IKEA Omlopp LED Cabinet Lighting Instructions
- June 7, 2024
- Ikea
Table of Contents
IKEA Omlopp LED Cabinet Lighting Instructions
IMPORTANT SAFETY INSTRUCTIONS
For indoor use only. Regularly check the cord, the transformer and all other
parts for damage. If any part is damaged the product should not be used.
Important information! Keep these instructions for future use
CAUTION!
The light source of this product is nonchangeable light diodes (LED).
Do not disassemble the product, as the light diodes can cause damage to the
eyes.
Do not immerse in water. Cleaning Use a damp cloth, never a strong cleaning
agent.
CAUTION
To reduce the risk of fire, electric shock, or injury to persons: Use only
insulated staples or plastic ties to secure cords. Route and secure cords so
that they will not be pinched or
damaged when the cabinet is pushed to the wall. Position the portable cabinet
light with respect to the cabinet so the lamp replacement markings can be read
during relamping. Not intended for recessed installation in ceilings, or
soffits. The low-voltage portable cabinet light may be installed inside or
under a kitchen cabinet or other built-in furniture when:
- The low-voltage Class 2 power supply is located outside the cabinet and is not concealed; and
- The line voltage power supply cord is not concealed or run through openings in the cabinet, walls, ceilings, or floors. This requirement does not apply to the wiring between the
cabinet light and the power unit. The National Electric Code (NEC) does not permit cords to be concealed where damage to insulation may go unnoticed. To prevent fire danger, do not run cord behind walls, ceilings, soffits, or cabinets where it may be inaccessible for examination. Cords should be visually examined periodically and immediately replaced when any damage is noted.
ATTENTION: CAUTION:
Injury to persons and damage to the lamp and/or the mounting surface may result if the lamp is pulled from the surface. To reduce the likelihood of such injury or damage, mount only on a surface that is mechanically sound.
WARNING
Deviation from the assembly instructions may result in a risk of fire or
electric shock.
This device complies with part 15 of the FCC Rules. Operation is subjected to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
WARNING
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment
.
ANSLUTA power supply cord and
ANSLUTA electronic transformer are sold separately.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>