ARTOLF FZ-200 Hand Held IPL Device User Manual

ARTOLF FZ-200 Hand-Held IPL Device

Product Information

Specifications

• Product Name: Hand-held IPL Device
• Product Type: Hair Removal Instrument (Epilator)
• Technology: Intelligent Pulsed Light Irradiation
• Applications: Hair Removal, Beauty, Health
• Dimensions: 20.2cm (length) x 6.3cm (width) x 11.3cm (height)

Product Usage Instructions

1. Safety Precautions

Please read and understand the following safety precautions before using the Hand-held IPL Device:

• Do not use the device on or near the eyes.
• Avoid using the device on sensitive areas, such as nipples or genitals.
• Ensure that your skin is clean, dry, and free from any lotions or creams before using the device.
• Keep the device away from water and other liquids.
• Do not use the device if you have open wounds, infections, or skin conditions.
• Consult a healthcare professional if you have any medical conditions or are taking medications that may affect your skin.

2. Function Switching

The Hand-held IPL Device has three functions that can be switched using the function switch button. Press the function switch button to cycle through the available functions.

3. Flash Emission

To emit a flash of pulsed light, follow these steps:

1. Connect the device to a power source using the power interface.
2. Ensure the device is charged and ready for use.
3. Press the flash emission button to activate the device.
4. Place the flash outlet against the area of skin from where you want to remove hair.
5. Press the flash emission button again to emit a flash of pulsed light.
6. Move the device to the next area and repeat the process.

4. Recommended Usage

The recommended usage of the Hand-held IPL Device is as follows:

• First Month: Use 2-3 times per week
• Second Month: Use 1-2 times per week
• Third Month: Use 2 times per month

Frequently Asked Questions

Q: Can I use the Hand-held IPL Device on my face?

A: No, it is not recommended to use the device on the face. The device should be used on body areas only.

Q: How long does each flash emission take?

A: Each flash emission takes a fraction of a second, allowing for quick and efficient hair removal.

Q: Can I use the device while it is charging?

A: No, the device should not be used while it is charging. It is important to disconnect the device from the power source before using it.

Product Introduction

Hair Removal Instrument (hereinafter referred to as (“epilator”) is an innovative beauty product, which can effectively and safely remove unwanted body hair. It adopts intelligent pulsed light irradiation technology and integrates multiple applications of optical technology in the field of beauty and health, boasting one of the most professional and practical products in this field.

Please read the instructions carefully before use

The ultimate goal for when designing epilators is to ensure customer comfort and safety. All products are manufactured under the highest quality standards. Please read and understand all of the operating instructions, safety precautions, and warnings before use.

Applicable Users

Epilator is an over-the-counter device, suitable for both men and women to remove unwanted hair.

Applicable Skin Tones

Never use on dark skin tone. For brown skin tone, please start from the lowest speed mode and adjust the speed setting according to your pain sensation.

Safety Precautions

Contraindications

This product is not intended for use by: Children, elderly, and people with either local or systemic inflammation; people who have photosensitive skin or are taking photosensitive medications; people with pacemakers and other implantable electronic medical devices, or those sustaining life with the help of life-support devices, such as ECMO.

Cautions

1. Pregnant women, children aged less than 11 years, people with moles, tattoos are not permitted to use.
   Not recommended for people who are sunbathing or using sunbeds, sunless tanning products. If you’re not sure whether the skin is tanned or sunburned, please wait a day for recovery before using the product.

2. Do not use the epilator directly towards tattoos, dark brown and black spots, otherwise, it may absorb a lot of light and cause skin discomfort.

3. Never use on areas around the ears, neck, nipples, genitals or anus, because these parts of the skin are Fragile and more vulnerable to injury.

4. Do not keep the epilator in the same area for too long, or emit waves of ight multiple times in one position. This may generate excess heat and cause discomfort to the skin.lf any allergic reactions occur such as redness, swelling after use, and last for more than 24 hours, please stop using it and contact your doctor or consult customer service.

