hansgrohe 15736XX0 ShowerSelect Trim Set Instruction Manual
- June 17, 2024
- hansgrohe
Table of Contents
Instructions for use
Assembly instructions ShowerSelect
15736XX0 / 15736XX7
ShowerSelect S
15745XX0 / 15745003 / 15745007
ShowerSelect
15764XX0 / 15764003 / 15764XX7
Safety Notes
Gloves should be worn during installation to prevent crushing and cutting
injuries.
The product may only be used for bathing, hygienic and body cleaning
purposes.
Children as well as adults with physical, mental and/ or sensoric
impairments must not use this product without proper supervision. Persons
under the influence of alcohol or drugs are prohibited from using this
product.
The hot and cold supplies must be of equal pressures.
Installation Instructions
- Prior to installation, inspect the product for transport damages. After it has been installed, no transport or surface damage will be honoured.
- The pipes and the fixture must be installed, flushed and tested as per the applicable standards.
- The plumbing codes applicable in the respective countries must be observed.
- It is not permitted to install a shutoff device (fe. single-lever mixer) upstream of the built-in valve for 3 consumers!
- If the thermostat or mixer is set to maximum water temperature, there is a risk of scalding at hydraulical opening of the check valve. For this reason, Hansgro- he recommends that you set up the “Safety Function”.
Special information for UK
If installing this product with a pump, please be aware that it has to have
negative head switching. This product will not function with a positive head
pump.
Technical Data
Operating pressure: max. 1 MPa
Recommended operating pressure: 0,1 -0,5 MPa
Test pressure: 1,6 MPa (1 MPa = 10 bar = 147 PSI)
Hot water temperature: max. 60°C
Thermal disinfection: 70°C / 4 min
The product is exclusively designed for drinking water!
Symbol description
| Do not use silicone containing acetic acid!
---|---
| Dimensions (see page 42)
| Flow diagram (see page 43)
| Spare parts (see page 44)
| Special accessories (see page 45) order as an extra
| Cleaning (see page 46)
| Operation (see page 41)
| Test certificate (see page 46)
Fault| Cause| Remedy
---|---|---
Valve stiff| – Select stop valve DN9 damaged| – Exchange Select stop valve DN9
Shower or spout dripping| – Select stop valve DN9 damaged| – Exchange Select
stop valve DN9
Pushbutton cannot be actuated or is without function| – Safety guard of
isolating valve has not been removed| – Remove safety guard from isolating
valve
Pushbutton is jammed or stiff| – Seal needs greasing| – Grease the seal
Pushbutton does not snap in| – Select Adapter incorrectly trimmed| – Trim and
mount Select Adapter according to Fig. 7 (see page 36 + 39)
– First, fully press the pushbutton down into the rosette; then, mount the
rosette
| 
---|---
| 
| 
| 
| 
www.hansgrohe.com/cleaning-recommendation
http://www.hansgrohe.com/cleaning-recommendation
Cleaning recommendation / Warranty / Contact
Hansgrohe · Auestraße 5 – 9 · D-77761 Schiltach
Telefon +49 (0) 78 36/51-1282
Telefax +49 (0) 7836/511440
E-Mail: info@hansgrohe.com
Internet: www.hansgrohe.com
04/2023
9.02240.07 R02
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>