare the frame kit ready to accept the toilet pan.
18. Insert both the soil & flush pipes into the joints.
19. Measure the pipe lengths required and mark accordingly.
20. Fit the pipes to the toilet pan.
21. Mark pipes according to size.
22. Check both pipes to ensure they are the correct length.
23. Cut pipes to length.
24. Using a file, chamfer the end of the pipes to enable ease of installation into the sockets.
25. Lubricate the pipes before inserting them into the sockets.
26. As per the illustration, measure the size of d. Hang the toilet to the 2 screw bolts which need to be 25mm longer than the size of d.
27. As per the illustration, insert the straight inlet pipe with rubber sealing into the inlet hole of the toilet. As per illustration 2, insert the horizontal drainpipe into the vertical drainpipe in the wall.

  *  **Attention!** Make sure to insert and install in place.
11. Secure the toilet pan onto the studs and connect the waste pipes.
12. Check for level and tighten bolts.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>