Warnings

1. Due to high voltage circuits inside the product, please do not disassemble it without permission.
2. Please do not cover the vent during use.
3. Keep away from water or moisture.
4. Never use the epilator if the plug or power cord is damaged.
5. Never use the epilator in a flammable and explosive environment.

Safe Operations

1. When flashing out, it is forbidden to point the light at the eyes and other vulnerable parts, and goggles must be worn when using.

2. Before using this product, please remove all metal items such as ring bracelets from your body to avoid equipment malfunction.

3. Please operate it away from children and keep it out of their reach after use.

4. Connect the power adapter, turn on the power, and wear the special protective eyewear provided with the product. The background light of the hair removal meter display is lit and the status is “OFF”.

5. Long press the “On/Off/Stand Size” button for 2 seconds, the hair removal machine will start. Check the current working status by referring to the previous “Display Introduction”.

6. Press the function switch button and enter the hair removal mode when the screen is displayed as HR.

7. The machine is equipped with 1 to 9 gears, short press the “switch/stall size” button to adjust the light wave level For the first time, please start from 1st gear and strengthen the gear according to your own experience. The higher the gear is, the better the effect will be.

8. Light setting. Manual light setting (for hair removal of small area). The defaults are manual, i.e., the light is emitted once by one pressing of the flash button. Slide out light setting (for hair removal of large area. After the hair removal machine is turned on, press and hold the flash button, the hair removal machine will switch to slide-out light mode. All you need to do is hold the head of the lamp vertically against the skin and the hair removal device will automatically shine its light.

9. Attach the lamp head to the part where hair removal is required and use it vertically.

10. When the hair removal device is in manual light mode, wait for the “LCD screen” to flash, press the “flash emit button” to emit a flash, the light head covers the area to complete the hair removal. Move the head of the lamp to the next hair removal area and hold it close to the skin, wait for the “LCD screen” to flash and press the “Flash Emit button” to emit a flash. In successive cycles, 2-3 exposures are recommended for each part.

11. When the hair remover is in sliding light mode, a long press on the “Flash Emit button” emits a flash of light, meaning that the area covered by the lamp head is complete. Move the head of the lamp to the next hair removal area and hold it close to the skin, the hair removal device emits a flash of light. In successive cycles, 2-3 exposures per part are recommended.
    Tip: When in slide out mode, the head is fully pressed against the skin, and can flash
    continuously for 8 seconds while the head is sliding.

12. After the operation is completed, long press “switch on/off” for 2 seconds to turn off the machine; When the hair removal machine is on, it will automatically turn off if there is no action for 5 minutes.

13. Pull the adapter plug, then remove the adapter from the power outlet.

14. After ten minutes, allow the surface of the lamp to cool and wipe the lamp with a non-alcoholic wet wipe or soft paper towel.

15. After cleaning, put the hair removal machine and adapter back into the box and place the hair removal machine in a ventilated dry place out of reach of children.

16. Care for the skin in the light-receiving areas. 20 minutes after the end of hair removal, you can choose products to the hair removal area for hydration and repair. If there is discomfort, apply cold compresses for 30-60 minutes until the skin is free of burnina nain.

Attention

1. Apply aloe vera gel or similar moisturizing cream to the hair removal area after hair removal, do not use harsh cosmetics immediately.
2. Ensure that the treatment area is clean before shedding.lt is recommended to wash the skin with cold boiling water, and not to touch water for 2 hours after operation. Sun bathing, warm water baths, steam baths, etc. are not recommended within 48 hours.
3. Avoid exposing the hair removal area to strong sunlight for 2 hours after hair removal, and apply sunscreen before outdoor activities.
4. Do not swim in a sanitized pool for 48 hours after waxing.
5. Do not press the trigger button continuously, just press once, each part is recommended to irradiate 2-3 times. (The entire head of the lamp fits tightly against the skin area in one place).
6. The machine should not work for more than 25 minutes continuously, if the hair removal area is large, it can be divided into several times (after 10 minutes, turn off the machine and unplug the power, after 10 minutes’ rest, you can continue to use it).

