TAC 214400 90 Degree Bent End Sidebars Instruction Manual
- June 17, 2024
- TAC
Table of Contents
TAC 214400 90 Degree Bent End Sidebars
PARTS LIST:
1 | Driver/left Sidebar | 4 | 1/2″ x 2” Hex Bolts |
---|---|---|---|
1 | Passenger/right Sidebar | 4 | 1/2” x 1-1/4” OD x 3/32” Flat Washers |
2 | Driver side front-passenger side rear Sidebar Brackets | 4 | 1/2” Lock |
Washers
2| Passenger side front-driver side rear Sidebar Brackets| 12| 8mm x 24mm OD x
2mm Washers
12| 8mm Plastic Washers| 12| 8-1.25mm Nylon Lock Nuts
Installation Instructions
PROCEDURE:
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION. ASSISTANCE IS RECOMMENDED.
-
Start the installation under the passenger side of the vehicle. Locate the front and rear factory running board mounting locations along the inner side of the body, (Figure 1).
-
Slide (1) Plastic Washer over each factory mounting stud in the body panel, (Figures 2 & 3).
IMPORTANT : The Plastic Washers are designed to prevent corrosion between the aluminum body panel and the steel mounting brackets. Do not install the Brackets without the Plastic Washers. -
Select (1) passenger side front Mounting Bracket. NOTE: Same bracket is used for the driver side rear installation. Attach the Mounting Bracket to the (3) factory studs with (3) 8mm Flat Washers and (3) 8mm Nylon Lock Nuts, (Figure 5). Snug but do not fully tighten the hardware.
-
Repeat Steps 1—3 to install the passenger side rear Bracket, (Figure 4).
-
Select the passenger/right Sidebar. With assistance, position the Sidebar up to the (2) Mounting Brackets. Attach the Sidebar to the Mounting Brackets with the included (2) 1/2” x 2” Hex Bolts, (2) 1/2” Lock Washers, and (2) 1/2” Flat Washers, (Figure 5). Snug but do not tighten at this time.
-
Level and adjust the Sidebar and tighten all hardware.
-
Repeat Steps 1—6 to install the driver/left Sidebar.
-
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing
is recommended to add a protective layer over the finish. Do not use any type
of polish or wax that may contain abrasives that could damage the finish. For
stainless steel: Aluminum polish may be used to polish small scratches and
scuffs on the finish. Mild soap may be used also to clean the Sidebar.
For gloss black finishes: Mild soap may be used to clean the Sidebar.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>