VISUAL COMFORT RL5672 Paxton 40 Ring Chandelier Instruction Manual

: June 17, 2024
: VISUAL COMFORT

Table of Contents

ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED (NOT INCLUDED):
Read User Manual Online (PDF format)
Download This Manual (PDF format)

RALPH LAUREN
Paxton 40” Ring Chandelier
Item # RL 5672

ASSEMBLY INSTRUCTIONS

VISUAL COMFORT RL5672 Paxton 40 Ring Chandelier - ASSEMBLY
1

NOTICE:
This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install.
Retain all packaging material until installation is complete and approved.

TOOLS REQUIRED (NOT INCLUDED):

Phillips Screwdriver
Slotted Screwdriver
Wire Cutters
Wire Strippers
Measuring Tape

Carefully remove all parts from the box. Place on a clean, soft surface.
Remove mounting plate (B) from canopy (J) by removing screws (I).
Install mounting plate (B) to the junction box and secure with mounting screws (E).
Connect supply ground wire (usually green or bare copper) around the green grounding screw (see diagram 1). Tighten.
NOTE: It is imperative that the fixture is grounded.
Gently set fixture on a flat, non-abrasive surface to adjust fixture hanging wires.
To adjust each hanging wire loosen screws (H) on either side of the cable lock nut (G) and adjust to desired length. Once complete re-secure screws (H) and repeat steps with the remaining wires. (See diagram 2)
After fixture height is achieved shorten the wires by using a pair of cutters (not included), leaving 8” of wire length to connect to the driver (D).
NOTE: Final leveling in later step will only allow for small adjustments. Make sure fixture height and fixture level are accurate before cutting wires.
Remove outer housing of wire by making a neat cut all the way around, about 1” from the end. Once cut is made, remove and discard the 1” piece of housing, exposing the electrical wires.
NOTE: Make sure not to cut too deep into housing or electrical wires could become damaged.
Separate wires and strip insulation on each 5/8″.
Install heat sink plate (M) to canopy (J) and secure with screws (L), then install driver (D) to heat sink plate (M) and secure with other heat sink plate (K) using screws (E).
Connect fixture neutral wire (black) to driver (D) output wire (black) using wire nut (A).
Connect fixture hot wire (red) to driver (D) output wire (red) using wire nut (A).
CAUTION: Do not reverse the hot and neutral connections.
Run safety cable through hole on back of mounting plate (B). Loosen cable lock and install to end of safety cable. Insert other end of cable through the cable lock and tighten ends with a screwdriver to secure. (see diagram 3)
Connect driver (D) input neutral wire (white) to the supply neutral wire (usually white) using wire nut (A).
Connect driver (D) input hot wire (black) to the supply hot wire (usually black) using wire nut (A).
CAUTION: Do not reverse the hot and neutral connections.
Make sure all wire connections are tight, then carefully tuck into the junction box.
Install canopy (J) to mounting plate (B) and secure with screws (I).
To level fixture, unscrew cap nut (O), feed fixture wire through stopper (N) and then re-secure cap nut (O). Repeat as needed with other wires. (See diagram 2)