Service cycle

Hair has a certain growth cycle, and short-term use does not complete permanent hair removal. The entire treatment course requires 2-6 months. Only long-term adherence to this product will have an effect.

First month(use 2-3 times per week)

After irradiation, the hair follicles begin to atrophy, and the hair gradually becomes soft and thin.

Second month(use 1-2 times per week)

Continuously irradiated hair has slowed down growth, with significant hair loss. Third month (use 2 times per month) After the hair follicles are irradiated according to the cycle, the hair roots fall off without leaving black spots and the skin is smooth.

Function switching

1. Switch to the LCD interface according to the steps of depilator.
2. Press the function switch button to switch 3 functions.
3. Press the “Flash emitting button” for two seconds to display “AUTO” to enter the automatic flash mode.

Specifications

Adverse reactions and treatment

All cosmetic methods may carry a certain risk, and this product may cause discomfort when used improperly.

Applicable Parts

Introduction of product button functions

Introduction of the display screen

Skin Test

If you are using this product for the first time, please select a small area to be tested for skin according to the following requirements.

1. Refer to the following steps for powering on.
2. Select either gear 1 or 2.
3. Follow the operating instructions and usage precautions for the selected skin area.
4. After 30 minutes of skin testing, check the skin reaction.
5. If the skin on the test site is normal, you can continue to use it, if it is abnormal, please stop using it.
6. operate it away from children and keep it out of their reach after use.

Procedure for use of the hair removal instrument

1. Before use, please shave off the hair in the hair removal area, clean the hair removal area and wipe it clean. Ensure that the hair follicles under the skin are able to absorb the maximum amount of energy to achieve optimal hair removal.

The problems and suggestions are as follows:

troubleshooting

Simple troubleshooting table

Frequently Asked Questions

• Q: Do I have to shave before each use?

  • A: No, shaving is only necessary before the first use. After the first use, you can wait for the hair to grow to about 5 mm. You can shave it again if it affects the using effect.

• Q: Why doesn’t my hair disappear immediately/change after using?

  • A: This is a permanent hair removal device. To permanently remove hair, you need to use it for a course of treatment. At the beginning, the hair growth inhibited and slowed down, with this continuous state, this device can make the hair follicles sleep, thus achieving permanent hair removal.

• Q: Why didn’t I achieve the same effect as the others, or no effect at all?

  • A: People have different physiques, and the difference of hair thickness and treated parts can affect the effecting cycle. The using cycle is an average value, of which the specific time may be slightly different.

• Q: What level is suitable?

  • A: There is no unified standard of the suitable levels, it all depends on how your skin tolerance is (the darker the skin color, the lower the level should be used. And start choosing the suitable level from the lowest one. The higher the level is, the more obvious the treatment effect is and the shorter the treating time is. On the contrary, if you use a low level, the treating time will be extended accordingly. It is recommended to do local skin tests on the treated skin part for 1-3 flashes before each hair removal, and then start treatment on large skin areas after making sure that no skin discomfort occurs on the second day.

• Q: Wil it hurt?

  • A: During the hair removal process, light waves will generate heat when encounter hair melanin, causing slight pain. Due to the different skin and pain tolerance of different individuals, the actual feelings are different. It is recommended to accelerate the level slowly from the lowest one according to your actual situation.

• Q: How to shave? What kinds of hair should be shaved off?

  • A: Generally speaking, you should shave hair on the armpit shaving easier:
  • A. Use shaving cream or mild shower gel to lubricate the shaving area.
    Or, apply a hot towel on the shaving area for a few minutes, and gently shave the hair immediately after removing the towel, which will make shaving easier.

• Q: Why is there a smell of scorched hair after use?

• A: That’s because the hair is not completely shaved. While using, the light waves will generate heat when encounter melanin, which causes the smell of scorched hair. And that is normal.

• Q: I want to remove my hair quickly. Can I use it every day?

  • A: It is not recommended to use this device every day. There is a hair growth period, you can use it according to the normal cycle: Use once every 3-5 days during the first month and gradually decrease the number of using times after the hair growth slows down.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>